Having problems with your Vacuums ?

When I turn the ac on it keeps going to heat by itself. I tturn it on to 60 aand it shoots to 90 by itself


Answers :

Hi,
I would look for wires that are shorted together in the thermostat wiring..it sounds like you are getting power through to the heat wire when you should not be...
Unhook the "W" wire at the furnace or air handler and that should shut down the heat for now till you find the problem...

heatman101
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

When I turn the ac on it keeps going to heat by itself. I tturn it on to 60 aand it shoots to 90 by itself


Hi,I would look for wires that are shorted together in the thermostat wiring..it sounds like you are getting power through to the heat wire when you should not be...Unhook the "W" wire at the furnace or air handler and that should shut do ... Vacuums

Roomba Discovery Roomba is fully charged and cleaned with sensor wiped clean. When turned on it it sounds normal and commences to go, but it then acts like it is putting on the breaks, spins, tries to go and manages a short distance and breaks again, just not making any progress because it keeps breaking after a foot or so and turns and tries again. Sometimes is gets so stuck from moving forward at all, like it is stuck in one spot just trying to go while seemingly surrounded by barriers. Somet


I had the same back-up, turn, move forward a couple inches, backup-up, etc. problem. Try cleaning/cutting the hair, etc. out from around the brushes, as well as around the ends of the brushes. Also, try a Q-tip to clean out the four pair of sensors ... Roomba Robotic Floor Bagless Vacuum

My irobot starts out running fine and then it will turn and slow down as if something is keeping it from going. all at once it will go full speed again. it does this until finally it stops and the red status light comes on. I just replaced the battery 6 months ago.


... iRobot 4296 Robotic Vacuum

I have a new Kenmore magic bued and I am about to change bags for the first time. Trying to do this the clip that is supposed to hod the bag close to the whole keeps coming off when I replace it and close the lid, turn on the vac the sucction is very low and it keeps showing the bag is full which is not true / what is going wrong here ? Thanks so much for supporting, Beba


Sorry to hear that you are having problems with you Kenmore Magic Blue.There is a so-called "bag full indicator", which will only turn red if it got some major blockage. This is the reason why there is no power suction.The "fu ... Kenmore Magic Blue 24195 Bagged Canister Vacuum

Runs but doesn't vacuum/****. Sidebrush works fine. Cleaned the roller brushes, and that seemed to confuse the robot and now it keeps going backward a few inches, turning, and then starts going backward again.


Sounds like a sensor problem. pull and clean the front black/white caster assembly and the revealed movement sensor and the 4 cliff sensors along the bottom of the front. Make sure the front caster wheel turns freely. You may have to remove the rolle ... iRobot Roomba 560 Robotic Vacuum

I installed a new battery in my Roomba 540. It charges and runs directly with power cord but will not charge on dock. When I push the dock button, it acts like it "sees" the dock and approaches it and even slides on, but then gets back off again and just keeps going back and forth until I turn it off.


... Roomba Robotic Floor Bagless Vacuum

I have a ge light switch receiver rf1023, with incandescent bulbs, and when I try to switch it on it just blinks once and goes out. if I hold the switch on the battery-operated wall remote, the lights keep blinking until I let go. It used to work fine, and now it doesn't. I've lost the intallation instructions, so I don't know if there was a trouble-shooting section that covered the problem.


... GE Vacuums

I have an Electrolux LE canister. It runs for about 2minutes then shuts off for about a minute , then turns on again and it keeps repeating this routine!!! It is driving me nuts. What part do I need to replace? Apparently it is over heating. Please help. Thank you.


The LE has a thermal cutoff. If the bag is overfilled or a bag breaks and clogs the bag chamber the vac will over heat. This also happens if the hose, wand or neck of the power head is obstructed. Try dropping a coin through the hose, look thro ... Vacuums

When you turn on the machine the light goes green,I then switch the lever over on the top to red for a hot drink,the machine makes the noise and you think its going to make your drink but no water comes out,My son brought it for xmas last year and didn't think to keep the reciept. thanks lisa


Turn off ... Vacuums

Your reply I received your reply of "Unplug the unit or turn off the circuit breaker. How is this going to help me trouble shoot what is wrong with my unit? Was there more to your message that I did not get?


... Broan-NuTone CV450 Central Bagged Central System Vacuum

I own a Sanyo 35s 3.5 Rice cooker that has stopped cooking and heating. Power is going to the unit power light comes on. We have checked to make sure that the unit was turned off before unplugging as per the instuctions. Unit was new in Feb 2010 and well taken care of. Anything we are missing here?


If you have been washing or scratching the inner pot with something sharp or harsh like a metal spoon or hard sponge it could cause that and even electric shocks. try changing the pot ... Vacuums

We have a zenith dehumidifier model ZD300 & the bucket full light keeps flashing. the percentage number wont go higher than 1%. we have turned it off/on & unplugged it. When we do this it will reset to 40% for about 2 seconds & then goes back to 1% & the bucket full light starts flashing again. The bucket is empty & we have cleaned the filter. We have only had this dehumidifier about 7 months. Please help us.


I've had the same issue with mine. I am a 12 year refrigeration tech. I checked the float switch which would normally cause that indication light. However manually pushing the switch and then checking it with an electric meter that was not the case. ... Vacuums

When you turn the sewing machine on it constantly keeps on going almost like you have your foot on the pedal all the time the machine is a contessa 410 model


The foot pedal controls the voltage to the machine. If it is running to fast then the foot control is bad ... Vacuums

I robot rumba- does not go forward, keeps backing up and turning


Sounds like one of the cliff sensors has gone bad. I think your options are to send it in for repair or buy a replacement sensor and swap it in. \012\012Good luck, \012 immorion\012check out robotreviews.com for detailed walk throu ... iRobot Roomba 560 Robotic Vacuum

Kenmore Canister Vac, Progressive, 25512 255513 model. Brush won't turn. One end of the brush roller, end closest to belt, is off center which is keeping it from turning freely. The end cap is like a square. Other ends turns fine. Do these end caps come off? If so how? Can't get it to budge. This is exactly what is keep brush roller from turning.


Take a flat head screw driver and pry the end cap off. It will come off. You might have some string or hair around it causing it to not turn. ... Kenmore 25512/ 25513 Progressive Canister Vacuum

My dyson dc17 turns off when its upright, so when I go to use the attachments it doesnt turn on unless I go to vaccume the floor. whats going on?


Hi there,I'm sorry to hear you're having difficulties with your DC17. Your issue sounds unusual, and we'd appreciate the opportunity to help resolve it. Please call our Helpline free on 1-866-693-9766 - or if you'd prefer, you can email your ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Roomba keeps going around in circles


Dear Roomba Owner,\015\012\015\012For solutions to your Roomba Vacuum Problems click on the following link @ ... iRobot Roomba 530 Robotic Vacuum

My Pasquini Livia 90 S/E will not stop heating water. This builds up too much pressure. I have unplugged the machine and let it cool off and turned it back on and got the same result. I can relieve the pressure by opening the steam valve, but since the heating element does not turn off it builds up too much pressure very quickly


Your thermostat is failing. Given the initial price tag, look at your warranty options first. If you are out of warranty, then lets proceed.Since there is not a parts / assembly diagram to be found, you will need to disassemble your esp ... Vacuums

No suction Just received my refurb. dyson animal bagless. Finally figured out how to get it all together, turned it on and there is no suction coming up thru the beater bar. The hair is just collecting around the bar and not going up into the canister. It appears all the suction is going thru the open red end of the attachment hose, which has a vented cover piece. Am I missing a piece or is there a switch to turn of the attachment suction?


So the red hose isn't connected to a part on the vaccum so like it is connected to the connester but not to an opening just above the beater bar, this is the only idea i can supply you with. good luck, maybe i got lucky and helped you out. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

I have an electrolux Enviro multi steamer which I was using this morning. I turned the steamer off for approximately 1 1/2 to do some shopping, and when I turned it on again, the steamer light turned on (green light) and then I waited for the orange light to go on, which too a while. When the orange light does turn on, there is no steam when you press the yellow button on the handle. I have checked for water, and the steamer is full, I have turned it on and off several times just in case that wi


Problem fixed itself. Turned off for couple of hours so unit can cool down completely and when I turned it back on it started working again. ... Vacuums

The Vaccum is not turning on when i plug the hose into the wall. The hoover system will turn on when i turn the switch on at the base and wont go off till i turn the switch off. But it will not come on automatically when i put the hose in to the wall connections. Many Thanks Linda


You can test this out by taking a small metal spoon and with the bottom side of the spoon insert it into the vac outlet on the wall. you want to touch the two metal pins inside the vac outlet to test if the unit is the problem or the hose is the prob ... Beam Industries Vacuums

Infinity Vaccum by Shark, model number NV31COS, will not start. The vacuum was running just fine until it grabbed the edge of a curtain. Turned it off to release the suction. Turned it back on and was working fine. About a minute later the vacuum was making an odd noise. Every 2 seconds or so it would "heave" (lack of a better word) then go away, then come back and so on. Turned the vacuum off and checked for blockage, none that could be seen or felt, and now the vacuum won't turn. Any suggestio


Carpet brush won't turn when vac on ... Euro-Pro NV31 Infinity Vacuum

I have the euro steam blaster s3325 when I turn it on, the steam ready **** comes on right away not heating can the heating element be replaced? thanks


There is a device attach to the heating element called a thermo fuse, this devise brakes down when it get to hot.open the machine and replace it with the same value. it is written on it.. ... Euro-Pro S3325 Handheld Steam Vacuum

Dyson, pressure release valve keeps going off and staying open.


There are a couple of things you can do, the blled valve (pressure valve) activates when there is a blockage in the machine. You just need to find the blockage:\015\012\015\0121) To check for blockages from the bottom of the machine. Remo ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Roomba turns in circles going one direction and then another but can not go forward in a straight line. Aftter a few moments of going in circles, it cuts off and says inspect and clean roomba's wheels. We have done that 5 times and to no avail.


... iRobot Roomba 530 Robotic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0883 seconds