Having problems with your Vacuums ?

My gtech sweeper has broken down. It is an electric rechargeable one and it just has no power. We have changed the fuse in the plug. Help.Lost receipt so no entitled to warranty.


Answers :

It probably needs a new battery and it would just be cheaper to get a new vacuum
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My gtech sweeper has broken down. It is an electric rechargeable one and it just has no power. We have changed the fuse in the plug. Help.Lost receipt so no entitled to warranty.


It probably needs a new battery and it would just be cheaper to get a new vacuum ... Vacuums

X5 steam mop shorts all the fuses when I plug it in. I've changed the fuse.


Shorted to ground ... Vacuums

My dc 05 isnt working and i cant understand why , i have cleaned all filters etc and i also changed the fuse on the plug , which after i didi that it attempted to start but then jus cut out again so i thought the fuse had blown again , so i checked the fuse but its working fine could there still be a blockage somewhere in it or is it something electrical which means my dyson has to go to the dump :(


Most common cause of this problem is a wire broken inside the flex, usually either just where it leaves the plug (easy to fix) or at the other end (more of a problem). In either case, this is no reason to dump the machine - it can be fixed at a fract ... Dyson DC05 Cylinder Bagless Canister Cyclonic Vacuum

My vax essentials hoover, model number vec-01 keeps blowing fuse as soon as it is plugged in and turned on. Cleaned the filters and have changed the fuse 5 times


... Vacuums

My nilfisk action plus keeps stopping. it used to re-start if I drew in the lead and/or left it for a while but now it won't start at all. i have changed the fuse on the plug (not the thermal fuse), but that has not worked. can you advise?


... Vacuums

I have use my henry with no problem, tunred it off with the red switch on the top, 20 minutes later I went to use again but the machoine was toatlly dead with no power I have changed the plug fuse


Could be fault @ plug.. try cutting off 10 mm of cable then redo plug ..Replace fuse then try, if still dead try switch, you could short this out or if you have multimeter check for contact...if stii no action could be motor.... ... Vacuums

I have no power, I have changed the plug fuse so this is not the problem and I have cleaned all filters and emptied the cylinder. I have a Dyson DC08 animal (not the upright), can anyone help me?


... Dyson DC08 Cylinder Bagless Canister Cyclonic Vacuum

My hetty hoover is not working i have changed the fuse and tried a other plugs in the houseno power going to it can you help its about 20 months old


Check the switch with a ome meter ... Henry Numatic "" Canister Vacuum

Hi there, I have an electrolux mondo (375W suction) vac cleaner.I hoovered 1 room switched it off then when I tried to turn it on again nothing happened.I have changed the bag and the fuse in the plug but still nothing... fiona


... Vacuums

I plug my Polti in and absolutely nothing happens, no lights come on nothing, I've changed the fuse but still noting


There maybe a broken switch or the motor may be burnt out. Take it to a used vacuum store and they will give you sound advice. ... Polti Eco Pro 3000 Canister Steam Vacuum

No power going to hoover have hoover turbo power 3. Plug is sealed but have changed fuse. Have had builders in house using it to renovate bathroom. Do you think it is now passed its sell by date was working until they got it. It dosent even switch on. Am ready to do them an injury as my upstairs is a mess


A Neighbour fixed it ... Hoover Vacuums

MODEL:Dyson CYLINDER DC05 NO POWER: Have changed the plug fuse, still no power.


Hi its Darran at Dyson. It is difficult to confirm what may be causing this problem with having the opportunity to inspect the machine. We offer a repair service for £69 which is inclusive of parts, labour and VAT. ... Dyson DC05 Bagless Canister Cyclonic Vacuum

Kirby G5 I was using the hoover and just switched it off and turned it on again but would not turn on. I changed the fuse in the plug but still wouldnt turn on. what should I do?


See my troubleshooting guide and from there, you can view my do it yourself guides for fixing your Kirby. ... Kirby G5 Bagged Upright Vacuum

Have had to change the plug on morphy richards 1900 watt hoover model 71067. What is the fuse type/size for this hoover?


... Vacuums

Miele cat & dog vacuum will not switch on. I have changed the plug fuse to no effect. Could it need a new switch or some other part. There have been no problems with it but it is now over 10 years old


Its probably the power cord itself or the reel that draws it back into the machine. ... Miele Cat & Dog 326i Bagged Canister Vacuum

Stopped working hello im in france, so my henry has a two pin plug. i feel all that needs changing is a fuse, but i carnt find it. i have taken out every possible screw searching for it but to no luck. iv checked and cleaned wireing and checked cable for nicks. im now begining to think maybe the motor has gone?


Hi!  Sorry you've had to wait so long for a reply, but I've only just stumbled upon your problem.  You probably don't need help any longer, but here goes anyway!\015\012You will not find a fuse, because there isn't one.  If your Henry ... Numatic Henry Bagged Canister Vacuum

Hi. Tried to do toasts this morning but to my dissapointments it has refused to work. I changed the plug fuse- no difference, still not locking when pushed down. Any idea what it could be?


The heating coils or the contacts have burned out. It is a simple device and you can DIY. Open the panel and look at the switch that contacts when pushed down. This contact could be burned or dirty try to clean and set. \012Use a multimeter to ... Vacuums

Today i was hoovering, and then my dyson just cut out! i left it a few hours then went back to it, it gave a little noise when i switched it on, then again i tried but it failed to come on! ive even changed the fuse in the plug! and now my dyson wont turn on at all, ive cleaned everything there is too clean! help! :D


It looks like you need a professional repair. If you're really lucky this may just be a break in the flex, or the switch has failed - both relatively cheap and simple to sort out. More likely, though, is a problem with the motor (carbon brushes worn ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson dc04 pluged in but no power i have changed the fuse on plug stil not going


... Dyson Vacuums

Plugged my Dyson in this morning, switched it on and power came on for not even a second and died. No power what so ever to dyson - checked my house sockets, changed fuse. Still not working - dead as a door mouse. What could it be? Many thanks Sam


It is either your power cable, cable rewind mechanism or your motor. \012\012Try switching it on, and wiggling the lead near the plug and see if it fires up. If it does, remove the moulded plug and fit a standard plug. \012\012If not, lik ... Dyson DC08 Cylinder Bagless Canister Cyclonic Vacuum

Dyson dco5 Pulled the unit too hard to get extra flex. The plug is ok changed the fuse. I believe the cable has detached itself from the inside. How can i check the inside of the unit for cable damage


Hi.\015\012\015\012Try this site has manuals on replacing mains rewinder unit on Dc05.\015\012http://dysonmanuals.llc.nu/\015\012\015\012Chris.. ... Vacuums

House fuse box blows when you plug machine in.


There is a short in your vacuum that is cause your circuit to trip. It is more then likely a ground wire that has come loose in the plug that attaches to the motor of the vacuum ... Vacuums

I was given a model 6591, plugged it in and it worked but didnt "****" and didnt sound right. I turned it off and removed the hose from the back found a badly plugged hose. Removed the hair plug cleaned filters and when I tried to turn it on again. Now the motor will not turn on or even make a noise. I hear there is a fuse that can be blown? How can I find the fuse if there is one? Thank You Ron


The User Guide for the bissell Clearview Power Trak\012\012http://canada.bissell.com/images/UserGuides/3590C.pdf\012 ... Bissell 6591 Power Trak Revolution Bagless Upright Vacuum

My VX550CC also shuts down after about 15-20 minutes. My problem is that I can't find my sales receipt. Nutone told me after contacting them several times that they will not honor their warranty unless I can produce the original sales receipt only. Tech assist person was very rude about whether I actually bought it myself. We bought this unit when we moved into a new house 4 years ago and can't find the slip anywhere. Totally bad customer service and they won't honor their warranty even for a p


Some People Hu...........Make sure that all filters are clean if need be renew..Sounds like overheating fault resulting in Thermal cut out operating....Good luck ... Broan-NuTone VX475 Bagged Central System Vacuum

Does the trivac 1100 have a fuse? My machine has suddenly stopped.I have checked the fuses in the plugs and also made sure that power is at the wall socket. I can see what loks like a fuse holder in the top of the machine near to the on/off switch but it is very tight so I want to be sure that it is a fuse before unscewing it. Thank you Jim


... Philips Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0361 seconds