Having problems with your Vacuums ?

The infrawave light blew out in the black and decker fc150r model, can this be replaced.


Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The infrawave light blew out in the black and decker fc150r model, can this be replaced.


... Vacuums

REPLACEMENT FILTERS WHERE CAN I GET REPLACEMENT FILTERS FOR THE BLACK AND DECKER 9.6 VOLT WET/DRY CORDLESS VAC MODEL # CWV3630


Just bought a B&D dustbuster. They say extra can be ordered by calling 1-800-54-HOW-TO. It also says be sure to have the model number of your DustBuster with you for proper filter selection. ... Black & Decker CWV3630 DustBuster Wet/Dry Vacuum

My black & decker cyclone type1 blender model blc 12600b has only been used a couple of times and now it has a flashing power light when I plug it in and will not work?


... Vacuums

Is the black and decker infrawave bulb a replaceable part or is the oven shot? I cannot seem to find a way to remove it Thanks


... Vacuums

I need a replacement blade for the Black and Decker Handy Chopper model H224.


... Vacuums

Replace battery in fhv1200 - Black & Decker Black Decker FHV1200 Bagless Canister Cyclonic Vacuum


Try this link belowhttp://www.blackanddecker.com/product-type/cleaning.aspx ... Black & Decker Black Decker FHV1200 Bagless Canister Cyclonic Vacuum

Adding hampton bay light model #430-727 to ceiling fan. ceiling fan works but lights dont work. connected white to white wire & black to black wire. what else can we try?????


... Vacuums

I have a clarke bench grinder model 1002. I have a light that I would like to attach into the wiring though the grinder wiring in it's base. The light has two wires, and the grinder has a ground that is grounded to the base, a black that goes to a switch then to the motor. The white goes directly to the motor. where would I have to splice in the two wires from the light? I have a switch that I would like to put in for the light on off also.


Attach the white wire on your lamp to the white wire on the grinder.\012Attache the black wire on your lamp to the black wire on the motor side of the switch.\012This will give the lamp power any time the grinder is turned on.\012Yo ... Vacuums

Battery replacement I would like to replace the battery on my handheld Black and Decker 9 volt battery Dust Buster. But where is the battery? How do I remove the old battery so I can replace with a new battery?


... Black & Decker CHV9600 Handheld Vacuum

Bissell Powerwash Proheat. model 1698-j, 220-240v, 50/60Hz, 1200-1400w. Motor stopped suddenly (ident label specifies type Ametek 119464-02), supply inline fuse at motor ruptured, fuse replaced but motor sparks like an angle grinder at armature and blew replacement fuse. Where can I obtain a replacement carbon brush set for the motor. UK based


... Bissell Vacuums

I need to purchase new blades for our 52" Jericho IV ceiling fan, Model 166315. I went to home depot in Harrisville, UT and they said that we would have to contact you and they didn't have ANY replacement fan blades in stock. HOW COULD THAT BE WHEN THEY HAVE HAMPTON BAY FANS ALL OVER THEIR LIGHTING SECTION? What kind of a business are you running when one can't get replacement parts? Our fan is making noise and I want to replace the blades. How hard can that be? By-the- way; I hope you no


... Vacuums

Is there a cheap battery replacement Black and Decker PHV1800


Hi pwolft... \012Amazon offers pretty large number of black decker replacement batteries, click here Finally charging for our multi device world and pick one (which fits). \ ... Black & Decker PHV1800 Bagless Handheld Cyclonic Vacuum

I have older Electrolux Epic Model C102D - warning light is on (icon of cup with bunch of holes in it). Is this about the filter BAG needing replaced or about the HEPA filter? Do I have a HEPA filter, and if so, how do I replace it?


... Electrolux Lux 5500 Canister Vacuum

I have a Hampton Bay Midili fan which I just installed about a month ago and it was working fine. A few days ago when I flipped the switch on the light flickered on and off consistently until I turned the switch off. The remote also stopped working to control the fan and light. Since this model only can be controlled by the remote I am worried I will have to replace the remote already after only 1 month!


In many of these remote controlled lamps you cant use the new spiral light bulbs .. you can only use standard incandescent lights .. if thats not the trouble then you may indeed have a bad controller (in the fan) .. there is probably at least a 90 d ... Vacuums

The Heath sensor I have is an old model 5411-A. It is seperate from the light fixture. Threr are three wires coming from the sensor: white, black, and red. How do they connect to the black white and ground from my source?


... Vacuums

I have a Hoover self-propelled windtunnel, purchased 6-04. It gets light use. I have replaced the v belt 3 times, once under warranty, and it must be replaced again. It appears to be in very good condition, but is stretched too big. When I purchased 2 v belts a year ago, one was already too stretched,but when my Dad took it back, the salesman put it on another model and said it was fine (Dad never mentioned this to me). Is there a way to adjust the vacuum to hold the belt tighter? Do they re


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=675093\015\012Generic problem for all Vacuums\015\012I have a Hoover self-propelled\015\012Posted by kl ... Vacuums

Belts I have a Hoover self-propelled windtunnel, purchased 6-04. It gets light use. I have replaced the v belt 3 times, once under warranty, and it must be replaced again. It appears to be in very good condition, but is stretched too big. When I purchased 2 v belts a year ago, one was already too stretched,but when my Dad took it back, the salesman put it on another model and said it was fine (Dad never mentioned this to me). Is there a way to adjust the vacuum to hold the belt tighter? Do t


It is the flat belt that gets stretched and should be replaced at least every 6 months. The V belt wears down so it won't it right in the brush roll V. Maybe the belt tensioner wheel has a problem, sometimes they get hook up and won't engage the V ... Vacuums

Irobot Scooba model 33501 the check brush light immediately goes on and irobot does not work. I replaced the brush and it still will not run and the brush light remains on.


... iRobot 5900 Scooba Robotic Wet/Dry Vacuum

Royal vacuum cleaner model 4600 wiring diagram I have a Royal Vacumm Power Tank Model 4600. I replaced the switch (6 wire - 3 position) that is on the tank. One side of the switch control just the blower. The other side control the blower and the POWER head - wand with a variable control speed. The middkle position is off. After I installed the swith, the power head - wand is powered in either position. There are three wires comming out of the wand: White, Red and Black. I guess I wired somethin


... Vacuums

I have a Palm Springs Ice Maker Model JS-ZBJ-10, and the Power Indicator Light blinks and tray does not fill up. I have had the water line clogged at one time and blew out the clogged line, but this is not the problem this time as I cleaned it and the light still blinks.


... Vacuums

REPLACE battery black and decker CHV7202 vac


... Black and Decker USA CHV7202 7.2-Volt Cordless Wet/Dry

Black and decker dust buster model chv 1218 manual


... Black & Decker Vacuums

I just bought this vacuum at a second hand store. My girlfriend told me to grab it as it such a quailty product. How ever I can't find a model number or anything else. I need a manual please. Does it take bags? Do I need to replace the filter or just wash the one I have? It is black and silver, cannister. It also says big gary's vacuum system warehouse in surry British Columbia, Canada. It also says to use filter pow-r-nozzle 96. I have no idea of the year.


I suggest you google what you know. I dont think anyone here can suggest where you can get a manual for a machine you dont even know the name of.\015\012\015\012You ask about a bag ... I dont know ... is there one in it now? You ask abo ... Vacuums

Change blade on old model Black & Decker circular saw


I drp a screwdriver through one of holes in the blade; that "locks the blade" when the screwdriver comes up against the sole plate. Works great for tightening as well. ... Black & Decker S500 ScumBuster Handheld Vacuum

Electrolux epic series 6000 sr model canister...we put a new bag in machine but it wont turn on and the light is on saying the bag is full and needs to be replaced...we tried the on-off switch several times but it wont turn on...why?


... Electrolux Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0804 seconds