Having problems with your Vacuums ?

Where is the belt and how do you change it? on my euerka pet expert vac model 3276 type BVZ


Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Where is the belt and how do you change it? on my euerka pet expert vac model 3276 type BVZ


... Vacuums

How to change the belt on euerka pet expert, model number 3276 type BVZ


... Vacuums

Eureka pet expert upright vacumn. Changing the belt. Model #3276BVZ


... Eureka 3276AZ Pet Lover Bagless Upright Vacuum

MY VACUUM ISN'T PULLING AS STRONG AS IT USED TO SO I THINK IT NEEDS A NEW BELT. I CAN'T FIND THE MANUEL ON IT SO I NEED SOME INSTRUCTIONS ON HOW TO CHANGE THE BELT. I DON'T WANT TO BREAK MY VAC. CAN SOME ONE PLEASE INSTRUCT ME ON HOW I SHOULD CHANGE THE BELT PLEASE. TYPE VAC: EUREKA THE BOSS WHIRLWIND LITE CYCLONIC POWER CANISTER TYPE VAC. THE HANDLE IS DETACHABLE TO CLEAN IN THE CORNER WITH A SMALL EXTENSION.


You can get Eureka replacement belts here:Eureka Vacuum Betls ... Vacuums

Change shop Vac Model LM500 from dry to wet pick


To change from dry to wet, remove the paper filter and install ball float if not already attatched ... Shop Vac 925-13 Canister Wet/Dry Vacuum

The vac just goes red hot and switchs itself off no idea why. alyx pets 2000w is the model of the vac.


Its activated its thermal cut off. Check the filters - if the paper pleated cone filter is blocked throughly tap it gently to loosen dirt before washing it completely and drying it in a low temp tumble dryer (put it in a pillow case with a towel insi ... Vacuums

I have an Alba Vacuum Cleaner model AVC1502(Bagless cyclonic cylinder 1500w) I am in desperate need of a filter cover. As I have severe arthritis this vac cleaner only weighs 5.1kg(not able to lift much weight) please I need help tracking down the filter cover, perhaps a later model may have the same cover, need all experts assistance thanking you sincerely for any help that can be offered. In anticipation Dee


... Alba Vacuums

I have an Oreck XL Hand Vac Model #BB870-AW Type 2 Serial #SN870AWP3Z101356-Z which was used to **** up a large amount of fresh coffee grounds (not used). The vac will not turn on. What can I do? Hose not clogged; put in a new bag. Can't find my manual. Is there a filter or reset button?


... Oreck Vacuums

I badly need a replacement for the small elasticized grey cloth part (filter??) that fits over the plastic form inside of the hand vac of GE Combiination Vac Bagless System---model 106687, type A. Can you just tell me if the name of that part is the filter? I did find one on a website but there's no image available and I don't want to order the wrong thing. Thank you.


... GE Combination 106687 Upright Vacuum

My Oregon Scientific BAR888 has 5 windows, 1. temperature, 2. humidity, 3. mb/hPa or inHg (switch at the back), 4. bars showing pressure changes over 24 hours, and 5. time/date. Window 3 gives an option to set something between 0 and 2500. Oregon say they only have one set of instructions for the BAR888 but they do not match my instrument as there is nothing included for my window 3. Trouble is I don't know what the 0 to 2500 relates to and therefore don't know what to set it at.(My model does n


... Vacuums

I have an Alba Vacuum Cleaner model AVC1502(Bagless cyclonic cylinder 1500w) I am in desperate need of a filter cover. As I have severe arthritis this vac cleaner only weighs 5.1kg(not able to lift much weight) please I need help tracking down the filter cover, perhaps a later model may have the same cover, need all experts assistance thanking you sincerely for any help that can be offered. In anticipation Dee


Www.searspartsdirect.com ... Vacuums

How to change belt on oreck xl type 6 model RXL2600HH


... Oreck XL2600 Vacuum

Change vacuum, clearner belt on eureka the boxx model 2271 type a


... Eureka Vacuums

Need help in changing the blade on inside of case housing for a old G6 type vac 15 plus yr old. how do i replace plastic blade.


This guide should make it easy for you!!!\015\012\015\012http://reviews.ebay.com/KIRBY-VACUUM ... Kirby G6 Bagged Upright Vacuum

How do i change the belt on my eureka enviro vac model number 3041 BZ


... Eureka 3041BZ Upright Vacuum

Need to change the motor brushes in Shop Vac model 800. How do you get into the motor housing?


Would like to know if you still need help with you problem. If so go to the link below.\015\012\015\012http://www.ereplacementparts.com/ ... Vacuums

Hi, I have a Dirt Devil Model # M08100REDC. I desperately need to change the bag, but I don't see an obvious way to do it. I'm afraid to try pulling on the cloth tab thingy that's just below the handle, between the rubber ring that holds the bag on the vac, because it seems like stuff will fly everywhere from the force required to remove it, and I might not be able to get it back on there. Should I just pull on that cloth tab until the bag comes off? Thanks, Roberta


You can pull on the tab to remove the bag, but probably a better way is to gently pull on the rubber ring that attaches the bag to the back of the vacuum body. If you don't yank and ****, it should come off without spilling the dirt. There may also b ... Dirt Devil Classic M08100 Bagged Handheld Vacuum

Cannot figure out how to change Hoover duros canister vac bag. Have Hoover SR bags for model #401010SR. Please help! Thank you.


... Maytag Hoover Duros S3590 Vacuum (Canister)

Water pours out from the clean water tank,there is a plastic type pin that the tank sits on and i'm not sure if there was some sort of washer on it that is not there now. Its a Hoover Steam vac, model # F5875-900 Thanks for your help.


The hose is off tilt the handle back you will see it running down into the base ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

I have the 2961 altima but out doesn't have the the duster it has the pet paw I needed to know the right belt size for it asap but it said its 2961 but type is bvz lol


The belt is the Eureka style U belt. Genuine part # 61120D. You may find them easily at Kmart, Walmart, etc. ... Eureka 2961AVZ Bagless Upright Vacuum

Have a Eureka Power Plus 12.0 Amps Model 4702 Type A 120 volts and 60 HZ that there is something wrong that it isn't picking up right and you can actually feel the air coming out of it near where the bagless canister attaches. My thoughts are that a seal is missing around where the hole lines up when the cannister is locked in. This Vac was my Mom's and she passed away and I think a part went missing maybe when it was taken apart to clean the filter and empty the canister. Need to figure out if


... Vacuums

I have a kenmore cannister vac - model 27514. Do I have to use hepa bags in it, or can I substitute another type, and which would that be?


You know, any bag made for the unit should give similar results. You can buy a cheaper bag and that number is 50558. You can get them at your local vac shop or you can let me know, I will send you some. The price per 3 pack is only 4.95. The cani ... Vacuums

I replaced the belt in our Eureka Boss Smart Vac, it still seems loose, it uses a type R belt. The beater belt still doesn't seem to turn properly and seems that it doesn't pick up very well when I use it on my berber carpet. We have 2 dogs and I like to use it frequently. I have changed the bags and belt......


Check to see that the beater brush is not frozen up. Pull the brush and clean it, spraying some WD40 on each end piece that holds the brush in place.\015\012Also be sure the belt is properly installed so that the brush turns in the correct direction ... Eureka Vacuums

We just moved in - the house is about 9 years old. I have a Eureka Mega Boss central vac - looks like model # is CV20220. 12.4 amps, 120 volts. Can't figure out what type of bags I need. Can you help?


Well, for this unit you will need any of the following bags, Eureka genuine Part# 90610Eureka replacement (Central vac bag) another genuine bag style called CV-1, and/or CV-2Kenmore Central vac bagsMost of th ... Vacuums

I have a Broan Nutone central vacuum. The power head seems to stall unless you lift up on the handle. I think I may need to change the belt but cannot find a place to purchase one to see if this is the problem Model number BN180 type 1


You are correct, you need a new belt. You can find belts for the Broan BN180 at www.vacbelts.com. ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0648 seconds