Having problems with your Vacuums ?

My Black and Decker Cycloen blender is flashing EE even after I have not used for a week....I have unplugged.....2 minutes plus...tried again....still flashing EE. Now hwat?


Answers :

Welcome to Fixya.

You may first want to check if the bowl is properly sitting on the driver wheel, or if the cover is ok. Also you may want to try out another power outlet.

Also, this blender automatically shuts off after 2 minutes for speeds 1 to 18 and after 20 seconds for the PULSE and CRUSH functions. If this occurs, the LED display shows "EE"; unplug the unit and wait 30 seconds.

Thanks for using Fixya.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Black and Decker Cycloen blender is flashing EE even after I have not used for a week....I have unplugged.....2 minutes plus...tried again....still flashing EE. Now hwat?


Welcome to Fixya.You may first want to check if the bowl is properly sitting on the driver wheel, or if the cover is ok. Also you may want to try out another power outlet.Also, this blender automatically shuts off after 2 min ... Vacuums

I have a Sleeptight Imetec Electric Blanket with timer and Dual Controls one for each side of the bed recently the timer was set for 45 minutes and when 45 mins elasped it went off and the control light began to flash which is normal however it is since stuck in this mode light flashing will not heat just keeps flashing is there any way of sorting this the other side of the blanket for the other side of the bed seems to be ok although it did the same thing but reset itself any ideas Regards


... Vacuums

The one of the controllers for the electric blanket keeps flashing an "e". The other controller is fine. We switched controllers and the same thing happened. We have unplugged the blanket for several minutes and turned off the controller for several minutes. It always goes back to displaying the "e". It is a warmspun blanket and I cannot find any information on the company so that I can contact them to see about the 5 year warranty.


I did some searching-- and I came up with this Linkedin page-- seems to have some information-- Let me know if it helped-http://www.linkedin.com/companies/jla-homeMack B ... Vacuums

Err5 When charging the battery, it starts out flashing amber, but after several minutes it turns red and the err button flashes five times. The troubleshooting says to hold the buttons above and below the power button for ten seconds and this may resolve some software issues. I tried that but it goes back to the amber light then red again. I replaced the battery hoping that was the issue, but it still does the same thing.


... iRobot Roomba 530 Robotic Vacuum

My Dyson DC28 works fine for a minute then it's like if the brush head gets too much resistance it quits spinning and the light starts flashing. When I turn the vacumn off then back on it's f


Hi Gayle,I'm sorry to hear you're having difficulties with your DC28. From what you've described, it sounds as if you may have the brushbar set at a level too low for the type of carpeting you're cleaning. If you select a higher carpet settin ... Dyson DC28 Animal Bagless Upright Vacuum

Roomba 4110 run for 1 minute & stops no beep just flashing clean light.


... Roomba Irobot 4110 Floor-vacuuming Robot, Sage

My i-robot spins first to the right, moves back a little, then spins again. after about a minute it stops the red light flashes it says oh oh and beeps nine times. how can i fix this?


Hey\015\012Please look for other same problem posted here \015\012;-)\015\012You are probably \015\012facing a bumper sensor issue.Try to clean the bumper first and if this \015\012goes on, either call iRob ... iRobot Roomba 530 Robotic Vacuum

I have an older Wega 2 group espresso machine. Looks like a date of 1992 on the group head, but not sure. This has no model name that I can find. Anyway, when I turn it on I get all lights flashing after it heats up 5 minutes or so. I do get nice steam from the wands. I drained teh tank and found a little scale, but not much. I took apart the group heads and cleaned them thinking it may be a clog there, but that doesn't seem to have worked. Also fwiw the water level float is not visible and whe


For a new fridge, need more time to maintain the required temperature of the fridge abut mainly the goods in it? So everything seems normal. The time will be reduced day by day since the goods will stay for longer time in and door opening will bec ... Vacuums

Roomba 535 runs in circles for a couple minutes then quits and red light flashes


... Roomba Robotic Floor Bagless Vacuum

Irobot discovery Hi, My irobot discovery charges fine, shows green (fully charged), starts running and flashes amber, then finally after about ten minutes stops and shows sold red.


It sounds like the battery is shot. These batteries only work for a couple of years and then they won't accept a charge any more. A common mistake people make is recharging them before they need it. This will make the battery "lazy"\015\012Cont ... iRobot Roomba 4210 Bagless Robotic Vacuum

My roomba 530 runs in a circle and does not move forward. After 2 minutes it stops with 11 beeps and a flashing red light to the left of the power button. It has no clicking noise. Does anyone know what is the problem?


Hey'\015\012This means Roomba is not registering obstacles. Roomba may be stuck in one place.\015\012Roomba may be in extremely large room, try setting up virtual walls to create smaller area.If Roomb ... Roomba Robotic Floor Bagless Vacuum

My vaccum cleaner, hoover model uh30010 stop after one minute


... Hoover UH30010COM Bagged Vacuum

Backs up spins in circles, then red light flashes and beeps


Hi, Your Roomba is experiencing the 9-beep error. This is caused by a bad component in your bump sensor. It pretty much is constantly sending a bump signal to your Roomba, which is why your Roomba keeps going backwards and circling(and never goes for ... iRobot Roomba 500 Series Virtual Wall Lighthouse 80201 Robotic Vacuum

Roomba goes a few minutes after a charge then stops


You can try cleaning the battery and charging contacts with some rubbing alcohol or contact cleaner, but its also possible the battery has reached the end of its service life. ... iRobot Roomba 560 Robotic Vacuum

I have lost my manual for the Mr. Coffee Maker - Model BVMC-LMX37. The red clean light keeps flashing. I have run water through the coffee maker, but it still flashes. I just need to know what I need to do to stop the light from flashing.


... Vacuums

I HAVE A BRAND NEW HOOVER MACH-3 CYCLONIC THAT CUTS OFF EVERY FEW MINUTES. IT IS DRIVING ME CRAZY! IT'S LIKE AFTER 5 MINUTES OF VACUUMING IT HAS TO SIT FOR A LEAST AN HOUR THEN YOU CAN VACUUM FOR ANOTHER 5 MINUTES. HELP!


If it were mine and it was brand new I would bring it back and exchange it. It sounds like the motor is over heating and shutting off automatically. Does not sound good. My advice return it. ... Vacuums

My eureka optima vacuum shuts off after 5 minutes of use, the brush still spins, but no suction. If I wait 30 minutes, it will work again, for 5 minutes.


... Eureka 431A Optima Bagless Upright Vacuum

We just purchased a Miele upright s7000. I vacuumed for 5 minutes (literally) and it completely shut down. Waited the suggested 30 minutes for cool down, but nothing happens. Waited another 30 minutes and still nothing. My husband checked for clogs according to the manual but still nothing at all. Is it just a dud?


... Miele Vacuums

My Shark vacuum sweeper will run for 10 minutes and shut off. After it sets for 15 minutes it will run for 10 minutes more.


If it runs on NiCad batteries it probably has programmed batteries which can happen, best solution, get new battery, and use til dead before recharge, every time. ... Vacuums

Hoover zoomi stops working after 15 minutes vacuuming, and takes at least 30 minutes to turn back on?


... Hoover Vacuums

I have a Dyson DC28 animal vacuum and the beater brush will not turn. It has one flashing white light and a red flashing light.


It appears that the drive belt is not adjusted properly or has stretched. THe gunk that vacuums pick up can also affect the belt in amking them too slippery to drive. Check it out. ... Vacuums

Dyson shuts off in 5 minutes, then starts up 2-3 minutes laters w


I think there's a good chance of a clog that you haven't found. On the Dyson it's fairly easy to remove several covers that give you access. From the collection canister is a tube that runs toward the base. At the bottom of the tube you can remove a ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Our machine works 3 minutes - and then 10 minutes it does not


The usual suction problem with these things is related to a clogged lint filter. I had the same problem as you with my carpet being completely soaked. Try checking the lint filter. It is located in the top clear plastic section (the one with the d ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Electrolux oxy 3 vaccum has stppoed working and all three blue lights flashing My electrolux oxy 3 ZO6330 stopped working suddenly and all lights are flashing. I've changed the bag and filter and its still not working. Any ideas??


... Electrolux Vacuums

Roomba red status light is flashing and i cant power it on. battery is fully charged and when placed on the charger it does not indicates anything, just the red flashing status light


... iRobot 4150 Roomba Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0248 seconds