Having problems with your Vacuums ?

The red light on my coffee pot is on and will not go off. I have run cleaner thru the regular cycle now what? Its a 12 cup programmable Mr. Coffee.

Answers :

I know this sounds like a pain but it takes a while toget that silly light to stop.\015\012Decalcifying your MR. COFFEE\302\256 Coffeemaker Minerals(calcium/limestone) found \015\012in water will leave deposits in your coffeemaker andaffect its performance. It's \015\012recommended that you regularly remove these depositsusing MR. COFFEE\302\256 Cleaner \015\012or vinegar. MR. COFFEE\302\256 Cleaner is available at manyretail stores or by calling the MR. \015\012COFFEE\302\256 Consumer Service Department at 1-800-MR COFFEE(1-800-672-6333).\015\0121. Follow packageinstructions to prepare one batch of MR. COFFEE\302\256 Cleaner. Pour the \015\012mixture into the water reservoir. Before decalcifying,remove the water filtration disk \015\012from the machine.\015\012NOTE: 4 cups or 20 fl. oz. of undiluted, white householdvinegar may be used as a \015\012substitute for the cleaner.\015\0122. Place an emptyMR. COFFEE\302\256 10-12 cup basket-style paper filter \015\012or MR. COFFEE\302\256 permanent filter into the filter basketand slide \015\012the brew basket in place.\015\0123. Place theempty decanter back in the unit.\015\0124. Press theCLEAN button until the CLEAN indicator light turns on \015\012(Figure 9). For your convenience the cleaning cycle isautomatic. \015\012The entire cycle will take 45-60 minutes to complete.\015\012 During thecleaning your coffeemaker will:\015\012a. Slow brewapprox. 3 cups of cleaning solution.\015\012b. Pause for 30minutes (the CLEAN light will remain on to alert \015\012you that the process is active).\015\012c. After 30minutes, your coffeemaker will brew the remainder of the cleaning \015\012solution.\015\012d. When complete,the CLEAN light will turn off and your coffeemaker will turn off.\015\0125. Discard the cleaning solution and rinse the decanterthoroughly with clean water.\015\0126. Fill the water reservoir with clean, fresh water.\015\0127. Place the empty decanter back on the coffeemaker.\015\012 8. Remove and discard the paper filter usedduring the cleaning cycle. If a Mr. Coffee\302\256 \015\012permanent filter was used during cleaning, remove it andrinse it thoroughly before \015\012replacing it in the filter basket.\015\012 9. Begin brewingand allow the full brew cycle to complete.\015\01210. Repeat steps 5 through 9 one more time.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The red light on my coffee pot is on and will not go off. I have run cleaner thru the regular cycle now what? Its a 12 cup programmable Mr. Coffee.

I know this sounds like a pain but it takes a while toget that silly light to stop.\015\012Decalcifying your MR. COFFEE\302\256 Coffeemaker Minerals(calcium/limestone) found \015\012in water will leave deposits in your coffeemaker andaffect its perfo ... Vacuums

I have a kitchenaid artisan coffee machine which is 15 months old just out of warranty. when you start to make an esspresso coffee the machine runs but no water is being pumped through the coffee to the cup you can hear the machine working but no coffee. Thanks Lloyd

Hello lloyd..... There are a few possible causes of this problem. The first is using coffee which is too fine a grind. The second is a machine which needs to be thoroughly cleaned. Most can fix those two areas themselves. The other causes have to ... Vacuums

Dirt finder I have a Hoover U6439-900.  After the cleaner was used a few times, the dirt finder light cycles between green and red on the regular setting and will not go to green.  On the sensitive setting, the red light stays on most of the time.  I have tried to run the cleaner to remove any dirt but have not solved the problem.

The sensor may be bad, or it may be coated over with dirt. Re,ove the hose at the back of the vacuum, the head of the sensor is down inside that opening, reach in there and clean it off and see it that corrects the problem, if not replace the sensor ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Sunbeam C30C manual - Sunbeam C30A CoffeeMaster 8 Cup Vacuum Coffee Pot

... Sunbeam C30A CoffeeMaster 8 Cup Vacuum Coffee Pot

My keurig platnium brewer is running slow like it clogged and its spitting the water back into the resivor rather than filling the coffee cup??? whats wrong??

... Vacuums

I have a Shark S3501 Steamer. No Steam Comming out. I have power,Heat but no steam.I tried all three heads to no avail. Is this like the coffee pots that you can run Vinigar (acidic acid) through to clean out the venturie?

Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it may not be getting steam to the head...Euro-Pr ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I just bought a Cooks 12 cup programmable coffee maker from JCPenney model # CM4221. When I unpacked it there was no instructions packed in the box. Can you help?

Hi,\015\012\015\012Sorry, the user manual isn't available online. This is a JC Penney own brand product and there is no customer service number available either. Take it back to JC Penney and demand one with instructions. It's brand new - ... Vacuums

My Tim Horton's (Bunn) Coffee Maker won't stop boiling the water really hard (to the point where it practically boils the full pot away). When I go to make coffee the next time it's boiled so hard that it doesn't give me a whole pot of coffee just like 3/4 of a pot, and if I haven't used it in like a day it's boiled it down to half a pot??... it's beginning to make me angry, as I have cleaned it in the past for this trouble, but it doesn't help or make a difference. Can somebody please help me??

... Vacuums

Need user manual for Farberware Milennium FSU236. How much coffee for 12 cups, 24 cups and 36 cups of coffee? How long will it take to brew 36 cups?

HelloOK, i am still looking for the specific manual for you model, but, at the link below you will be able to have a loo at a similar unit in capacity. Click ... Vacuums

When I put a k-cup in and it brews the coffee, it leaves coffe grounds all over the top of the k-cup and in the holder area and I get some in my coffee, it looks like the top needle is making too big of hole when it starts brewing(???)

Sorry to read about your problem, I hope this helps you out.I would follow the cleaning list below, I an addition you may have a bad batch of k-cupsplus just run some hot water, with out a kcup in the holder.\015\012\015\0 ... Vacuums

I have a probleme with my coffee maker model 81178 kenmore. He dosn't make his full cycle and the coffee is weak.I even put more coffee but it didn't change.It does that with all the coffee brand I tryed.The coffee is hot anough but weak. thank you Richard

Looks like you have a problem on the center tube. Check:\0121. It has the spring to press tube to the bottom of the device.\0122. It is clean with no obstructions.\0123. Water comes up frequently and each time more darker to the little cu ... Vacuums

Rival model CM1100 coffee maker: I can not get the coffee carafe in the right position. Should it lock in? Sometimes the coffee does not enter the pot and overflows onto the counter. Should the handle be on the left or the right or maybe the center? Please help me. I am not a coffee drinker and when I try to serve it to friends, I end up with an embarassing mess.

... Vacuums

When i make a cup of coffee with my kuerig coffee maker my coffee is coming out with coffee grinds though it. how can i fix this problem?

Your coffe may be ground too finely for your maker. \015\012Is your coffee maker flat-bottom or cone shaped? Or is it a french press?\015\012\015\012Your coffee needs to be ground according to the brewing method. Too coarse and it w ... Vacuums

My Discovery 4210 Roomba will run normally for about 20 minutes on a smooth, wooden floor. It then begins the following sequence: run forward a few inches, turn in a tight counter-clockwise circle a few revolutions, stop, power off a few seconds, power up, repeat cycle from forward run. The sequence can be repeated seemingly endlessly if I don't turn off the power manually. I've replaced the motor, and led revolution sensor system on the left drive wheel. I've blown the dust out of everywhere. A

This robot vacuum has a electronic micro processor that controls the unit and tells it how to operate and where to go based on programmed parameters. It's quite a technical marvel. I have dropped a link here for contacting the company tech support li ... iRobot Roomba 560 Robotic Vacuum

Went to turn it on after not using for several weeks and it states not ready to brew like usual but after about four minutes it just turns off. Wont let us brew a cup or access the menu even to choose size of cup or anything. It sounds like it's sucking up water to make cup and pokes hole in the coffee but nothing more than that. It is almost brand new

You have posted the fault in the wrong column with no instruction of the make/model.\012Assuming it to be new , Is it passed the warranty period before we take a look ,?\012Just lave it on for sometime and see if there is any change. per ... Vacuums

B77 Keurig coffee maker won't dispense coffee if k cup is in holder. Help?

I had the same problem with my Keurig coffee maker. The needle is clean, and no deposits. Above the needle is a check valve. This is a simple fix. Open the K-cup arm and look up, in front of the needle housing is two silverish screws. Remove them and ... Vacuums

We have a Starbucks Barista Aroma Grande Cat. #BA12 1200 W 120 Volts 60 HZ -- bought in about 2006. The lid to the coffee pot has a broken part -- little round plastic disc that when you press the little handle on the lid -- it allows the coffee to be poured. I would suspect we would need the whole lid to be replaced!! Can you help?

... Vacuums

Problem is you can have the maker plugged in but you can't manually brew the coffee. The switch will not engage to brew the coffee. Stainless Steel, Programmable Cuisinart CUI DCC 2000 model.

I have this model.I'm not sure if you mean if it won't brew manually or not at all.Ours failed because the thermistor failed due to the fact that the heater element was badly calcified (calcium deposits). It would come on for ... Vacuums

How much water and coffee is needed for a GE 42 cup coffee urn? Thanks,

Hi,\012\0128 X 42 = 336 ounces / by 128 = 2.625 gallons of water\012\0121 cup of coffee/10 cups = 4cups of coffee for the batch...\012\012heatman101 ... Vacuums

I need the manual for farberware fsu 236 coffee maker. How much coffee for 36 cups of water?

For medium strength coffee, start with about 2 cups of coffee. Adjust for taste in later batches until it's the strength you want. ... Vacuums

It'll bring the water into the machine but no water/coffee comes out in to the cup. I'm trying to clean it with vinegar, but nothing comes out. Keurig single cup coffee maker.

You have to use a lot of vinegar as it evaporates....this is a coffee maker right and not a vacuum? ... Vacuums

I have the same problem as steve967 The dyson dc16 is fully charged, runs well for 5-10 seconds and shuts down. I wait for a second or 2 and it runs again for 5-10 seconds. This will continue for numerous cycles, until I am finished cleaning. I have cleaned all the filters, and the power is good, The system will just not stay on. It is just over 2 years old. A friend of mine had the same problem with his Dyson DC16 after just a couple of months and has replaced his Dyson with a Black N De

Dear Michael_Stad,I am going to sound like a broken record but here is my same answer to another person with the same problem.I have I had the same problem with my Dyson DC16, where it only runs for a few\015\012seconds at a t ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

I have Nutone VX550C. Motor runs intermittently (cycles on and off rapidly--the light on the handle is blinking furiously) when I use the on/off switch on the hose. This happens at all of the wall connectors, so suggests a hose contact problem. Motor runs continuously when I turn it on at the switch on the wall unit.

The unit does have a switchs the PVC outlets, and it sounds like the hose mech to operate the switches is broken, and intermittently making contact. A replacement hose would likely fix the problem. Looked them up on the net, and they're not che ... Broan-NuTone VX550 Bagged Central System Vacuum

Hoover Windtunnel My Hoover Windtunnel is 3 years old. It worked great until yesterday when it lost all suction. I have followed the manual to trouble shoot any possible clogs and could find none. Then I noticed that when I remove the dirt collection cup and held my hand over the vent the suction is fine and strong. So... I replaced the hepa filter thinking that might be the problem. That didnt' work. The motor runs fine. The suction without the dirt cup inserted is strong. As soon as you insert

Either the hose has a clog, or the inlet down by the belt is clogged. Is there suction at the end of the hose, if not then it is clogged. If there is suction, then it has to be clogged down below by the brush roll, check that inlet. There also is ... Vacuums

How do I remove and clean the grinder on my Saeco v'spresso? It grinds and grinds then says the coffee beans are empty when they're not. If I finally get it to finish its cycle no coffee comes out and all the water goes into the overflow tray and/or the grounds container. I am assuming the grinder is completely plugged up and I tried to clear it out from the chute underneath but no luck...

... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0397 seconds