Having problems with your Vacuums ?

Water pump grinds but no water is being extracted from the resevoir and flowing through the coffee basket


Answers :

You could have a clogged water hose, or you might have a clog where the water enters the coffee filter area.
One easy solution would be to look inside your pot and check it. If you think you see a clog, remove it with hot water. You may need to also use a very small, thin bottle brush to get into the tube of your pot to clean it out.

To avoid any clog problems in the future, you should fill your coffeepot with cold water and about 2 tablespoons of regular white vinegar. Put a clean coffee filter in the basket. Then let it run thru a normal coffee cycle. You can repeat this several times if necessary.
After the last time you run the vinegar solution thru, run plain water thru it a few times too.
Your problem should be solved. If not...your going to have to either contact your manufacturer, or just go out and buy a new coffee pot.
But the next time you get a new coffee pot, use the cleaning hints they tell you to use, and be vigilant about it. I have never had a clogged coffee pot because I do this.
It isn't very obvious, but if your coffee starts to taste bad, or your water starts to spit when you brew, your pot may be due for a cleaning. I clean mine about every 3 to 4 months, after daily use.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Water pump grinds but no water is being extracted from the resevoir and flowing through the coffee basket


You could have a clogged water hose, or you might have a clog where the water enters the coffee filter area. One easy solution would be to look inside your pot and check it. If you think you see a clog, remove it with hot water. You may need to ... Vacuums

Saeco Odea Giro pumps the water but the internal spline or gear is not turning moving the ground coffee grinds to the point where the water can pump to the front exit lines so the water is pumped into the over flow resevoir. How do I replace the gear or check to make sure this is the problem. I want to replace this myself.. Also how do I get the unit apart it seems to be bullet proof. Is this a common problem.


It is a common problem if it is what I think it is. However your description is a little confusing. So the coffee does get ground up, but then has a hard time getting to the next stage of the process? Please clarify... And no water gets pumped th ... Vacuums

Bissell ProHeat 2X Select Upright Deep Cleaner not pumping water to floor. Water is not flowing out of the pouch area into the carpet. Water does not come out of the blater, I have checked the line & valve and they are clear how do I check the pump


Make sure you have soap in the soap container or the water will not pump. Sounds strange I know. Even if you have the soap mixture selector turned off, it seems that these machines won't pump clear water unless the soap resovior has fluid in it. D ... Vacuums

How do I remove and clean the grinder on my Saeco v'spresso? It grinds and grinds then says the coffee beans are empty when they're not. If I finally get it to finish its cycle no coffee comes out and all the water goes into the overflow tray and/or the grounds container. I am assuming the grinder is completely plugged up and I tried to clear it out from the chute underneath but no luck...


... Vacuums

I have a kitchenaid artisan coffee machine which is 15 months old just out of warranty. when you start to make an esspresso coffee the machine runs but no water is being pumped through the coffee to the cup you can hear the machine working but no coffee. Thanks Lloyd


Hello lloyd..... There are a few possible causes of this problem. The first is using coffee which is too fine a grind. The second is a machine which needs to be thoroughly cleaned. Most can fix those two areas themselves. The other causes have to ... Vacuums

When i turn on my auxilliary pump, water still flows out.


Leaking from where? The jets up front? If so you need to replace the electrical water control valve. Visit http:www.Michco.com to get a new one or assistance. ... Minuteman C46000-00 Self Contained Carpet Extractor Vacuum

We have bissell pro heat and I have put new belts on and took off the top plastic cover I blew out the lines and I still can't get it to pump water or solution. The red little spinner flow indicater does'nt get water, if I pour water into it it runs out the front. I guess I don't know what else to do. The machine worked fine the last time we used it about 6 months ago. Any suggesttions?


Did you check and make sure the belt is still on right? They do come off from time to time.There are like 6 long screws holding the top cover to the bottom. The are real pain in the behind to put back together once you take them off. T ... Bissell Vacuums

Bissell Powersteamer 1694W won't extract water from carpet. Was extracting fine until the pump/brush belt gear broke off off the pump. I repaired the gear with super glue and the brush is once again working fine. I now have an extraction problem. What did I do wrong? I took it apart and was so proud of myself when I fixed the original problem. Now I'm lost.


Check your re-assembly.\015\012\015\012Have you missed a pipe connection somewhere? ... Bissell Powersteamer 1694 Upright Vacuum

Water will not pump out of my bissel carpet shampooer the motor works ok but the flow indicator is not spinning and no water comes out of machine so carpet is dry


I wasted a lot of time following the expert advice to repair my unit by taking the cover off of the main unit and using compressed air to blow out the lines. The problem turned out to be in the lower panel of the handle (4 screws to remove). The he ... Bissell 8910 ProHeat Clear View Upright Vacuum

Sunbeam Cafe series coffee machine em6910. Even after relacing the group head seal it leaks around the basket when expressing. I have followed all the instructions and tried different grinds and levels in the basket. The seal shows good signs of even contact.


... Sunbeam Vacuums

Bissell Pro-Heat 7901-1 no cleaning solution is pumped out. The flow indicator is spinning and the belt is spinning the beater bar. Have cleaned the flow indicator, checked vavles in the solution tank and water tank and they are working properly. Also checked the trigger to make sure it works okay. Any ideas?? Moody Fan


Bissell Pro Heat shampooer - Fill the soap dispenser with extremely hot water and shampoo with only water for a few minutes. There is often dried soap in the lines. Make sure that all filters are clean. Press the soap container and the water conta ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Bissell ProHeat 2X Select Upright Deep Cleaner not pumping water to floor. Water is not flowing out of the pouch area into the carpet.


The water sprayers on your Bissell are probably clogged. I had this problem this morning, myself, with my machine, about 15 months old. They get clogged up with mineral deposits. This is a *fairly* easy thing to fix yourself. Read all the way to ... Vacuums

I have a Bissell Proheat model 7901. When I pull the trigger on the handle, there is no water flow. The brushe revolves and the unit vacuums any water spilled on the floor. Could it be a failed pump or kink hose or ? Thanks Zap


Take the handle apart and put spring back into place. ... Bissell Vacuums

My Keurig pauses for about 3 min. befor it brews. Also , when i press the button for the largest serving, it only gives the smallest. It takes about 6 min. to fill a large mug because of the small amount of water and the delay in brewing. When I use the basket with my own coffee, only water comes out. What can I do? Mary Jo Greaver


... Vacuums

WATER FLOW VAC HAS GOOD SUCTION, THE CANISTER FILLS, BUT WILL NOT PUMP THE WATER OUT ON ITS OWN. HAVE TO HAND EMPTY. THANKS


Ok . i may have read you post wrong but i think you want the vacuum to empty itself ? i never heard of any vacuum emptying itself ......... the water or dirt goes into the canaster . when full remove the top and dump the bin . some than a drain pl ... Shop Vac 584-06-00 Canister Wet/Dry Vacuum

No water flow from vax 6131. replaced pump no change


... Vacuums

Nothing spraying out of Bissell Powersteamer Proheat. I've check filter under flow indicator, pump belt is fine, cleaner in proper tank, bladder of water tank is full. We've had it for a very long time but it's barely been used. Can anyone help?


... Bissell 1698-1 PowerSteamer ProHeat Plus Upright Vacuum

When I set my sunbeam 3331-33 coffee machine to just brew, I can hear a click but it doesn't **** up the water to brew. I have not tried the grind and brew position to see if it will brew... any suggestions on what I can do? Everything is in properly (the lid is closed properly, the carafe is on properly)... Thanks.


... Sunbeam Vacuums

Hi I have a Breville BarVista espresso machine model BES200. The water doesn't go through anymore, even when the filter is empty, so it's not a coffee problem. Pump maybe ? How can I fix it Thanks


... Vacuums

I have a homedics rainfall fountain wrf-rel, I can not get the water to flow or the sound to work. The light comes on. The pump is properly installed. What should I do.


... Vacuums

Windsor cadet 7 water flows all the time


... Winsor 72126- Windsor Cadet Switch DPDT 3-POSITI

I have a Saeco Armonia Espresso Machine. The water pump was running when the tank ran out of water and when I refilled the tank, it wouldn't start again. I unpugged it and turned everything off overnight. The pump is very loud and won't pump any water.


Common on Armonia...There is no water in the system, so the pump is pumping air!!you have to push on the usual button but make sure the hot water button (for tea for ex) on the right side (same as steam opening valve) of the machine is op ... Saeco Vacuums

Hi my proheat bissell 7901 stopped pumping water to the floor, but it pumps water from the hand hose. I read the manual and followed how to check belt and the flat belt on right side of shampooer is fine and I turned on and it turns and so do the brushes at the bottom of the machine. I was reading online and I guess there's two belts on this machine? where can I find the other belt to see if it needs replacing. I guess it's a ribbed belt? that is the water pump belt?


Just taken ours apart with the same problem... found it was caused by the 2 halves of the main casing coming apart in the area where the upright pedal release is. I found this to be due to the upper casing having broken in 2 places - the bottom of th ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

My electrolux eba60002X coffee machine is built in but despite grinding the coffee beans has stopped dispensing and liquid coffee. I have cleaned it but without success. You can hear it grinding and then nothing happens. HELP!


... Vacuums

My Bissell Quicksteamer Model 1960-R won't spray cleaning solution. I have cleaned it and taken apart the whole thing. I can't find any problems. The holes are not cloged where the water comes out as I disconnected it and blew through it to be sure. The lines show water trying to go through. It is as if it doesn't have enough power to pump the water out when I squeeze the trigger. I am thinking it is the pump thing but can't find a replacement part for it.


... Bissell 1960-3 QuickSteamer Plus Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0552 seconds