Having problems with your Vacuums ?

I have a bissell flipit floor cleaner should i get steam


Answers :

No, a flip it does not have a heater.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a bissell flipit floor cleaner should i get steam


No, a flip it does not have a heater. ... Vacuums

My bissell proheat upright steam cleaner is spraying out through the attachments just fine, but will not spray to the floor when using upright. we've taken it apart to find that there is no water at all going through one of the hoses, but it appears the hose is connected behind the on/off and heat switches, we can't seem to figure out how to get in there to replace that hose....any suggestions on how to access this?? just curious how you would get in to replace the hose, we know it is the hose..


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Cant get any water to floor or hand dispenser on my bissell power pro steam cleaner


I have 2 = 1697 cleaners. I finally located the problem by switching tanks from one to the other. The small red seal on the bottom of one tank was bad[ tiny checks on ribbed part of seal] causing the unit to loose vacuum & prime. Simple problem ... Bissell 1697-7 Powersteamer Pro Deluxe Vacuum

My Bissell steam cleaner appears to have suction at the connecting point for the receiving tank but it does not collect the disbursed liquid and cleaner either on the floor mode or the handle tool. The floor is soaking wet!


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissell steam mop not working - Bissell 1867-7 Steam Mop Chemical free hard floor cleaner-Green Cle


... Bissell 1867-7 Steam Mop Chemical free hard floor cleaner-Green Cle

I have a steam cleaner and i can not get the black arm brush to keep one side up and when you trun on the steam cleaner the brush dose not spin when you start to clean the floor but it will spin when you have it siting up right


Sounds like you could have an elevator broken (part #2000010). You will have to take the top off to replace them or to check to see if one of them is broke. There is one on each side so when the handle is in the upright, they push againsy the brush ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

My bissell 9400 pro heat steam cleaners sprayers are clogged again...how can I fix this with out taking it to a shop to get fixed?


The water sprayers on your Bissell are probably clogged. I had this problem this morning, myself, with my machine, about 15 months old. They get clogged up with mineral deposits. This is a *fairly* easy thing to fix yourself. Read all the w ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I can't get the floor brush to stay on - Euro-Pro Ultra Steam SharkTM II Hard Surface Steam Cleaner Vacuum


Sometimes the locking latch gets broke off. You may need to replace the swivel elbo. ... Euro-Pro Ultra Steam SharkTM II Hard Surface Steam Cleaner Vacuum

I have the 8920 bissell proheat steam cleaner. i


You must have a suction problem. Try checking the lint filter, which is located in the top clear plastic section (the section that goes on top of the bladder section - it has the dial to switch from floor to tool use). There is a small plastic lint ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I lost the manual for my Bissell model 8920 Steam cleaner. where can i get one Victorea


You can get the manyal here.\015\012\015\012http://www.bissell.com/images/UserGuides/9200_908.pdf\015\012\015\012\015\01 ... Vacuums

Can't get my bissel steam cleaner to sucktion


Check on board switch for tools only or vacuum, is switched to vacuum, as majority of vacuum suction power is diverted to hose/ hand held devices. See if vacuum hose has suction as well? The unit may be clogged with carpet fibresas well and t ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

I have a Bissell 1623-1 Steam Cleaner. It will work good for about 2 minutes and then after that it will not dispense cleaning solution on floor or through the hand held wand.I have replaced both drive belts with no improvement. I have cleaned it and found no obstructions in hoses and spray nozzles, put back together and it still will not dispense. Is it possible the pump or solenoid is no working? Aaron


... Bissell 1623 Steam Cleaner

I have lost the instructions for my Bissell Flip-It Hard Floor cleaner. Where can I get this? Thank you!!


Go to http;//audio.manualsonline.com maybe there you find it.Good luck ... Vacuums

I have lost the instruction booklet for my Bissell Flip-It hard floor cleaner. Where can I get this info on line? Thank you.


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=747125\015\012Generic problem for all Vacuums\015\012I have lost the instruction\015\012Posted by kaner ... Vacuums

Bissell model 8920 deep cleaner. I get cleaning fluid spray on the upper furniture wand but not at floor wand.


The heater is clogged its in the handle ... Vacuums

On a bissell 9400 steam vac i am getting spray from the hand wand but not the floor spray. I checked all the solinoids and lines and switches. I blew throurgh the lines and got no clogs. can you tell me what else can be wrong


... Bissell Vacuums

I lost the manual for my hoover steam cleaner spot. and now i can't figure out how to use it. i've only used it once before and i can't remember how to get it working. the water will come out but it just floods the floor when i turn it on. what do i do?


Hi,Here is a link to your manual. Hope it helps.http://www.retrevo.com/support/Hoover-F5505-Vacuums-manual/id/8231dj681/t/2/ ... Hoover F5505 SteamVac Spot Vacuum

Okay i dont know what model it is all i know its a bissel steam cleaner all white and is on the floor kind and i need directions how to use it


There Is A Model Number On Either A Sticker Or A Plate On There Somewhere If You Can Find It Ill Give You A Link To The Manual. ... Bissell 1697-7 Powersteamer Pro Deluxe Vacuum

I have A Bissell power heat steam cleaner and tubes are clogged how do I get to 1 and how do I unclog them. It just stop spraying it will **** up but it will not spray out of the main part or out of the handle


Lisa: If anyone you know is mechanically inclined, they can open the machine using a screwdriver. follow the path the water takes in the tubes and find out where the water is being blocked. You'll know what to do to fix the machine when yo ... Vacuums

Bissell steam cleaner will not spray or prime


... Bissell 1725-1 Little Green ProHeat Wet/Dry Vacuum

Bissell Proheat cleaner hand cleaner spray but floor cleaner wont


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissel deep carpet steam cleaner not pulling water out of carpet


How can i make the water come out ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissell laminate floor cleaner wet vac and flips to dry vac


You just need to replace the cap and valve part # 2036919, You should be able to order the part thru Bissell.com, or they will tell you who you can call close to you. ... Vacuums

Bissell ProHeat Carpet Steam Cleaner stopped spraying.


The problem was a clogged heating unit which is located in the lower handle. There are two clear hoses going up the inside of the left leg of the lower handle that go to the heater and to the in-line water switch all within the lower handle. I unplu ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

HOW DO I CHANGE THE BELTS ON A BISSELL STEAM CLEANER


On your housing you will see a plastic cover adout 4 inches long remove this piece and you should see where your pump belt goes. flip your steamer over and remove the little red retainer that sits by the belt you have located. at this point you can t ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0711 seconds