Having problems with your Vacuums ?

I have ajenair garbage disposal under the sink and it leaks when running. What's the fix?


Answers :

First inspect that all connections to drain and seal to sink are tight. If it's leaking through the housing itself, it needs to be replaced. Be VERY CAREFUL... you have house current and water in close proximity and can possibly get severe electrical shock. If you're unsure, have a plumber or trusted handyman look at it for you.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have ajenair garbage disposal under the sink and it leaks when running. What's the fix?


First inspect that all connections to drain and seal to sink are tight. If it's leaking through the housing itself, it needs to be replaced. Be VERY CAREFUL... you have house current and water in close proximity and can possibly get severe electrical ... Vacuums

How to fix a garbage disposal - Vacuums


Depends on what is wrong with it.\015\012Two basic problems that can exist -\015\012Circuit breaker can be tripped\015\012Blades can be caught up.\015\012\015\012Unplug unit and re-set breaker on bottom of unit.\015\012Get an appropriate size a ... Vacuums

My sunbeam water cooler model #YLR2-5-67H3 has been sitting unplugged for 3 years. I moved, plugged it in and put a water bottle on top and water went all over the floor. I unplugged it, (read the instructions on the front, duh) and it still leaks on the floor. What should I do? I put it over the sink, emptied it, checked the drain plug, tried running a glass full of tap water through each tap. Only the room temperature one would work.


One of the rubber connecting hoses inside it has dried and aged so the pressure of the water from the bottle made it burst.\012\012\012You will need to open it, find the defective hose and replace it - a 2 hour relatively easy job. The hardest ... Sunbeam Vacuums

Hoover Steamvac F6025-900 leaks clean water when running


First item to check is the valve on the machine where the upper ank sits. If you install the tank and then remove it, you will have a small ammount of water in the black gasket area. this means that this is ok. if not and there is no water you will n ... Hoover F6025-900 SteamVac Wet/Dry Vacuum

Fantom Thunder vacuum whistled and stopped running and won't run now. Can it be fixed?


... Vacuums

The Euro-Pro Shark Steam Vacuum Blaster is leaking would like to fix myself but don't know how to get to it were it leaks


... Euro-Pro Shark Steam Blaster Vacuum

DT 1300 As I am vacuuming the motor seems to fade in and out and sometimes stops running for a few seconds and then resumes. If I move the hose a bit near the vacuum end, it runs smoothly again. Does this sounds as if there might be a short in the motor? Would this be something I can fix myself or does the vacuum need to go in for repairs.


... Oreck DutchTech DTX1300C with Motorized Carpet Brush Bagged Canister Vacuum

Hoover steamvac model f-5883-900. The brushes spin freely when i spin them myself,but dont spin when running. The vac runs but sounds differet like a higher hum. To fix this would the pin be broken or the turbine


... Vacuums

We have a Bissell Proheat 2X (model 8920). The problem we are having is when water/soap is initially released (all settings) it continues to leak out the front water spray nozzles unit the water containers are empty. The vacuum works but can't keep up with the continuous water leaking out. Do you have any idea what is sticking open to allow the continued release of water when the machine is running? Thanks Rick


Return it. It is faulty and should not do that. Mine does not. Does require changing water about evrery 10 minutes but one can see the filth in the water. Also re-clean with plain water over areas that were cleaned to remove all cleaner. Old cleaner ... Bissell 8920 ProHeat 2XTM Upright Vacuum

My Dyson DC07 vacuum started to run slower after being on for a little while and then would run normally again. I have switched on today and it has just stopped. When I push the start button, on occasions it almost starts and then doesn't. I am wondering if there is a problem with the switch and if so how can it be fixed? Thankyou.


The motor running slower was the motor starting to burn out. The "almost start" is the brushes making intermittent contact with the armature in the motor. \015\012\015\012Your machine needs a new motor Pam. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Brushes won't fix back into holder without being forced, so Roomba clicks when it runs. It will only run a little while and then stop and say to clean Roomba's brushes.


It sounds like you didn't clean the bearings. On one end of each brush is a bearing, probably in a yellow housing. Pull the bearing off the axle, and you'll find it's full of hair underneath.Obviously, the brushes should turn freely and s ... Roomba Vacuums

How to fix a leak in the dirt devil SE 3800 carpet cleaner? The clean water storage tank leaks.


... Dirt Devil Easy Steamer Upright Wet/Dry Vacuum

Hoover steamvac model f-5883-900. The brushes spin freely when i spin them myself,but dont spin when running. The vac runs but sounds differet like a higher hum. To fix this would the pin be broken or the turbine


... Vacuums

Hoover steam vac leak from the bottom when tank has water in it when not running but tank is not leaking


The tank is not sealing to the black rubber ring seal on the lower handle. make sure this seal is not displaced. ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Hello there, I have Bissell Vaccum Model 6579 3...and it's not picking up the garbage..it works but nothing in going in the garbage container. Can you tell me how i can fix it.


I have the same problem!!!! ... Bissell Vacuums

Power nozzle on E-series won't start when cold unless the red 'reset' button is pressed multiple times while also holding the trigger to 'warm it up'...this is w/the power nozzle off the floor - no restriction on it turning. Once it's been running and then turned off the button must be pressed w/the trigger to get it to run - again w/the nozzle off the floor. It also seems to shut off too easily while vacuuming. I replaced the motor,which didn't fix it. Is the reset switch next on my list? T


... Rainbow E series Canister Wet/Dry Vacuum

Rainbow E series AquaMate II leaks around the quick connect/disconnect how to i fix the leak??


You have to get new O rings for it. You can find them at an Auto supply store, or hardware store. If where you first go does not have them, keep looking. You will find them.\015\012\015\012If you have any more questions let me know. I am ... Rainbow E series Canister Wet/Dry Vacuum

I am losing suction and it sounds as if there is a leak in the vacuum(I hear air rushing around). There is also a high pitched noise. Dyson dc07. Can there be leaks in the gaskets where you clean hoses and filter? are they replaceable. Does the noise suggest the bearings are going in the motor?Is it worth getting fixed?


It wont be a gasket problem - they don't tend to fail. \015\012\015\012A high-pitched noise can be a number of different things. That is too vague to diagnose on here with the description you have given. Can you be more specific? ... Dyson DC07 Bagless Upright Cyclonic Vacuum

D4 Rainbow leaking water around the water basin while running. Already replaced the seal. Still leaking.


Clean the water separator. Use a tooth brush if you do not have the Rainbow separator cleaning brush. It is the same thing, and works perfectly. :-)\012\012Ralph ... Rainbow Technologies D4 Bagless Vacuum

Nothing inn the canister after using,suctione working,bottom roller working,no air leaks from hoses.Also when running awhile it shuts off by itself,have to wait awhile to use again


I'm not sure what vacuum you have, but that sounds like a blockage to me. Thermal shut off kicks in, shutting the motor down, to prevent damage from overheating. After waiting like 1 hour it probably comes back on. Make sure hose, filters, bag (if an ... Vacuums

I have a singer 328 and the foot pedal has developed a problem the machine is running all on its own can I fix the problem with the foot pedal


... SewShop.com 328 Singer Instruction Manual .pdf format

Dyson leaking air around bottom of cannister now what do i do to fix


... Vacuums

My sister used my bagless Dirt Devil EnVision vacuum to clean out the last bit of ashes from her fireplace. The vacuum still runs but I do not think it is picking up. Can this be fixed?


You should just get a new vacuum. ashes are not very good for vacuums ... Vacuums

My Hoover carpet cleaner is approx. 7 yrs. old....husband believes motor is shot? Smells burnt when running....fix or buy new???


You are correct, the motor is shot. if you like the machine replace the motor. i would get an est. on the machine from your local vac shop and the go price them. in some cases its better just to get another machine. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

MY Bissell Little Green Machine doesn't seem to be sucking as well as it should be ...dirty water is leaking out of the attachment used for **** it up (the brush) whats with that and what do I do? Thanks!


Well i see you wrote the question a long time ago but here is what I found. I have new carpet and we got a puppy. You know what that means. Anyway a lot of use and the new carpet gave up a lot of fibers. The fibers lodged in the "s" shaped portion of ... Black & Decker Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1346 seconds