Having problems with your Vacuums ?

I recently bought a chefmate racket bug zapper from target, but can't seem to get it going. I pressed the buttons over and over so it would make it's high pitch sound and then i would know it was charged. never happened. what do i do next? I don't hear anything happening but do see the green light on. can you help?

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I recently bought a chefmate racket bug zapper from target, but can't seem to get it going. I pressed the buttons over and over so it would make it's high pitch sound and then i would know it was charged. never happened. what do i do next? I don't hear anything happening but do see the green light on. can you help?

... Vacuums

Sponge filter I have a kirby sponge filter for my Sentria shampoo system and dont know where it goes. It stop working and making foam. Kirby sent me the sponge filter saying this is what i need and i would know where it goes. I dont nor kind I figure it out. please help!!!!!!!

On the end of the shampoo tank where it attaches to back of motor where the bag is normally attached ... Vacuums

The battery will not charge in the sweeper. I can remove the battery and wire it to the power supply for charging and it will charge up and run the sweeper. So the power supply and the battery are both good. Obviously there is a circuit failure in the on board charging control. Anyone know a fix or a likely faulty component? I had a shark handheld about 8 years ago and it developed the same problem. I examined the little circuit board inside but saw no visible indications that would isolate t

... Euro-Pro Cordless Bagless Upright Sweeper - Blue/Gray

I am currently unsure, it my Dyson DC16 battery is charging as it should. I read all the posts about Powersupply voltage of 28V and defective PCBs. I now need to know from someone who's DC16 is working properly what voltage the battery should have when it is charged. I currently only measure 24.2V in mine. Supposing there are 6 batteries in there with nominal 3.6 voltage each, which would add up to 21.6, I supposed one could charge with up to 25.2V (4.2*6) and once reach lower the voltage ke

Does it stop working real fast ? ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

I have a 2 year old Electrolux ergorapido cleaner that gets used daily for about 2/3 min, the blue light on the stand comes on when the cleaner is put on to charge but fades after about 5 min & the batteries dont charge, would this be a faulty ac adaptor or worn out batteries

No, not worn out batteries.For my experience, if the batteries were worn, they would charge with the blue led being on and after that, the vacuum wouldn't hold his charge. just that.This is a different problem. Check the contacts between the ... Electrolux Vacuums

I bought a new Bush MP2200BUK 2GB MP3 Player today and havent a clue how to download music from my laptop to my mp3 player and donw know if i have installed it right nothing is happening and dont know if i can download music from my frostwire (music download)

Does anybody know where i can get a new front cover for my 8gb bush mp3 player ... Vacuums

The hand held dyson does not appear to charge. does the battery come away from the unit as I can't seem to release it? Would there be any point in buying a new battery as I don't know if this is the problem. The red light stays lit all the time it is on charge and when I take it off the machine does not respond at all.

The battery is located at the bottom of the handle. To release it, press and hold down the button on top of the battery case (it has 3 ridges on it). That releases a catch and you can then slide the battery out to the rear. This can be quite ha ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

I have the brother Ls-2000 sewing machine i threaded the top as well as the bobbin but when i try to sew the thread gets stuck and it bunches up and tangles in the bobbin. also the little bit that did sew was tight stitches on one side of the fabric but very loose on the other side I followed the instruction and it keeps happening i need help i dont know how to fix it please help me

Adjust your tension.You probably did not wind your bobbin properly as well.Make sure you oil your machine every month or so and make sure your bobbin is seated properly before you sew.\012\012Go slower with the pressure foot speed and use the r ... Vacuums

I never recieved any manual with this product that i order on October 07 /10 it would be nice to know what part to us for what section of the floors thanks

Hello. Go to this link http://www.sharkclean.com/cgi-bin/livew/site.w?locati ... Euro-Pro Upright Steam Mop - Metallic Lavender

Undefined light is on where it says controls are locked......this has never happened before & I do not know how to unlock it.....I tried throwing the breaker switch but that didn't work.

What make and model? ... Vacuums

This was my grandmothers machine and when she passed there was no owners manual so I am not sure how to use the settings on it or oil it properly. I so want to use it cause it was hers but don't want to mess up the machine. She never even got a chance to use it before she passed away. I just have no owners manual. I know how to use sewing machines but this one is older and I don't want to mess it up. this was passed down to me. and a manual would help in so many ways. even if it was sent in a

May I get the manke and model # so I can help you more ... Vacuums

I have the IROBOT discovery that just got a new battery. IT ran great! As the battery was dying, I put it into the home base. The "brick" is green, the home base has two green lights and the on/off pulsates red. It never charges though. Eventually the red light stops pulsating. Customer service said to reset it, clean the metal, and nothing works! They told me to just buy another one. The problem is that I know it was working! Help!

The best thing that you can do is take the charger into somewhere that can test it for the proper output voltage. It should be somewhere very close to 22 volts with no fluctuation. The charger is the easiest thing to test in this case. ... iRobot Roomba 4210 Bagless Robotic Vacuum

Power nozzle of my S3670 does not work (vacuum itself does work), the headlight bulb in the nozzle is broken. This happened in the past several times - we would bring the vacuum to service center - I don't know what they did other than replacing the bulb. I decided to go to ACE and buy replacement bulb myself, replaced the one in the nozzle - this did not fix the problem. I don't see any fuzes or anything in the nozzle. However, the manuals says to "Use only HOOVER part no. 27317307, which is a

... Hoover S3670 Bagged Canister Vacuum

My Braun tootbrush has never charges-i have a 240 & 11v shaver socket but nothing seems to happen when i plug it in?

When charging a device on some type of charging block you need to plug it into a regular 110 socket as the block has the correct modifications in it for the device that it charges. This 11volt shaver socket is for older shavers that dont charge up yo ... Vacuums

A family member recently gave me their Kenmore Vacuum Cleaner (model 35821) and I did not notice that the power cord was missing at first. I tried to look closely at the manual online to see if this was something I would be able to purchase or if the vacuum was no longer any good. Do you happen to know if there is a replacement part for the actual power cord for this item?

Any power cord 17 gauge or lower will work ... Vacuums

I have shark vacuum model #V1700Z and doing my move to a new house I never found the charging chord. I don't know if I can buy one for it or should I just buy a new one for only $35.

... Vacuums

I have an antique 8 arm chandlier and want to put it up in my bedroom but the wire hasnt any differance in color, how do i wire it to the exsisting wire from the celing , what wire goes to what wire ? I wont be installing it myself but would like to know so i dont sound so silly

Starting with the proper wire gauge, always white to white and black to black. ... Vacuums

I have the same problem as discussed above. My Hoover Pet Cyclonic upright stops working while using it. The bottom feels hot when this happens. When it first occurred, I emptied the canister and even tried a different plug. It did not turn back on for over an hour. When it did turn back on, it would die again after about 3-5 minutes of use. I don't know what else to try. I have washed the secondary filters, let them air dry and replaced them and this did not help the problem. My friend,

... Dirt Devil Hoover Uh70085 Pet Cyclonic? Upright Vacuum

When I shampoo The excess water that is to come back in bucket has never happen I bought it a long time agp at KMart didn't know why it doesn't work. I oly paid $100.00 so I don't want to spend to much money to repair. I just borrow my sons machine. Janet


My electric toothbrush doesnt work any more even though I have only used it a dozen times. I have obviously tried to charge it, but with no result.I disposed of all the packaging when I started using it so I dont have the guarantee. I bought it from Tesco in Roundhay Rd., Leeds 8. roun about Christmas time. I would be grateful if you could help me with this matter. Yours sincerely, Mrs. L.E.Glenn

My Dear Chap. It is highly unlikely that you can exercise any type of warrenty for the toothbrush without the documentation. That is, a reciept at the least. Packaging would have helped, but the receipt is the key.\012What you can do is try to ... Vacuums

Dont know how to hook up the carpet cleaning part of the vacuum

You have to have the Aquamate II shampoo attachment in order to clean/shampoo your carpet. Go to the Rainbow website and you can purchase it if you don't already have one - if you do have one, this site also has simple directions on how to set up th ... Rainbow E series Canister Wet/Dry Vacuum

I have a 350E memory craft and I would like to know how to register a new USB or PC Card so I can use the pattern. Also would like to know how I can download patterns on to my Laptop. Thank you.

Welcome to FixYa!\015\012\015\012\015\012\015\012First you need to format the USB.\015\012Important: You memory stick USB is less than 1 GB. (The one that came in the package)\015\012\015\012\015\012Put the USB ... Vacuums

My Euro-Pro UV617 never holds the charge as described from day one. I never it plugged in all the time and it dies after use for 5 mins. Is there a cheaper source to buy replacement battery? Should I spend another $27 for replacement battery or is there a bettter cordless vacuum out there which holds the charge as promised?

I'm going to try this source for a battery: $11.99 ea.+ $6.96 SH or 3/$32.42 + $7.95 SH\015\012\015\012http://store.yahoo.com/buyitnow64/shvacl ... Vacuums

Roomba Red shows pulsing red charging light, turns green, measured battery voltage - only shows about 5.5 volts. Borrowed and used neighbor's charging unit - same thing happened. It seems that the charging system inside the Roomba Red is not functioning. WShat else can I try?

... iRobot Roomba Red 4100 Bagless Robotic Vacuum

I cannot charge my two year old electrolux pronto. I purchased a brand new hand held vacuum for it, but even the new one does not charge. When I plug in the cord nothing happens. If I turn on either the long handle or the portable unit within the long unit, the blue charging light comes on for a few seconds, then out. This tells me that the circuit is intact without a broken wire somewhere. I took it all apart carefully and could see nothing broken or out of place. On re-constructing it, it

It must be the charging transformer. We have already ruled out the vacuum unit. Unfortunately the transformer is not a serviceable part, and will need to be replaced. ... Electrolux Pronto 2-In-1 Stick/Hand Vacuum - Cayenne
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0487 seconds