Having problems with your Vacuums ?

Bissell 7350 parts list - Vacuums

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Where can I get a complete factory list of parts numbers for the Bissell 3750 Series Bagless Vacuum Cleaner. I found an exploded diagram but parts did not have official part numbers listed.

If in Australia call godfreys vacumm they can probably email one to you or look up www.bissel.com and ask them ... Bissell Vacuums

Bissell 7350 parts list - Vacuums

... Vacuums

Where can i buy parts for the model C151D vacuum. any place i checked does not have that model of electrolux listed. i need the power wand attachment. i ordered one that looked like it from sears parts direct but it wasn't the proper one and they do not list the model C151D

Any Aerus Electrolux store. For the one nearest you, check the below link and follow the directions. Keep in mind that if it's too far away, they do ship. If you're close enough, they do deliver.\015\012This model is not the same company tha ... Electrolux UltraLux 2000 Bagged Canister Vacuum

No parts list in the user manual, thus can't search for a specific replacement part for Fantom FM740 vacuum cleaner!

Go to this link for parts for fantom fm740http://www.vacpartswarehouse.com/Fantom-FM740-Bagless-Upright-s/4164.htm ... Fantom Vacums FM740 Twister 300SE Bagless Upright Vacuum

What is belt part number foe bissell 3108 - Bissell 3108 EasyVac Powerbrush Upright Vacuum

The drive belt part number is 210-0130 for the bissell 3108. The number for bissell consumer services is 1-800-237-7691, hope this helps!! ... Bissell 3108 EasyVac Powerbrush Upright Vacuum

The part under the vacuume isnt spinning - Bissell 6594 PowerForce Bagless Upright Vacuum

... Bissell 6594 PowerForce Bagless Upright Vacuum

I took apart my bissell easy vac to clean it because it was clogged and now I cannot remember how a part goes on that is underneith the vacuum. I keep putting it on but its not right. It lifts the vacuum off the floor so it is not sitting in there right.

Make sure the plate is lined up correctly it should side down flush ... Vacuums

Brush will not turn on on my Bissell Healthy home vacuum, the brush button is depressed and brush is clear. The vacuum motor works fine, just the brush will not turn on. Is there a part to replace?

... Bissell Healthy Home HEPA Bagless Upright Vacuum - Metallic Blue

Does anyone know where I can get a motor bearing for the 3595 upright vacuum. Called Bissell and they say I have to be an authorized dealer to get "internal" parts and called their "authorozed dealer" and they told me they cannot get the part and I needed a new motor...ridiculous! Anyone put a bearing on these and if so where did you get it from?

Bought the whole motor assembly for mine, no bearing only part available. THis vacuum now headed for its third motor. " $45 dollars is still cheaper than a new vacuum". That's what I said the first time... ... Bissell CleanView 3596 Bagless Upright Vacuum

Bissell bagless upright parts near me - Bissell 3576 CleanView II Bagless Upright Vacuum

... Bissell 3576 CleanView II Bagless Upright Vacuum

Bissell cleanview 11 bagless special edition model 3576-2 I took apart to clean the filters and don't remember howto put the bottom of the dirt container back. I thought I put the empty container back in place correctly but the dirt when vacuuming is flowing through another part of the vacuum.

... Bissell Vacuums

Hello :) My bissell proheat upright steam cleaner is not shooting any water out at the bottom and I was wondering what could be wrong. The handheld part is working fine, its only the vacuum part thats not squirting out any water.

... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Was cleaning out a shed and ran across a electrlux vacuum cleaner in excellent shape blue in color would like to find an owners manual and parts list it is missing part of the wan and bags, it purrs like a kitten would apreciate any info on it, year etc. thanks so much. Ken

HI,Without having a model number it is hard to tell you what to buy. I have found a website for the Electrolux company and there is a place for contacting them for support. I hope this helps. If you want to you can also leave a comment letting ... Vacuums

I have a Philips vacuum Cleaner model FC9104. The on/off switch does not work (it appears to be part 11a and/or 11 on this the parts list document). Is it easy to replace?

... Philips FC9104 Bagged Canister Vacuum

I have an Eureka Express canister vacuum - I believe it's model 8284 - that just stopped working. Plug it in, turn it on, and absolutely nothing happens. I took it to the local sew and vac place and they say it's a circuit board that is no longer available. I've looked at all the parts lists and diagrams for that vacuum and I would swear there isn't a circuit board there. (I wouldn't have even thought that in 1989 they would have used circuits.) In any case, I absolutely love this machine a

Given the age of the machine weighed against you fondness for it, unless you can find a fault with either the switch or the cord, there is little else that can be done. With time the electrical lead can break down and one o ... Electrolux Vacuums

I need to buy parts for my bissel - Bissell 3750 Lift Off Bagless Upright Vacuum

Parts can be purchased at www.bissell.com or by calling BISSELL Consumer Services at.....\0121-800-237-7691Mon-Fri: 8am to 10pm ETSat: 9am to 8pm ET ... Bissell 3750 Lift Off Bagless Upright Vacuum

I have a bissell lift off and the brushes wont spin, i think it maybe because of the internal switch that tells the vacuum that the canister is installed is bad. is there a replacement part for that or do i have to get a new vacuum?

Hi,If you take out the brush roll, holding the ends, make sure that it \015\012spins freely, if not, replace it. Belts stretch after a short time of \015\012use and need to be replaced often.So you could either have a bad brush roll and ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum

The genie vacuum wetdry vac parts list and schematic breakdown illustrarted view for genie sv200q

... Vacuums

Need an internal parts list for a bissell pro heat pet, model # 8910

Click this link for parts list and diagram for bissell 8910http://www.ereplacementparts.com/bis ... Bissell 8910 ProHeat Clear View Upright Vacuum

Clogged Bissell After debris clears the brush part, it gets clogged at the point of entrance into the machine, barely anything makes it through the filter and into the canister. Clogs immediately after a few swipes of the carpet. Had vacuum for almost 3 years.

Something must be in the hose causing a clog, take the hose off and if suction is good where the hose hooks up, then there is something caught inside the hose. ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum

I am looking online for a replacement motor for my Bissell ProLite 3560-2 upright vacuum. I have found two different part numbers and do not know how to determine which is the correct one. 2146060 or 0132057

The bissell website has a user manual http://www.bissell.com/images/UserGuides/prolite.pdf and it states the motor is warranteed as follows...Note the ... Bissell Vacuums

My Bissell Model 3760-4 is not working properly. The belt has been replaced (and checked 3 times), but the brush bar does not move when the brush motor button is on. The little metal turning piece that turns the belt is turnable with one's finger when the belt is off, but when we put it all back together and turn on the vacuum, the brush bar does not go around and the burning belt smell returns. The portable part of the machine works properly. It's the brush bar. It has been cleared of hair, etc

... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum

I need an operators manual for the bissell model #1631 please, and a parts list. I may be missing something when I purchased it at a yard sale.

I believe you will find what you need at this URL:\015\012\015\012http://www.bissell.com/product_search.aspx?searchtext=Bissell%25201631%2520PowerSteamer%2520ProHeat%2520Canister&searchType=search&mode=userguides&pagesize=25\015\012\015\0 ... Bissell 1631 PowerSteamer ProHeat Canister Vacuum

Bissell 6595 problems with roller brush. I've had this happen with two of the same model. Each one didn't last more than seven months! First, it became loud when vacuuming, then there was a burning smell. When you try to replace the belt, you see that won't do any good because the fitted end of the brush is melted. The housing part the roller brush fits into is melted too. There's no place for the roller brush to fit into. I tried to upload pics, because I don't see how replacing the roller brus

... Bissell 6595 Lift Off Bagless Upright Vacuum

I have a Bissell Lift-Off Revolution upright vacuum cleaner. The dirt is sticking around the black round sponge filter which is in the upper part of the cleaner. It isn't falling into the bowl like it should. What could be the cause of this?

Thats what its supposed to di i suggest to clean that filter after every couple of uses to prevent any problems in the future ... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0858 seconds