Having problems with your Vacuums ?
The iron keeps beeping and flashing red but does not get hot since i pressed the self clean button
Repair Help & Product Troubleshooting for Vacuums
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
The iron keeps beeping and flashing red but does not get hot since i pressed the self clean button
Keeps stopping. My Roomba Discovery says it has a full charge, but it runs for a few minutes, then stops and beeps and the status light comes on. If you press the clean button, it will start again and go for a few minutes before the same thing happens again.
Your battery isn't holding a charge ,buy a new battery ... iRobot Roomba Discovery SE Bagless Robotic Vacuum
Hi, I've a Tefal Steam Generator Express Turbo 2910. It won't "steam". The solenoid works when the button is pressed. The pump works. I've cleaned the tank (with white vinegar as recommended on this site!) thoroughly. The water from the steam tank is only "hot" (not scalding as I'd expect it to be). When first switched on and hot enough there is the TINIEST whiff of steam when the button is pressed then nothing more. Do you think this could be the Thermostat Part CS00094126, or can you
When I was putting my new rug shampooer together and the directions said to press the trigger and the clean surge button until I heard a snap, I did just that many times and never did hear a snap so I thought it had likely happened and I didn't hear it so I proceeded to fill the solution tank and get busy but no solution came out so I used the clean surge button instead and got the job done (I think). Can I continue to use it that way or is there a way I can get it to snap and use it the way it
My husband figured it out and it now works great! Thank you ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum
The power button on my scooba will turn on but when you press the clean button it will not beep or start to clean
... iRobot 5800 Scooba Vacuum
Eureka lightforce 300 poor suction, power paw doesn't spin and self cleaning duster doesn't clean its self when the button is depressed.
When this happens to me I do two things. The first is to empty the cannister but when you do (with the vacuum unplugged) stick your hand up inside of where the cannister goes.Sometimes that is filled with debris. Pull as much as you can out. There is ... Eureka 4718AVZ LightForce 300 Bagless Upright Vacuum
My roomba is about two years old. I have not used it very much. It has been on the battery charger all of the time. It had been awhile since I had used it and I pressed the clean button and it left the dock, but will only go in a circle and after awhile, t turns itself off and the on/off button lights up. Any suggestions?
I had this happen to my Roomba and it turned out to be a fried main circuit board. I called iRobot tech support to help get the diagnosis and they insisted on sending me a wheel module for me to swap in but that didn't work and when I called back in ... iRobot Roomba 560 Robotic Vacuum
I purchased a hoover windtunnel 2 model#u8361900 in Dec 2007.I am very disappointed because the self cleaning filter is not turning and particles keep clogging in that area. I have manually removed the particles but the filter will not turn.I also haven't been able to use the pet brush for some time.The cleaner has not been used hard about once a week since it was purchased.I am not happy that this product has stopped working effiently since purchased 6 months ago. Thank you Marcia Long Pottstow
The filter stands up right.the bottom goes in first then snap in the top.turn it by hand and you should hear it click if you have it in right ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum
My iRobot Roomba runs for about ten minutes, then shuts off. I can keep pushing the clean button and it will run for another ten minutes and stop again. Nothing seems to get clean.
Take the brush rolls out and you should see a copper disc. It is the dirt sensor. Clean it with Windex or some other cleaner. This works sometimes. ... iRobot Roomba 550 Vacuum
I keep getting errors on my roomba 560 telling me that I need to remove and clean the brushes. I reset it and it goes for about 2 minutes and beeps again (and the brushes look fine) What am I missing?!
Try also cleaning all the filters ... Vacuums
Water wont come out when handle pressed to do floor or out of nozzle for upholstery cleaning smells hot when trying to get it to work could this be a belt
Yes it most likely is the belt ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum
I just bought my edmark steam brush but didn't able to watch the guy selling it. Does the iron board really not coming hot? do I need to keep on pressing the steam button while using it? please somebody answer me/ thanks
After being on the charger for days and the green light is on I press the clean button. The Roomba leaves the charging unit and travels about 1 foot then the red light comes on and it beeps and won't do anything more the red light continues to pulse.
Buy a new battery ,the old one isn't holding a charge ... iRobot Roomba Discovery SE Bagless Robotic Vacuum
My dyson animal works for a while then shuts off...i guess it's getting hot and automatically turning off to keep damage from occuring. i have cleaned the filter and all the collection basket, but am still ahving problems. it was just services a year ago and a new switch installed. please help!!!
The belt that drives the beater bar may be broken or stretched, causing the motor to turn more freely, therefore causing the motor to rev beyond it's design.Jim ... Vacuums
EVERYTIME I PUSH THE BUTTON REALLY LOW TO ALLOW THOROUGH CLEANING IN THE CARPET, THE LIGHT DOESN'T TURN ON AND IT DOESN,T **** THE DIRT AT ALL.. IT ONLY WORKS IF YOU PRESS IT UP ONCE BUT IT DOESN'T GET ALL THE DIRT AND ESPECIALLY HAIRS.. WHAT HELP CAN YOU GIVE ME? THANKS
You need to replace the belt whenever the green brush indicator light goes out or is not steady. Be sure to observe the wear settings when re-installing the brush. The ends of the brush are marked with 1, 2, or 3 notches and numbers. In normal use th ... Kirby Ultimate G Bagged Upright Vacuum
Manual A friend of mine just cleaned out her garage and gave me a Westinghouse WST1600 vacuum that was rarely used. I purchased new #25 fuses and have had the battery pack plugged in for over 10 hours and when I put in into the vacuum and press the on button a green light flashes, but the motor does not start. Can I get this vacuum to work?
Here is a copy of the manual for your vacuumwww.thinkvacuums.com/pdf/uprights/Westinghouse-WST1600A.pdfWhat could be the problem is the battery could be shot after not being used for so many years that the life of the battery ... Westinghouse WST1600 Upright Vacuum
It won't keep a charge and it doesn't do anything but beep when I push the buttons to spot, clean and max.
What kind of vacuum is it. ... iRobot Roomba Discovery SE Bagless Robotic Vacuum
I can't get the vacuum to turn on. Its an miele electronic S3121. I keep pressing the power button, but nothing happens. is there a trick to it? thanks
... Miele Vacuums
My Scooba floor cleaner "check tank" light stays on even after it's refilled and everything cleaned but still will not work. It just keeps beeping at me when I try to start it. How do I reset it or get the light to turn off so I can wash my floors?
Flush out the solution valve with water (aka "prime the pump"). Use water, not just air, because water will clear any obstructions that may be in the lines. Also, rinse your tank through the four ports on the *underside*-- one round, two oval, one la ... iRobot 5800 Scooba Vacuum
Roomba turns in a circle then stops gives seven beeps when I press the button I have checked the wheels where can I get it fixed?
... Roomba Robotic Floor Bagless Vacuum
Press the power button on - good got a green light (new battery) press the clean button - got a green light iRobot runs for a couple of seconds and stops, then starts, then stops. After two or three times I now have a red light on for the Status. All of the wheels seem to be clean. I used compressed air to clean the underside. But still have the start stop problem.
How many times does the red light blink before it pauses? ... iRobot Roomba Discovery SE Bagless Robotic Vacuum
My roomba goes round in circles. sometimes it stops and moves a centimeter backwards and then again it goes round in circles. if you press the ,,dock'' button it goes back to the station. if you press the ,,clean'' button, again, it goes round in circles.... the machine is cleaned, the sensors aren't covered with dirt, the weels and brushes can rotate freely.... can anybody help me??? thanks in advance franz
Here's the link. IR Bump Sensor Fix ... iRobot Roomba 560 Robotic Vacuum
I have a hoover 3000 i have not used in awhile, and since I removed a large rug, I would like to use it again on my slate floor. HOWEVER, I cannot get it to pick up ANY water in the water recovery unit......it is dry, dry, dry. I have put in a new filter, cleaned the nozzle unit, the scrubber , and reconnected both the recovery unit and the water unit several times, but to no avail. I would like to get a graut attachment a well as replacement part, but since I can't get the basic unit to work, I
Have you made sure the plastic filter cover with the round hole in it that covers the filter is in place ( part # 59177096 ). This piece seems to get lost, and without it there is no pick-up. The other common problem is that the wheel assembly has be ... Hoover Floormate H3000 Upright Wet/Dry Vacuum
It will work-about 1 in 50 times of trying. when i put in a file and press MDR button it makes a whirring sound and the screen will say any one of several things e.g.no disc or corrupt file.If the data file is put in before machine is switched on-i then get YAMAHA MDF 2 and nothing happens when i press the mdf button.
The unit is basically a floppy backup machine. In your case the actual floppy reading unit has failed. Since this is a custom mechanism it means that the unit is pretty much dead - no replacement parts for it. If you are willing to try everythi ... Vacuums
I have a hoover mach 5 multi-chamber cyclonic vacum cleaner and it keeps getting hot and quitting.it's got a strong smell like something is burned when it gets hot also.
If its giving off that strong smell then the motor is bad. probably caused by not keeping the filters clean. on any bagless machine one has to clean the entire vacuum after almost every use to keep the unit operating correctly ... Vacuums