Having problems with your Vacuums ?

Eureka powerline central van not sucking

\015 Downstairs is sucking but when I put the hose in upstairs, I hear the vac come on in the garage but it is not sucking anything\015

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Eureka powerline central van not sucking


... Vacuums

My home has a central vacuum system hook-up but no vacuum installed. My friend upgraded his central system and gave me his Eureka Mega Boss central vacuum system and the accessories, including the pow


The power head requires 120 Volts. Some hoses have a receptacle in the handle for the power head plug, and the hose has a cord at the wall inlet end that plugs into a receptacle. Some hoses have a plug at the wall inlet end that plugs into a 120Volt ... Eureka 1810 Central System Vacuum

Change belt for eureka powerline 4773 - Eureka Powerline LiteSpeed 5845 Upright Vacuum


... Eureka Powerline LiteSpeed 5845 Upright Vacuum

No suction eureka powerline - Eureka Powerline LiteSpeed 5845 Upright Vacuum


... Eureka Powerline LiteSpeed 5845 Upright Vacuum

Eureka powerline gold


If no suction, then you have a clog either in the hose, the dirt inlet by the brush roll, or bad filters. ... Vacuums

My Hoover s5620 central vacuum is not sucking. I cleaned out the canister and vacuumed the inside bag in the canister. The hose is clear as is the central vacuums tubing. Any suggestions ?


Try getting some compressed air source and blow back whatever is stuck in the hose. ... Vacuums

Eureka victory replacement bags - Eureka 1810 Central System Vacuum


... Eureka 1810 Central System Vacuum

Central vac our central vac will not work unless the main vac in the garage is switched on manualy.... its sucking fine but i have to switch it off at the main switch in the garage after i have used it normaly i just plug in the hose and vac away and it switches itself off we have just had cable installed with a fisher guy in the walls do you think that would be the problem thanks a lot


It is possible that the low voltage wiring that controls your central vacuum has been damaged during the cable work. You can check to see if the low voltage relay is working by shorting the two terminals together at the unit. Just disconnect the two ... M&S Systems AirVac AVP1200 Platinum Series Central Vac - 12,000 sq ft Bagged Central System Vacuum

How to get at my belt on eureka E1393 - Eureka 1810 Central System Vacuum


... Eureka 1810 Central System Vacuum

Eureka central vac 's power stopped won't start again.


I took to dealer I bought from . He examined it. The motor is gone needs new one. Thanks, Ann ... Eureka 1810 Central System Vacuum

My Eureka Whirlwind Plus is not sucking up


Hi,\015\012 It sounds like you just have a clog going on... maybe a sock or something. You might have to do a little disassembly of the roller to get to it.\015\012Hope this hlelps... Good luck ... Vacuums

Why doesn't my eureka 8810 avz suck much?


... Eureka Vacuums

My eureka 437 stopped sucking


Hello,I believe the filter on your vacuum is clogged. Bagless vacuums require the filter be brushed or washed\015\012 and dried, If they are not, the \015\012 filter will clog, resulting in the reduction of suction. Clean fi ... Eureka Vacuums

Getting a Eureka central vac cloth bag back in after cleaning


I found that if you start by making sure that the tab that you pull to remove the filter is in a spot where you can reach it next time you need to remove it. Next, put the filter in over the inlet spoutand push it up to the white "stops" then gently ... Vacuums

Central vacuum not sucking


... Electrolux Central Vacuum

Eureka upright wide angle doesn't suck well. belt and roller seem fine.


... Eureka Vacuums

HOW DO i CHANGE THE BELT ON MY EUREKa powerline 4773 AZ


... Eureka 4700A Maxima Bagless Upright Vacuum

Central vacuum not sucking


Usually when there is no suction, and the main unit is running, then either the hose or somewhere in the piping there is a clog. If you move the hose to another location, is there suction? If not then the hose is clogged. You can unhook the pipe a ... M&S Systems AirVac AVP1200 Platinum Series Central Vac - 12,000 sq ft Bagged Central System Vacuum

My Broan central vac is 25 yrs. old and making a lot of noise in the upper canister, but sucks okay, what is it? #CV40


1) motor bearing replace2) brush roller bearing defective replace3) any other parts loose or worn.God bless you ... Vacuums

Motor Filter Has Been Sucked In - Eureka 4467AV Upright Vacuum


You will have to remove the cover over the motor so you can get to it and the fan. When you get the filter out, drill holes first, then drive a couple of nails down thru where the filter sits so it can't get sucked into the fan again. ... Eureka 4467AV Upright Vacuum

Eureka Central Vac-Sweeper -Model B1501


First undo the hose from the base and then take the cover off from under the vacuum, remove the brush roller and belt, then note where the suction hole is and shine a light through the hole and look in the other side, if there isn't any light, then p ... Vacuums

Eureka Central Vacuum powers on and off


... Vacuums

I have a Eureka "The Boss" vacuum that doesnt seem to be sucking up as much as it should and did in the past when vacuuming on carpet and hard floor surfaces.


I have a Eureka "The Boss" vacuum that doesn’t seem to be sucking up as much as it should and did in the past when vacuuming on carpet and hard floor surfaces.\015\012 \015\012I woul ... Vacuums

I have a Eureka Central Vac CV1601b. The motor does not stop unless the Unit is unplug from the electrical outlet. Any Idea?.I removed the control unit to check if there was disconnected wires or burnt wires. Everything look normal. The circuit board does not show area that overheated. There seem to be 2 relays. Likely one of the two went bad. What do you think.


If the unit is relay controlled, there is always the possibility that when the unit was turned on, the relay contacts welded themselves shut making the power button ineffective. \015\012\015\012If you're familiar with relay pinouts, with ... Vacuums

Looking to replace my eureka Boss central vacuum, but need a new unit with both exhaust and suction connections on same side. I was looking to replace it with an Imperium CV7700.


I would recommend the AirVac AVR7500 model. It's a great unit. ... Eureka CV1801 Bagged Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0320 seconds