Having problems with your Vacuums ?

Coffee will not stay hot after the brew is finnished. The pad for the coffee pot will not stay hot.

Answers :

Flip upside down thak out screws check for lose or broke wire on heating pad
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Coffee will not stay hot after the brew is finnished. The pad for the coffee pot will not stay hot.

Flip upside down thak out screws check for lose or broke wire on heating pad ... Vacuums

I have a GEelectric percolator from about 1955. It looks like a pot belly stove, or an egg standing upright! It works fine, except the little red light that normally comes on when the brewing is completed no longer lights. I assume it is the bulb......but how do I get to it? It is located near the coffee brew setting mild-to-strong sliding lever.

Hello Theodore.I also use a coffee pot similar to yours. Makes a great pot of coffee.While I have never had to replace mine I have had these type apart years ago.It probably has a 120V neon style bulb soldered into the circuit mount ... Vacuums

Our Mr Coffee Model FTX 45-1, all lights are onit is plugged in but thebut it does not brew coffee and the heating element does not get hot.

... Vacuums

I have a welbilt electric percolator model PW-28 that won't go through the whole brew cycle. It starts OK, but stops way too soon, so the coffee is weak and not very hot. Can it be fixed economically?

... Vacuums

Hamilton beach brewstation 47665 will not stay hot after brewing, can I replace a part?

... Vacuums

My Tim Horton's (Bunn) Coffee Maker won't stop boiling the water really hard (to the point where it practically boils the full pot away). When I go to make coffee the next time it's boiled so hard that it doesn't give me a whole pot of coffee just like 3/4 of a pot, and if I haven't used it in like a day it's boiled it down to half a pot??... it's beginning to make me angry, as I have cleaned it in the past for this trouble, but it doesn't help or make a difference. Can somebody please help me??

... Vacuums

Problem is you can have the maker plugged in but you can't manually brew the coffee. The switch will not engage to brew the coffee. Stainless Steel, Programmable Cuisinart CUI DCC 2000 model.

I have this model.I'm not sure if you mean if it won't brew manually or not at all.Ours failed because the thermistor failed due to the fact that the heater element was badly calcified (calcium deposits). It would come on for ... Vacuums

When I put a k-cup in and it brews the coffee, it leaves coffe grounds all over the top of the k-cup and in the holder area and I get some in my coffee, it looks like the top needle is making too big of hole when it starts brewing(???)

Sorry to read about your problem, I hope this helps you out.I would follow the cleaning list below, I an addition you may have a bad batch of k-cupsplus just run some hot water, with out a kcup in the holder.\015\012\015\0 ... Vacuums

I have a probleme with my coffee maker model 81178 kenmore. He dosn't make his full cycle and the coffee is weak.I even put more coffee but it didn't change.It does that with all the coffee brand I tryed.The coffee is hot anough but weak. thank you Richard

Looks like you have a problem on the center tube. Check:\0121. It has the spring to press tube to the bottom of the device.\0122. It is clean with no obstructions.\0123. Water comes up frequently and each time more darker to the little cu ... Vacuums

Rival model CM1100 coffee maker: I can not get the coffee carafe in the right position. Should it lock in? Sometimes the coffee does not enter the pot and overflows onto the counter. Should the handle be on the left or the right or maybe the center? Please help me. I am not a coffee drinker and when I try to serve it to friends, I end up with an embarassing mess.

... Vacuums

When I set my sunbeam 3331-33 coffee machine to just brew, I can hear a click but it doesn't **** up the water to brew. I have not tried the grind and brew position to see if it will brew... any suggestions on what I can do? Everything is in properly (the lid is closed properly, the carafe is on properly)... Thanks.

... Sunbeam Vacuums

My CJX Series decided not to brew! I checked the manual's troubleshooting, (The coffee is not brewing) everything is correct! The unit has power and the light comes on, will not start brewing cycle.

Heating elements in coffee makers have an internal thermal protection device to locate it access the bottom cover find the wires leading to the element you will find on one of the wires a silver bullet shaped device this is the culprit, you can check ... Vacuums

I have a Mr Coffee EMCP 50 Espresso maker. I tried to brew espresso but the coffee wasn't coming out because it was ground too fine. Now, there are 2 flashing lights one red and green-I have tried turning it off and turning it back on after waiting about 20 seconds so it will reset the pump but it is not working. Any suggestions?

... Vacuums

We have a Starbucks Barista Aroma Grande Cat. #BA12 1200 W 120 Volts 60 HZ -- bought in about 2006. The lid to the coffee pot has a broken part -- little round plastic disc that when you press the little handle on the lid -- it allows the coffee to be poured. I would suspect we would need the whole lid to be replaced!! Can you help?

... Vacuums

I have a Platinum B70 Cofee maker bought from Costco in June of 2010. I have set the on time, the off time, the temperature (192) and the cup size. All went well until today. Now the machine will not accept cup size. It goes to the max only, and it will NOT brew coffee, even though the window says "Ready to Brew".

Take it back as its under warrenty ,i think it may have a problem with the electronics which could be caused by brown out or a voltage spike ,either way its no good unless the computorised panel works ,my best advice is to buy a small coffee perculat ... Vacuums

I have a Cooks esspresso model 22052 coffee pot and it will not turn on and make coffee. What could be the problem? It was a gift and I had it less than a year and it quit working.

... Vacuums

The red light on my coffee pot is on and will not go off. I have run cleaner thru the regular cycle now what? Its a 12 cup programmable Mr. Coffee.

I know this sounds like a pain but it takes a while toget that silly light to stop.\015\012Decalcifying your MR. COFFEE\302\256 Coffeemaker Minerals(calcium/limestone) found \015\012in water will leave deposits in your coffeemaker andaffect its perfo ... Vacuums

Went to turn it on after not using for several weeks and it states not ready to brew like usual but after about four minutes it just turns off. Wont let us brew a cup or access the menu even to choose size of cup or anything. It sounds like it's sucking up water to make cup and pokes hole in the coffee but nothing more than that. It is almost brand new

You have posted the fault in the wrong column with no instruction of the make/model.\012Assuming it to be new , Is it passed the warranty period before we take a look ,?\012Just lave it on for sometime and see if there is any change. per ... Vacuums

My Keurig pauses for about 3 min. befor it brews. Also , when i press the button for the largest serving, it only gives the smallest. It takes about 6 min. to fill a large mug because of the small amount of water and the delay in brewing. When I use the basket with my own coffee, only water comes out. What can I do? Mary Jo Greaver

... Vacuums

I have a 4 showing on the screen of model 48465C, cannot remove it is not for the number of hours to brew, however only brews 4 cups of coffee, even though I have push the button to remove is still there.

Well... to start.... you are on the vacuum area.... can not help here!!!! ... Vacuums

Our Krups km 506 has slowed brewing down to a crawl taking 20+ minutes to brew a pot and essentially steaming off 35% of the water. Is there something that needs cleaned? we have tried running vinegar through it but to no help.

... Vacuums

My Cuisinart DTC-975BKN beeps as if the coffee has finished brewing, but doesn't brew...

... Vacuums

I bought one of these units last year and it worked great for about 9 months and then it stopped brewing coffee. Not sure what is wrong. It will not heat the water to make the coffee. Any idea as to what could be wrong?? Thank you. Pierre

Hi,Either the heating element is completely corroded with mineral from the water or the heating element has gone bad...If it is not heating at all there is some kind of electrical problem or the element is gone bad... ... Vacuums

Need user manual for Farberware Milennium FSU236. How much coffee for 12 cups, 24 cups and 36 cups of coffee? How long will it take to brew 36 cups?

HelloOK, i am still looking for the specific manual for you model, but, at the link below you will be able to have a loo at a similar unit in capacity. Click ... Vacuums

Bag change indicater staying on and vacuum smells hot when using

I suspect there is a blockage somewhere along the pipes leading to the dust bag.\015\012The bag full or bag change indicator measures how strong a vacuum is present at or near to the point where the bag is connected to the pipes. Under normal ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0281 seconds