Having problems with your Vacuums ?

Keurig model B40 How do I empty the resevoir , I can empty the cold watet tank. We are moving so need to completely empty all water.


Answers :

Hi,

The water reservoir lifts out. There are two tabs on the side which lock it in place. You may have to pres on them to remove it. If you are wanting to completely empty the entire machine, I have found an instruction manual and have instructions for purging: Fill reservoir with clean water and replace on machine with lid on it. Raise and lower handle without K cup inserted. Wait for the red light next to "heating goes off.
The blue lights on the control center will begin flashing. Put a cup on the drip tray and press "Brew"

When finished, repeat brew procedure 2 or 3 times and inner tank should be empty.

Hope this helps, if it does, please place a vote for me.

Good luck with your move,

Handie Andie
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Keurig model B40 How do I empty the resevoir , I can empty the cold watet tank. We are moving so need to completely empty all water.


Hi,The water reservoir lifts out. There are two tabs on the side which lock it in place. You may have to pres on them to remove it. If you are wanting to completely empty the entire machine, I have found an instruction manual and have ins ... Vacuums

My sunbeam water cooler model #YLR2-5-67H3 has been sitting unplugged for 3 years. I moved, plugged it in and put a water bottle on top and water went all over the floor. I unplugged it, (read the instructions on the front, duh) and it still leaks on the floor. What should I do? I put it over the sink, emptied it, checked the drain plug, tried running a glass full of tap water through each tap. Only the room temperature one would work.


One of the rubber connecting hoses inside it has dried and aged so the pressure of the water from the bottle made it burst.\012\012\012You will need to open it, find the defective hose and replace it - a 2 hour relatively easy job. The hardest ... Sunbeam Vacuums

I have a Zenith ZD300 Dehumidifier. Bucket full light blinks. The water bucket was not completely full. Emptied the water bucket and re-inserted. The bucket full light continues to blink. The humidity setting LCD shows 1%. What is needs to be done to correct the problem?


... Vacuums

My indesit is70cs is blowing out cold air instead of hot it is taking hours to dry the clothes. I have cleaned all filters and the water container does not need emptying ????


Could be element heater or thermostat/ likely thermostat......cut out ... Vacuums

I just purchased the hoover steam vac model F5853-900 from a garage sale and everything seems to be working well except i dont see any steam coming out from anywhere and the water in the vacuum stays cold. is there supposed to actually be a steamer inside this vacuum? if so, is there a button i need to turn on for the steamer to work? thank you so much for the help!


... Hoover F5837-900 SteamVac Supreme Wet/Dry Vacuum

I have 1699-R Proheat carpet cleaner recently I was replacing the food pedal during the process some tubings that carry water/chemical got mixed to the point that one side instead of spraying chemical sprays only water from oneside the other side that is connected to the flow indicator cap is completely dry does not move at all. I am looking on line to see tubing diagram for model 1699-R


The instructions in this Repair Guide pertain to the Bissell PowerSteamer ProHeat (#1698)\015\012and the Bissell ProHeat ClearView(#1699). \015\012If your unit matches this model numbers then the repair guide plus diagrams for this unit is mentioned ... Vacuums

Shark steam mop - Model S3501 does not produce steam. I checked the water after 10 minutes. It was completely cold. I primed the pump several times as suggested in the user instructions


\012Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Ste ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have a Bissell Steam Cleaner that is not sucking up the water when cleaning. I used a full container of water and when it was empty I emptied out the water, only to find very little dirty water in it. I noticed the window, as i used it, seemed like it wasnt sucking up the water. I took the plastic cover off to clean it (it didnt look very dirty in the first place), an i noticed that the grey plastic flap was on but not moving up or down. I thought there may be dirt in it that prevented it from


... Bissell Vacuums

Sylvania Hot & Cold Water Dispenser Model #SE80070 Cold water is at room tempature/Hot water is fine. Has been drained, cleaned and turned back on.


... Vacuums

We have a Bissell Proheat 2X (model 8920). The problem we are having is when water/soap is initially released (all settings) it continues to leak out the front water spray nozzles unit the water containers are empty. The vacuum works but can't keep up with the continuous water leaking out. Do you have any idea what is sticking open to allow the continued release of water when the machine is running? Thanks Rick


Return it. It is faulty and should not do that. Mine does not. Does require changing water about evrery 10 minutes but one can see the filth in the water. Also re-clean with plain water over areas that were cleaned to remove all cleaner. Old cleaner ... Bissell 8920 ProHeat 2XTM Upright Vacuum

Just bought a used bissell steamcleaner 2x model 9300 needs fluid tank tried it out by filling water bladder does not dispense water when I pushed the tigger it does **** up water that I spilled on the carpet is it worth keeping after I buy the fluid tank


Click this link for spares for bissell 9300http://www.vacsite.com/en/bissell-parts-1/bissell-parts/9300-upright-deep-cleaner-se ... Hoover F5906-900 Upright Steam Vacuum

Envirosteamer 300 leaking water. Older yellow model. I put water in it and as soon as it heats up, all the water leaks out the bottom, and it barely gets warm! It worked fine before. Could it be seals need replacing or something? Thanks!!


... Eureka Enviro Steamer 370 Upright Vacuum

Scooba model 6050. The robot picks up dirt as found in the screen, but does not vacuum up any water. The dirty water tank remains empty after using all of the clean water. Help. Thanks.


The dirty water lines may be clogged. I don't exactly know how to un-clog it, but I would check to see if there is any way to flush them out. or talk to the company's customer service people. They would know what to do without voiding the warrenty. ... iRobot 5800 Scooba Vacuum

My bissell sprays solution and water but does not **** it back up. After the water and solution are gone the return tank is completely empty


1) check the tank is full of water2)check gasket position,can be worn, or damaged fix it3)check the belt worn for inoperable brushes.4)check motor duct gasket, and test it. yif you notice suction in the duct, remove the tank, for assure i ... Vacuums

I have a steamvac v i was wondering if i fill the container of water to the top and does the water need to be cold or hot? I heard I could use tide liquid if so how much do i put in the detergent holder


Hi there SmartAlec from NelsonVacuums.com.au here. I have looked at literally hundreds of steamvacs over the years and you can use warm but not hot water in the tank. You c ... Hoover Vacuums

We lost our instructions to the Kirby Shampoo attachement and how to attach it to the main unit, the belt and how to use it. We need complete instructions and explanations on how to use this as we have tried and the belt does not attach to the main unit, the brush does not turn and the hops along the carpet and no water, etc. returns to the tray. Please help us with as simple and complete instructions as possible. THANK YOU VERY MUCH, LOUIE CAPLAN


First, you'll need to fill the tank with water (warm or cold). There are three fill lines on the side of the tank. Fill to the desired line and add one shampooer tank lid full of Kirby shampoo for each line of water. A full tank will require th ... Vacuums

Need replacement filter for Silent Super Shark model # EP88SS. Filter model XSH 88. Parts search comes up empty.


... Euro-Pro S3325 Handheld Steam Vacuum

I have a very old Soundesign Ultrasonic Humidifier. Model 1866. I need a water tank cap. This cap has a plastic pin in the middle of it as well as a rubber gasket type thing, this helps control the flow of the water. Can anyone recommend a substitute? Thanks Abbey


Just realize its an old post. just throwing mine out i would have sent u the cap. mine stopped shooting mist out cap is good oh well. linda c ... Vacuums

My iron is dripping water my model number is dz6080 focus do i need a new one? It is coming out of the bottom when it is sitting upright. my ironing board is all stained and actually my floor is rusted from when I fold up my board and put it away it drips from the ironing board. I paid alot for this model.


... Rowenta Vacuums

I need help with my Hoover Steamvac, FH 50020. It was new last spring, used it once then & it will not **** up water, things there do not move in bottom portion. Water goes out, but not out. This is a new cleaner, please help!!!


I just found one by the dumpster and worked on it and found the same problem. First I took the catch tank off and made sure the unit still sucked. Then I slid the front of the catch tank out and repositioned it straight down so as to work in the up ... Hoover Vacuums

I have lost my manual for the Mr. Coffee Maker - Model BVMC-LMX37. The red clean light keeps flashing. I have run water through the coffee maker, but it still flashes. I just need to know what I need to do to stop the light from flashing.


... Vacuums

I have a Hoover Steamvac model #f5888-900. Recently, after finishing use, it leaks a lot of water from the bottom of the unit onto the recently cleaned carpets. Do you know what would cause this spewing of water after completion of use?


Either the rod in the handle is holding and not releasing the resevoir asm, this where the tank sits on, is bad. So water is not being shut off completely when off. ... Vacuums

Just need simple instructions, can not find mine at the moment due to Christmas rush. Do I need to put warm or cold water in tank?


Hi,\015\012\015\012It doesn't really matter - the water is heated to the correct temperature inside the steam mop - so you can use either. It's recommended that you fill with clean cold water, but if you put warm water in, it will still ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

My Bissell carpet cleaner model #1697-W will not dispense the cleaning solution and will not **** the water back up--also need to know how you get to the belt on the machine?


The drive belt for the pump is located under a cover on the front right side as you look for the front of the machine. Just lift it up and the belt will be obvious. If it is not sucking then make sure that the dirty water tank is empty and that ... Bissell 1697-7 Powersteamer Pro Deluxe Vacuum

We own a Hoover V ac Ve Deep cleaner Model # 73502 02482 or F7425 - 950 Serial # 110200001908 and we are in need of a Clean Water Tank. Can you help us find one. Thanks


Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=575543\015\012Generic problem for all Vacuums\015\012We own a Hoover V\015\012Posted by dgodard on May 06, 2008 ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0979 seconds