Having problems with your Vacuums ?

Cant open vax steamer safety cap - Vacuums


Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Cant open vax steamer safety cap - Vacuums


... Vacuums

VAX STEAM CLEANER CANT GET IT OPEN - VAX Appliances V081 Canister Steam Cleaner


... VAX Appliances V081 Canister Steam Cleaner

I have a VAX U91-MA-B-I vacuum. All filters are clean. When I start it a valve in the upper part of the canister (near the handle) opens and the vacuum makes a very loud noise and does not create the cyclone in the chamber.


... VAX Appliances Vacuums

Shark SC-505 Handheld Steam Vacuum: how to open the cap...


... Euro-Pro Shark SC-505 Handheld Steam Vacuum

I have a vec-101 vax bagless cylinder vacuum cleaner,only had it a week and the blockage light has stayed on.i have checked everything and cant find a blockage anywhere,what is the fault? thanks


... Vacuums

How does the cap open to put water in - Polti Eco Pro 3000 Canister Steam Vacuum


You push down and hold it down while turning, keep turning till it is off. Same as puting on ... Polti Eco Pro 3000 Canister Steam Vacuum

My safety cap will not twist to open and i cant refill my steam cleaner what would the problem be


... Vacuums

I cant open it - Eureka 431A Optima Bagless Upright Vacuum


Before doing anything, make sure that the vacuum is unplugged from the outlet. After that, you are now ready to open your vacuum. Here are the steps to do so:a) First, remove the dust cap by pressing the "cup release" button on the top rear rig ... Eureka 431A Optima Bagless Upright Vacuum

CAN NOT GET THE CAP OPEN - Steam Fast SF-250 Mouse Vacuum


... Steam Fast SF-250 Mouse Vacuum

When we turn on the vacuum, the canister falls open. The clips holding the canister in place do not seem to hold the canister tightly which I'm sure that it did in the past. The clips do not look bent, but every time we turn on the vacuum the intense pressure blows the canister open only remaining attached the the rest of the vacuum by one clip


Check filter and make sure it is kept clean at regular intervals. Possibly worn out clip retainers on cannister side due to excessive pressure build up. Do not force closure unless pressure is back to normal. May crack cannister or damage unit beyond ... Hayden Industries SuperVac 6000 Central System Vacuum

Can't open Cannister Vacuum to get to motor


Pop the cover that operates the cord return you will find two phillips head screws under it; take them out and the covers comes right off. ... Vacuums

I cant open the top


... Euro-Pro Omega SC104 Steam Vacuum

My Ergospace Vacuum took some apple juice in and now it makes strange noice and even threw out some sparks. Is there anything I can do my self or is it over with this vacuum cleaner? I opened 6 screws, but I still can't open the motor cover. Are there some hidden screws?


Liquid plus electrical parts always ends up with the electrical parts losing. Juices, although they will dry, will leave behind a sticky residue. You'll need to replace at least the motor, but due to the other electrical components, probably be bet ... Electrolux EL4100A Ergospace Cannister Vacuum

Need technical help for my miele s2180 momentum canister vacuum .Bought a display open box at fure shop..Came with a filter bag..there are no tears in the bag...Perhaps they put the wrong bag..Anyway after 30 minutes of use..The motor stopped working ..so I opened up the unit only to see,.the dirt was everywhere inside the vacuum...only a little was in the bag itself..can you hepl..Dave


... Vacuums

Hi, I have a Miele s247i vacuume cleaner- My electric coard does not roll back, How do I open the vacuume lid / housing to fix or replace the spring? do you have instruction manual on how to open the cover?


... Vacuums

CEL lit up on dash. Codes point to possible loose vacuum line or faulty gas cap. Replaced cap with no change. Looking for vacuum line diagram if possible. Thanks, Brian


\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012 ... Vacuums

My vacuum smells like it is burning - VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum


... VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum

On my Air Vac model AV425A Central Vacuum System, I discovered the circuit breaker opened. When I close it, the vacuum motor goes on. It doesn't matter which position the on/off switch is on, it runs until I open the circuit breaker again.


... M&S Systems ZX7000 Bagged Central System Vacuum

Can you reverse the vax 2000 vacuum cleaner to pump up a pool


Theoretcally u can switch the two coils inside the vacume cleaner, u could get electricuted/ break the cleaner as a result.\015\012if any one has suggestions on how exactly to do this(im building a furnace... gotta have a blower thin) then plea ... Vacuums

Unbeknownst to me, someone took the bag out of my Kenmore Progressive vacuum and failed to replace it. I have been vacuuming without a bag for months, and today the vacuum stopped sucking. When I opened up the front to replace the bag, tons of dirt and dust came pouring out. I thoroughly cleaned the vacuum, put in a new bag, but still no sucking power. Just dust coming from the rear vents where one of the filters is. Is the vacuum ruined, or is it a simple solution of buying a new filter?


Sounds like you need to buy a new motor. All that grit and dust will ruin a motor and I'm surprised it lasted as long as it did.\015\012This is where a vacuum that won't run without a bag would have been nice. (Aerus for one) ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

My electrolux oxygen canister cuts on and off. I have to open and close the vacuum, or take the base of the hose off and then re-insert. I have to do all these things before it will start up again. I sometimes shake the hose around, then it will come back on. If I try to dust with the dust brush (like a lamp shade or shelf) and the suction pulls against the object, the vacuum goes off for awhile. Sometimes I'll have to reset the vacuum by unplugging the electric cord. I never get to finis


Maybe you should have taken it back to that shop, it appartently isn't fixed. I would have replace that board, don't believe in modifing, you usually end up with other problems, like you have. One thing to check is maybe you have a partial clog in ... Vacuums

How do you open the vacuum - Dirt Devil KURV Hand Vacuum Champagne Vacuum


Wish I knew! We've tried everything and can't get it open. ... Dirt Devil KURV Hand Vacuum Champagne Vacuum

Vax rapide not picking up - VAX Appliances Vax X3 Bagless Upright Vacuum


... VAX Appliances Vax X3 Bagless Upright Vacuum

Vax model 121 how to remove motor - VAX Appliances Vax X3 Bagless Upright Vacuum


... VAX Appliances Vax X3 Bagless Upright Vacuum

My DC07 Animal Bagless Upright Cyclonic Vacuum has a small attachment for vacuuming carpeted stairs. This attachment is currently not spinning its internal brush necessary to pickup the dirt on the stairs. The rest of the vaccum is working fine. The suction cap on this attachment is pulled out, as it should be. I have checked the vacuum over thoroguhly and there are no bloackages anywhere.


Make sure to extend the wand straight up and completely out of the handle and watch that you don't kink the hose. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0743 seconds