Having problems with your Vacuums ?

Vax vstm1500 leaving streaks on floor - Vacuums


Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Vax vstm1500 leaving streaks on floor - Vacuums


... Vacuums

Poor cleaning I recently bought the Shark Steam Mop as I read mainly fantastic reviews. I was disappointed to find that it leaves a slight film on my dark hardwood floors when finished. I can wipe the film away with my finger and you can see foot prints if walked over. I also found that there are cloth streaks on my ceramic floors after drying as well. I followed all instructions, vacuumed beforehand, used distilled water even though my water is not considered hard, cleaned slowly, etc. I am wo


Hi,This type of problem usually is not he fault of the Shark Steam Mop.The problem is the old residue left on the floors by other cleaners.Here is a tip that I wrote that will help you out with that problem... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Vax steam mop leaves streaks - Vacuums


... Vacuums

It leaves dirt and fluff in the rollers not in the filter. So is not cleaning properly. There is never anf fluff at all in the filter. Also the lid does not close properly and we constantly get the 'check tank' light coming on. It leaves streaky marks across the floor and seems to leave the floor too wet (hence the streaks). Look forward to hearing from you.


Is there something stuck in the air passage between the tank and inlet ... iRobot 5800 Scooba Vacuum

Streaking I just used my Shark steam mop for the first time and I am very disappointed in the streaks that were left on my porcelain tile floors. The floor was vacuumed before I mopped. What can I do about this?


You maust have some type of wax build up on ur porceline tiles that has not been removed, and should never been used to begin with as poceline is its own finished luster...or you may have used a strong concentration of cleaner that has left behind re ... Euro-Pro Ultra Steam SharkTM II Hard Surface Steam Cleaner Vacuum

Oreck vacuum leaves brush marks on hardwood floor


... Oreck XL Ultra Bagged Upright Vacuum

Vax s2s bare floor pro steam mop - VAX Appliances Vacuums


... VAX Appliances Vacuums

My Hoover Windtunnel Ultra U6425-900 began shutting off after a few minutes of vacuuming. The time interval became shorter and shorter. If I leave it sit a while, it will start again. This does not happen when I used the attachments - only with the floor brushes. The switch has recently been replaced and the whole vacuum serviced by a Hoover dealer about a year ago. I have been told by a local repair shop(not a Hoover dealer) that it is the motor, there is nothing to do other than replace t


... Hoover Vacuums

Shark steam mop leaves ugly streaks on my floors


Http://www.sharkclean.com/ go to the web page and after support and download, see video, read you instr. manual or chat with them for support in how to fix it the problem. Go ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Water lesking from vax rapide carpet washer - Dirt Devil CE5500 Floor Keeper Upright Wet/Dry Vacuum


I have been using a vax v26 carpet cleaner and the washing water is leaking from the bottom then the solution will not come out has the pump\015\012given up? ... Dirt Devil CE5500 Floor Keeper Upright Wet/Dry Vacuum

Kirby Sentria My vacuum is leaving scuff marks on my hard wood floor any ways to fix?  please help.. thanks.


Be sure that the brush roller is dusengaged. \012To do this you:\012* Lift up the headlight lamp\012*Turn the handle until the red arrows line up ... Vacuums

My Bissel pro heat 2x is pouring water all over the floor when ever I turn it on. I checked the water tank itself and it is not leaking. Is there a way to fix it? It also leaves soap in streaks on the rug.


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Every time i shut the vacuum off it leaves a pile of dirt on the floorthe floor


... Dyson DC28 Animal Bagless Upright Vacuum

My dyson dc07 brush bar seems to be only spinning at half speed. Leaves three light streaks in the vacuum marks like somethings just dragging. Brush bar is clear and filters are clean. Seems like there's slipping somewhere.


The belt is stretch and so it is slipping on the motor shaft. You need to change the belt. Here is a link for the\015\012instructions on how to change the belt and a link for the belt you need: ... Dyson DC07 Bagless Upright Cyclonic Vacuum

H300 brushes won't stop spinning even though I switch it from "wet scrub" to "wet/dry pickup" and is leaving streaks on the floor. I have already ordered a new squeege, but that won't take care of the non-stop brush problem. Any suggestions?


I have found that the plastic piece on mine is wore out and slips when the trigger is pulled back. If you look underneath the dirty tank, you will see the black plastic pieces that over lap. I took a wiretie/zip strip and placed it around the spot ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

Why does my vacuum leave a trail of hair on my floors when it's being pulled backward but suction up fine when it's going forward?


It is because the belt is worn and stretched. when you go forward there isn' t as much resistance and the brush can turn and pick up, but when you go back there is more resistance and doesn't pick up. You simply need to replace the belt. Here is the ... Eureka 5849A Boss Bagless Upright Cyclonic Vacuum

Leaves floor Dull! - Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum


Hi,This type of problem usually is not he fault of the Shark Steam Mop.The problem is the old residue left on the floors by other cleaners.Here is a tip that I wrote that will help you out with that problem... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

When vacuuming the floor it does not leave brush marks or pick up anything unless you reach down and lift on the very front of the machine and then it works for a while and quits again


The belt is probably worn or stretched. When this happens the belt won't turn the roller brush when it is against the carpet. Here is a link for the manual and links for the belts you need: ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Leaves floor Dull! - Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum


Hi,This type of problem usually is not he fault of the Shark Steam Mop.The problem is the old residue left on the floors by other cleaners.Here is a tip that I wrote that will help you out with that problem... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Whem i vacuum it leaves streak marks of the dirt on the carpet. i clean out the cup and the hose, what am i doing wrong? and how could i solve this problem?


It sounds like your filters may be clogged. Try pulling out the tray directly underneath of your dirt cup. You should see a black, or plastic piece directly underneath of the dirty cup that says PULL, pull this tray out and inspect the filter. ... Bissell 89Q9 Bagless Cyclonic Vacuum

Vacuum cleaner I am needing to buy a vacuum cleaner - the flooring in our house is mainly oregon pine with loose rugs. I suffer from back problems and find the cylinder vacuums cause a great deal of back strain. I have been told that an upright vacuum is not suitable for wooden floors - I would appreciate any advice, particularly if u know of an upright vacuum cleaner that works well on wooden floors Thank you


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=517227&thid=728380\015\012Vacuum cleaner\015\012Posted by che9 on Jul 01, 2008\015\012I need to buy a vacuum clea ... Electrolux EL7055A Bagless Canister Vacuum

Streaks on porcelein tile from shark steam mop


I have the same problem!!! its driving me nuts, i think its the microfibe pads that do it. I used the kenwood steam mop and it didnt have a microfibe cleaning pad on the bottom of it and it cleaned it perfectly, no streaks! because that blew up i ha ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

My Hoover vacuum is not vacuuming the carpets or floors. When I release the tube to use the smaller end the suction works perfect. So i believe the problem is in the rods on the floor or in the part that vacuums the floor! Can you tell me how to fix it , or where can I take it to get it fixed? thanks


Ive just had the exact same problem. In the very back lower portion of the vacuum You will need to take it apart. I guarantee there is a clog. You might also check your belts to make sure they are still on track. ... Hoover Vacuums

Vacuum leaves a trail of dust


... Eureka Whirlwind LiteSpeed 5843 Upright Vacuum

My vacuum just stopped working, so I don't know what the problem is. I used it in the kitchen to vacuum the hard wood floor. I turned it off, and a few minutes later, turned it back on to finish vaccuuming the kitchen floor. It just would not turn on. I had not unplugged it or did anything to it. I then tried to see if it would work in another plug, and no luck. I'm trying to figure out if it can be fixed or if I need to look for a new vacuum.


When I get most Vacuums that have dies on people most of them the wire has been worn and cut one or more wires on the plug cord. Sometimes the cut can be over looked. Please unplug and check the wire carefully.Also please post the make model a ... Kenmore 23913 Progressive PowerMate Bagged Canister Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0830 seconds