Having problems with your Vacuums ?

I have found my old Slton Yourt Maker...Thermostat Controlled Model, GM-5 25 watts...but no instructions. Have read many blogs...am I safe to simply put in the ingredients, plug in and wait for 6-10 hurs? If otherwise, I'd appreciate a response. Thanks


Answers :

Basically, heat your milk to a boil and then cool until it reaches the "add starter" mark on the spoon thermometer. Add starter, and then you're good to go.
\015\012
\015\012Found the manual, it's in .pdf format.
\015\012
\015\012http://www.divinemind.biz/files/Salton%20Yogurt%20Maker%20GM-5%20manual.pdf
\015\012
\015\012This should help you out. : )
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have found my old Slton Yourt Maker...Thermostat Controlled Model, GM-5 25 watts...but no instructions. Have read many blogs...am I safe to simply put in the ingredients, plug in and wait for 6-10 hurs? If otherwise, I'd appreciate a response. Thanks


Basically, heat your milk to a boil and then cool until it reaches the "add starter" mark on the spoon thermometer. Add starter, and then you're good to go.\015\012\015\012Found the manual, it's in .pdf format. \015\012\015\01 ... Vacuums

My Ryobi 720r wont start. Absolutely no response at choke + engage lever. I checked the spark plug but no luck. Just test i put little gas in the spark plug chamber. It started only to burn what was in the chamber then stopped.


... Vacuums

I purchased a nordic microwave popcorn maker and misplaced the directions for making the popcorn. I need to know how much popcorn to put in the bowl and amount of oil if any is to be used. I would greatly appreciate this information, because as it is right now I cannot use the popcorn maker. Thank you for your time - will wait for your reply. Deborah Schmitt


The Nordicware Popcorn Popper is one that actually works in the microwave. The 3-Qt. Popper makes light and fluffy popcorn in about 4 minutes. Just place 1/2-cup of popcorn kernels in the bottom bowl and cover with the lid. No oil needed, makes up to ... Vacuums

I have a 1937 Johnson 4.2 HP Outboard Motor LT-37 Serial # 273761. The engine is seized and I am looking for info on the best way to free it. I've started by putting marvel mystery oil down the spark plug cylinders. Any hints and help would be appreciated. Thank you. Ron massauto


Do you think it is the engine or the lower unit? If the engine has set up for a long time it may be the lower unit or the prop gearing. Pull the bottom loose at the flange be-careful of any parts you take off and try and turn the engine then. If it s ... Vacuums

My sunbeam water cooler model #YLR2-5-67H3 has been sitting unplugged for 3 years. I moved, plugged it in and put a water bottle on top and water went all over the floor. I unplugged it, (read the instructions on the front, duh) and it still leaks on the floor. What should I do? I put it over the sink, emptied it, checked the drain plug, tried running a glass full of tap water through each tap. Only the room temperature one would work.


One of the rubber connecting hoses inside it has dried and aged so the pressure of the water from the bottle made it burst.\012\012\012You will need to open it, find the defective hose and replace it - a 2 hour relatively easy job. The hardest ... Sunbeam Vacuums

Have an older model Electrolux canister model. The electric plug is broken so I got a new plug to put on. When I cut the cord to replace the plug, the dang cord retracted into the unit. So how do I get access to the cord area so i can find the end to the cord!


Hi,\012\012You have to open the vacuum cleaner and look for the wire.\012\012It is located inside the circular wheel, where it wind itself up.\012\012Don't be afraid to open it, unless your willing to pay somebody just to install a ... Electrolux Vacuums

I have a Kirby G4. I have noticed the last few days when trying to vacuum that it is blowing more than it is sucking up. I put on a new bag to make sure it wasn't too full. I also put on the hose and noticed it's not sucking as well as normal. I unzipped the back of the bag holder and noticed the bag isn't inflating as it should be as well. I appreciate any advice. Thank you.


Take the mini emptor off(plastic piece on bottom of cloth bag) this is done by rotating it away from the body of the machine. There is most likely a clog there. Also take the brush head off and inspect fan for chips or cracks this will also reduce su ... Kirby G4 Bagged Upright Vacuum

My Dyson Aminal Vacuum simply will not turn on. I plugged it in this morning, pressed the power button- and nothing. No warning sounds, simply silence. Sigh. Nothing is wrong with the wall outlet.The vaccum is 3 years old but has run perfectly until this point. The brushes are clean of any accumulated hair. What part might need replacing?


The power switch may need to be replaced. Call the Dyson helpline - they will give you the location of an authorized Dyson dealer in your area who will be able to replace the switch. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I had plugged it in to use it, turned it on and instantly it made a pop sound, smelled of electrical, and would not turn on after. i even waited for a while let the smell go away and tried a different plug in the house and still no operation of any kind. Is there an internal fuse that i could check on this? where is it located?


Sorry there is no fuse in the vacuum. It sounds like there is a short somewhere when they manufactured it. There is no way to fix yourself you will need to take to a repair shop\015\012\015\012Good luck ... Vacuums

I have a grafter safe model no AA/R06/1.5V - GT24 batch number 0171-2C and have lost the instructions and the key. I have put in a wrong pin number and now I am getting the message 'error' flashing across the safe and don't know how to get into the sate.


... Vacuums

Omc specs 1989 rinker boat 4 cylinder gm/omc i need specs for: plugs, points,idle, prop size,etc. boat had been sitting for a while, i changed oil,points,plugs, new gas,etc. i can crank it, but it's a little rough and won't idle below 2000 rpms. any advice or help would be appreciated. thanks. tommy


You will need to repost this in the correct section, this one is for vacuum cleaner repairs. ... Vacuums

I have a Flotec shallow well FP4122-08. A burglar stood on the pump this summer to gain access to my goats building (window). There's a small black tube that came off at both ends. When I put the tube back on, it shoots right back off as soon as the pump is plugged in. I don't know the name of the part (tube) to order a new one, and I don't know if it just plugs onto the fittings of both ends, or goes into the pump at the end with the round fitting on it.


... Vacuums

Do you have to wait for the filters to dry Before putting them back in vacum?


Yes ... Bissell 6594 PowerForce Bagless Upright Vacuum

I was vacuuming and the power abruptly stopped working. The plug had slightly slid out of the wall socket, but when I put it back in, it wouldn't power up again. The wall socket is working for other appliances.


The first thing to suspect is that the wall plug on the vacuum cleaner is defective, to confirm this you will need to access the on/off switch on the vacuum, there will be three wires coming to the switch from the cord ... Hoover S1361 Bagged Canister Vacuum

No suction Hello - any help with this would be much appreciated! I just changed the bag and filters. The machine runs, seems normal, but there is no suction. There is no blockage of the hose, as indicated by the fact that that little viewer window above where the hose connects to the unit is not showing the red portion that it shows when there is something blocking the hose (god, this is hard to describe!). If I disconnect the hose and put my hand over the hole, I feel some suction. But


Well, it actually sounds like there is a blockage. Try removing your hose and dropping something through it, like a quqrter. If it comes through, no clog. If it is clogged, I believe that machine has a blower on the upper part of the cleaner (mayb ... Miele S514 Solaris Electro Plus Vacuum

After two years, my Euro-Pro Shark Steam Mop, Model S3101, no longer ejects steam. I have used tap water. I think the line is clogged with mineral deposits. The light is on when plugged in, and the unit heats up. I even put in vinegar for about an hour to break up the calcium deposits, but it did not correct the problem. How do I fix it, or, where can I take it locally to be fixed (Orange County, CA)?


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

HOOVER 6430-900 Runs for about a minute or two and shuts off. Wait a while and it will run again. Changed the belts, new bag, new filter. Seems to put out a lot of heat when running.


Hoover Fined for Failing to Report Vacuum Cleaner Fire Hazard\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\01 ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Shark plugged on, Light is on, chamber full to line with water, waited 30 min to 5 minutes - NO STEAM, Tank is hot.


Soak the "device" in 1/2 vinegar and 1/2 water. heat it up until it makes steam, then empty it and use distilled water and it will be fine.\015\012\015\012\015\012-----------\015\012Also possible clog or build up of di ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

My Bissell vacuum roller does not spin when I put it on the carpet but does spin otherwise.


... Bissell LiftOff Revolution Pet Vac 37602 Vacuum

My hoover power drive vacuum simply died. It just shut off. I checked the plug, etc...I just can't get any power...Can you help?


If no light or motor sound cord is probably bad. Look near AC plug or just replace the plug end. Check with ohmmeter for continuity with switch ON. ... Hoover U6311-930 Power Drive Bagged Upright Vacuum

Vacuum cleaner We have a panasonic MC-E47electronic which seems dead. It has a speed control which we nearly always had on full anyway. Have tested continuity through plug, flex and on/off switch and all OK. from then is open circuit through speed control which consist of slide rheostat and mystery small green box (2cm x 2cm x 1cm approx). Across motor there is negligable resistance. Machine is quite old and not worth paying out loads on poarts if it is safe to bypass speed control and connect


Yes it is safe, but i would make a switch? ... Vacuums

I got a vacumn from a friend who ungraded and though i used at her home when i got it home it would not turn on when plugged in and i check everything and no use. my friend lost her manual. im in my 60's and on a disability fixed income so cant afford to take to repair but got lots of men at church who would help if they know how to trouble shoot it. and would really appreciate any help. thank you , ann


Hi\015\012In the UK we have similar machines but they are made by Vax. If you can't source the correct user manual from Hoover.com consider the following - it is a free download.\015\012\015\012http://www.vax.co.uk/downloads/pdf/vzl-60156016_v2 ... Hoover U5194-900 Mach5 Multi-Chamber Cyclonic Vacuum Cleaner Bagless Vacuum

Have a bissel proheat plus. There is no water flow. It has been used once,but was not flushed with water. Tried to fix it myself. Don't know if it is put together correcly. Or sommthing may be plugged up.


If the belts are new and it still doesn't spray then its probably a clogged heater core, it isn't easy to unclog so i would take it to a bissell repair center. ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Help Canister stays on until you put the hose on, then it shuts off. If canister is on and you even stick anything where the vacuum plugs in it turns off.


Hello jane just a brief message if you look on tis board at a similar problem i have just replied to about canister cover lifting off ? this may also be the same problem as the fixit solve i have suggested ? about blockage of ... Electrolux UltraLux 2000 Bagged Canister Vacuum

I have plugged it in and waiting for it to steam, but nothing happens. what do i do?


Hi,Take it back it is not working...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0565 seconds