Having problems with your Vacuums ?

Engine on dc180 gets hot, is that normal, lm thinking not


Answers :

Check your filters and hose for obstructions. also check brush roll for material wrapped around it.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Engine on dc180 gets hot, is that normal, lm thinking not


Check your filters and hose for obstructions. also check brush roll for material wrapped around it. ... Vacuums

My shark professional steamer plug gets extremely hot. Is that normal?


No it should not get hot undo the plug and check if the wirers are conected tight one of the main causes is loose wires, have you tried a differant outlet. ... Vacuums

FQ95x...motor gets very hot very fast


These old style majestic always ran on the hot side but since its pushing 20 years old, you need to have it serviced my a filter queen service center. that will help with the heat problem and prolong the life of the machine. ... Rainbow 75th Anniversary Canister Vacuum

I've had my Dyson DC14 vacuum cleaner now for approximately 9 months and been very happy with my purchase. However, It is used sparingly maybe twice a week at the very most. The problem is when I try to use the item on my carpet, you have to push really hard to get it to move. It's as though the suction power is far to strong. It certainly doesn't glide as I think it should. It still picks up as usual but I cannot imagine that having to 'force' the machine to move is the normal operating procedu


Thanks for your question!I'm sorry that you haven't received an answer yet.The response rate on FixYa FREE questions is usually over 80%, but sometimes questions go un-answered when:1. the question is unclear, incomplete, or poorly ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

Burning smell There is a burning smell when I run my Kirby Ultimate G.  The smell seems to be coming from the belt.  I looked at the brushes and they are spinning so the belt is working.  the Post on the vacuum is getting very hot not sure if that is normal.  What is causing this?


Unlock the sweeper brushes and take them out. on each end is a cup bearing and should be free of debris.then check around and under the belt and likely there is debris wrapped around it.the post is getting hot as your pulling too much of ... Kirby Ultimate G Bagged Upright Vacuum

The little belt inside the head of the vaccum with the beater bar is not always spinning therefor is melting. Is it normal for the metal pin that it is going around on to get really hot?


The Belt should be changed at this point. This will allow for the proper tension to be on the brush between the motor assembly (metal pin) and the brush so that it spins at the proper speed. Is it "normal" for the metal pin (motor shaft) ... Filter Queen Majestic Canister Vacuum

My cord gets hot is that normal? - Dyson DC14 Animal Bagless Upright Cyclonic Vacuum


Warm is normal for 12 amp appliances like most vacuums. Hot is not normal and you should have the unit serviced before any further use. ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

I purchased the Shark Steam Mop less than a year ago and I have used it about 8 times and now it is not working. It will not steam. The light on the front is on and you can hear it tryng but it will not get hot and steam the water like it should. I think it needs to be replaced with a Warranty Item for free. It is still under warranty.


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Plug gets hot when using vacuum.Could it be the motor? My husband thinks it's because it is drawing to much power. That the vacuum is blocked somewhere.


Do you mean the plug in the wall gets hot if so this should never happen has the fuse in the plug been changed?\012 if not the vacum can not be pulling to much power as the fuse will blow to stop that\012 Yes the vacuum may be blocked ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

We bought a Philips Intellicare 8030 ironinng system in 2005. Two days ago water from the plastic water container does not go inside bigger water tank where we think the water gets heated up. When the heating tank is empty there is no steam that comes out of the iron. Also, there is water dripping off profusely from under the iron where the steam normally comes out. Can you please advise how we should remedy this problem Please advise which service centre in Sydney, Australia would we be able to


... Philips Vacuums

Steam doesn't come out anymore when I pull the trigger. I think the water in the tank is getting hot, but when I pull the trigger, only a little water comes out. No steam


Try putting some white vinegar in the tank to dissolve any hard water deposits. You should use only distilled water in this machine. Don't try to clean anything with the vinegar in it, but take it outside to run the vinegar through. ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

The engine seems to be accelerating and getting hot and no vacuuming happens


Everything you say points to there being a blockage somewhere. The motor's not moving any air, so it goes faster. Without any cooling air it gets hot. And, of course, with no air moving there's no suction. Find the blockage and clear it, and everythi ... Eureka Vacuums

Machine cuts out due to getting hot


Most vacuums have a heat resister in when they overheat they cut out, this is normally because they are full up, got a blockage or the filters need cleaning, suggestions are, clean filters, empty and check for blockage. ... Dyson DC07 Allergy Blue/Turquoise Bagless Upright Cyclonic Vacuum

Miele Cat & Dog vacuum gets VERY hot and is VERY loud. Hose has no restrictions and I have changed the dust compartment (motor) filter and the exhaust filter. It still gets hot when I run it with the top open and all filters removed, so I'm guessing the problem is with the motor. Should I be going into the motor compartment? If so, what am I looking for?


Hi\015\012\015\012The fact that it gets very hot could be due to a number of issues.,but the fact that it started making a very loud noise at the same time suggests that there might be more problems maybe brushes etc.\015\012\ ... Miele S514 Solaris Bagged Canister Vacuum

The handle for my Eureka 5993 AVZ was getting very hot when used. Finally, the wires around the switch melted and now the vacuum will not work. What is wrong? Is the switch bad? The wires only melted in the immediate vicinity of the three-prong switch. Nothing else appears to be wrong; the vacuum worked fine when it was running - except for the handle getting hot. Thank you!


Try cleaning all...\015\012if have sam paoblem need replaced main motor.... ... Eureka 5893AVZ Bagless Upright Cyclonic Vacuum

I have a hoover mach 5 multi-chamber cyclonic vacum cleaner and it keeps getting hot and quitting.it's got a strong smell like something is burned when it gets hot also.


If its giving off that strong smell then the motor is bad. probably caused by not keeping the filters clean. on any bagless machine one has to clean the entire vacuum after almost every use to keep the unit operating correctly ... Vacuums

The steam do not get hot it get warm athe water


Hi,Sarah, the unit is no good...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have a GXCFD GE Smartwater hot, cold water dispensor, everything works but the hot water, doesnt light up, or get hot. any suggestions


If there is no hot water coming out from your instant hot-water dispenser, check the following to find out the prolem and fix it :\015\0121.Power: Under-the-counter hot water dispensers are plugged into a standard wall socket that suppli ... GE Vacuums

I am trying to register my shaver on www.philips.com/welcome and get 1 year additional guarantee. I also expect to get Updates on all the latest shaving and grooming Hot exclusive offers And Personalised support. I cannot get any of these and cannot register my shaver. Please help....


... Vacuums

Why is my hoover getting too hot and stopping


... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

Off/on switch gets hot and burns out after 30-40 hours of use.


... Proteam CoachVac Canister Vacuum

Belts breaking/melting The original belt broke at almost 1 year so I replaced it. I changed the carpet setting to shag even though my carpet is very low pile to make it easier on the vacuum. I didn't get to use it but just a couple minutes and could already start smelling the new belt getting hot. I checked the roller and it is easy to spin. Not clogged with hair or dirt. Now the inside of the new belt has small pieces of rolled rubber instead of being smooth. The metal shaft that goes into the


... Dirt Devil M088905 Vision Bagless Upright Vacuum

I have a Z5930 vacuum and i want to trace an electrical fault. I need to disassemble it to get to the electrical connections and it is quite a tricky one to get in side. The machine will run and then cut out after a short time. It will then re-start in about 2-3 minutes and run normally again and so on. I was not able to give you the exact model but it is Ultra Filtration Oxygen line


... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

Brand new Shark steam mop out of box - plug in, gets hot but steam won't come out. No steam, just hot mop - should we just give up and send it back?/


Hi,Some types of water will not work, try bottled spring water...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Why am I getting a smell out of my Kirby when I am vacuuming, I have tried changing the bag thinking it was something to do with that, but even with the new bag I get the same horrible smell. Can you help please. Thank you.


If it is a burning rubber smell then that means that the belt needs to be changed. Here are the belts you need:Kirby Ultimate G Belts ... Kirby Ultimate G Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0462 seconds