Having problems with your Vacuums ?

The clear water tank/ detergent mix, a valve sticks open. What can I do. I have to reset it with a long wooden spoon. Any ideas ??


Answers :

Empty the water from the tank. Coat the seal around the valve with petroleum jelly. Open and close the valve with your wooden spoon to get it coated really well and try refilling it again with water to see if it solves the problem.

If it doesn't, contact the maker to purchase a replacement valve and/or seal kit.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The clear water tank/ detergent mix, a valve sticks open. What can I do. I have to reset it with a long wooden spoon. Any ideas ??


Empty the water from the tank. Coat the seal around the valve with petroleum jelly. Open and close the valve with your wooden spoon to get it coated really well and try refilling it again with water to see if it solves the problem.If it ... Vacuums

After a brief power outage my Marantec 4700 garage door opener has problems opening/closing. When opening it stops at the fully open position and the lights blink, when closing it automatically reverses just as it fully closes and then the lights start to blink again. I checked for obstructions and tried to reset the limits of travel per the manual, it still does the same thing. Any ideas on what to try next?


This is not a sensor issue, I have a similar problem, sensors work fine, garage door is still fully functional, all operations, including safety sensors work properly, just the overhead lights flash. I suspect there was damage to the power board due ... Vacuums

I have a Morphy Richards Grime Buster 2200 and the cap on the tank turns but will not open. I cannot find the manual to check out any possible trouble shooting advice. Any ideas would be most gratefully received, thank you.


DId you find a solution? I cant open mine!!! ... Vacuums

I have a raynor flight star garage opener. Had a lighting strike 4 days ago. All power is good. The opener even has a little green light on the switch that is attached to it. However the opener is not responding. Is there a way to reset on the motor by taking off the housing? I don't see any reset button on the out side of the housing.thnx w


You could always try unplugging the unit and plugging it back in. If that doesn't work the logic board is probably fried and unfortunately there is no replacement available for it any longer. You would need to buy a new opener. I'd recommend Liftm ... Vacuums

I have Pro Safe PSF80 and everytime I enter my password, the lights are blinking and can't open the safe. Since the only way to reset my password is when the door opens, I cna't reset it either. I need yuor help, how to fix this problem.


2 blows with a pickaxe on the hinge and it was open in less than 1 minute ... Vacuums

I shorted out the light socket on my Chamberlain Professional Garage Door opener. Now it wont open, I am looking for a fuse or reset button, but cant find one. Is there a way to reset it or did I fry the solinoid


First check your house fuse. ... Vacuums

Automatic shutoff red ball in recovery tank rises to top when recovery tank is about 20% full.Thus we are only able to use the steam cleaner for about 2 minutes before having to empty the recovery tank. Ideas to resolve ?


Your cleaner should have a foam sock around the float cage in the recovery tank. Remove the foam sock and rinse it out with clean water. If these are very dirty, they may cause the airflow to be disrupted, causing the float to raise prematurely. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

S3501 unit is hot but no steam is coming through the tank opening going into mop head. i have cleaned the opening and used a wire to insure the opening is clear.


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it may not be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

How to open water tank to fill.


... Oreck Sanapathic DMS2000 Handheld Steam Vacuum

Hi there. My coromaster 2000 has lost its limits. The travel on the opening mechanism is about 100mm each way i.e. the limits for opening and closed position have to be reset. How is this done. On back of motor there is a micro switch which has to be pressed to set limits. What is the sequence of pressing and activating. Thanks a ton I really look forward to hearing from you Cheers Graham


... Vacuums

I have bought a house with a Bricard electronic wall safe which might be useful but which is locked open (ie the locks are out but the door is open). I do not know the pin code and there does not appear to be a manual. Any ideas on how I can get this back into working order?


... Vacuums

My tank foamed up into the motor and now the rainbow won't come on. Is there a reset button for the motor somewhere? Will it dry out and reset on its own?


Reset switches are generally for use after a motor has shut off due to overheating. They don't do any good for resetting a motor that has gotten moisture into it. Moisture in a motor will quickly ruin it. Allowing it to dry out on it's own will ju ... Rainbow E series Canister Wet/Dry Vacuum

I have a bissell quickwash 1950-e. I bought it Jan. 2006, and have only used it 8-10 times, I live in a very hard water area, so I though if I put some vinegar in with the cleaning solution it would get rid of any hard water deposits, unfortunatly the solution went lumpy in the tank and stoped spraying out water, I have opened it, hose clean, sprayer not blocked, x at bottom of water container when depresed water trickles out, component that opens the x when water container placed, also ran wate


Hard to say what is causing your problem, replacing the cap and insert on the water tank may help, part #2041111, even tho it may trickle out water when depressed, they can still be bad. The other thing would be the rod not relesing the water like i ... Vacuums

Bissell Pro-Heat 7901-1 no cleaning solution is pumped out. The flow indicator is spinning and the belt is spinning the beater bar. Have cleaned the flow indicator, checked vavles in the solution tank and water tank and they are working properly. Also checked the trigger to make sure it works okay. Any ideas?? Moody Fan


Bissell Pro Heat shampooer - Fill the soap dispenser with extremely hot water and shampoo with only water for a few minutes. There is often dried soap in the lines. Make sure that all filters are clean. Press the soap container and the water conta ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

My e wave microwave appears to be in fine working order until the door is opened. It then trips the breaker and ceases working. Ater the house breaker is reset, the power is restored to the microwave until the door is opened again.. I havve tried plugging the microwave into another area that is on a different power breaker but again the breaker trips and the microwave ends all functions. Have you any solutions to my problem? Email Address [email protected]


You may have a short circuit on the INTERIOR LIGHT BULB circuit in your microwave.\015\012\015\012This might explain why the breaker trips every time you open the door.\015\012\015\012If so, you would have to unplug and disass ... Vacuums

Bissell ProHeat 2X - I removed the clean water tank bladder and now I can't figure out how to attach the insert from the bottom of the tank so I can put it back together. Any ideas? Make sense? :)


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have a sandleford safe S201045 the 4 diget code now wont open it and the key wont open it either any ideas?


There is no known trick to open this safe. The best option was the key but since it is not working as well, call Sandleford. Here is their contact information. ... Vacuums

I have an electrolux central vacuum in my house. My central vac hose has something stuck in it, I think, maybe a sock. I tried to put a long dryer wand down it but the hose is just too long. Does this need a repair man or new hose?? Any idea of a way to blow it out? Thanks.


The best way to clear an obstruction is to blow it out by attaching the wall end to the exhaust of a shop vacuum, or using an air compressor.\015\012You can try holding the wand end of the hose directly to the CV in port and turning the machine ... Electrolux Central Vacuum

My Electrolux Regency Series upright vacuum brush motor does not activate. Cleaned the brush and press reset to no avail. Opened handle switch assembly and checked each wire attached to all three switch settings. Tried disassembling brush assembly but could not pry open after removing all screws.


... Electrolux Vacuums

My lux 7000 has a new bag but when i start to use it with the power unit or without the unit shut's it self off i can reset the lites or the motor if you will by clicking the on off switch 4or 5 times and i'm ready to go again untill you start to work and off it goes you can repeat the switch thing as long as u want, it just won't let u vacuum ,it turn's it self off .I blew it all out but found nothing in it. if u don't try to vacuum it will run as long as u want to listen to it. Can you


Have you replace the afterfilter? It may also cause this if rather dirty. It's located under the tool caddy/air diffuser on the back half of the machine.\015\012Try this: Disconnect hose, turn on vacuum. Does it continue running? If so, pl ... Electrolux Lux 7000 Bagged Canister Vacuum

I opened the cannister to change the bag and when I closed it the motor switch will not turn on. The second position which turns on the attachment for rugs still comes on. We thougth it was the switch so we ordered the part and it is still doing the same thing. Is there a reset button somewhere inside? The only reset button I see is on the attachment which is working.


It can be a few things. First check the overload protector located on top of the canister. If it has tripped the unit will not run. Push it in to reset. \015\012If that is the problem check the motor safety filter to see if it is clogged and caused t ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

I HAVE TRYED TO CHANGE THE CODE BUT NOW i CANT OPEN THE SAFE, HOW CAN i GET IT OPEN?? how can I reset a medalist electronic digital safe?


I tried to search for the manual or guide of your Medalist Electronic Digital Safe but I cannot find any. Most electronic digital safe has a small rubber hole plug either near the keypad or at the bottom of the door. Check your safe and s ... Vacuums

Nothing spraying out of Bissell Powersteamer Proheat. I've check filter under flow indicator, pump belt is fine, cleaner in proper tank, bladder of water tank is full. We've had it for a very long time but it's barely been used. Can anyone help?


... Bissell 1698-1 PowerSteamer ProHeat Plus Upright Vacuum

Trouble opening tank, pushing handle and it wont open


Push down on the handle while lifting the right side of the tank with your other hand. ... iRobot 5800 Scooba Vacuum

I lost the detergent container on my Hoover Model F7220-900. Its a small plastic bottle that sits on the back of the clean water tank. I called the help desk and they told me that they no longer make that part so I have to pay $55 to replace the whole tank which will come with a detertent container built in. The whole carpet cleaner was only worth about $225 new. I don't feel I should have to pay $55 for a part I don't need but the machine is worthless without it. Any good ideas to solve th


... Hoover F7220900 SteamVac V2 Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0521 seconds