Having problems with your Vacuums ?

Sonixx bagless 2400watt vaccum

\015 Sonnix\015

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Sonixx bagless 2400watt vaccum


... Vacuums

Vaccum problem I turn the vaccum on and it does not run but the light on the vaccum works. Bissell bagless vaccum cleaner


No sound at all? or the motor runs but no vaccuum?\015\012did it stop while using it? might have overheated due to dirty filters... strange that the light comes on but no motor at all... that would suggest to me that the motor is shot... ... Bissell 6594 PowerForce Bagless Upright Vacuum

I have a Kenmore bagless vaccum 12.0 amps I need help with get the canister off so it can be emptyed It is a upright vaccum.


Which model is it? ... Vacuums

Help!!!! i have an older model of the dirt devil bagless quick vac. and it has been working great, just last week i was vaccuming my bedroom and i accidentally sucked up a string belt that goes with one of my capris. and today i emtpied out the dirt cup but it seems the the string belt that was sucked up is not within my reach and whenever i start the vaccum i get this distinctive noise that i've never heard before. help.


It's likely wrapped around the brush\015\012pull out the roller and un tangle it ... Dirt Devil M084600 Dynamite Bagless Upright Vacuum

My bissell bagless vac has no vaccum. ihave


Have you checked the main dust channels from the hose leading into the bin? Have you brushed clean the main filter cones? Make sure all the filters have been properly cleaned *(and if washed make sure its completely dry before puttng back into the ma ... Vacuums

Euro-pro EP724 bagless vaccum cleaner


... Euro-Pro EP724 Bagless Canister Cyclonic Vacuum

Bissel bagless vaccum cleaner---how to reassemble


Make and model number please ... Vacuums

I have bagless samsung air track 2000w tein cleaner vaccume cleaner..it has only one switch for on and off...cant find a switch to put the cord back????? .


... Vacuums

My brush roller on my hoover bagless quik broom with on board tools S2610 not working but belt is intact vaccum


... Hoover Quik Broom S2610 Bagless Upright Cyclonic Vacuum

Dirt devil dual cyclonic bagless vaccum


Did you check the hose and the inlet by the brush roll for a clog? ... Vacuums

Hi, The belt of our Dirt devil bagless vaccum broke and we got new belt and replaced it. Even after replacing the belt, the brush is not rotating. Any suggestions please ?


Did you check to see that the beater brush, the brush that the belt drives, is free of debris and moves freely?\015\012When they bind up they can cause the belt to break.\015\012Remove the beater brush just as you do when changing the belt and clean ... Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

Vaccume overheats and shuts down - Hoover U5753-900 WindTunnel Bagless Upright Vacuum


Check your filters. Not changing or cleaning your filters suffocates your motor, so that could be the problem.I suggest checking your local yellow pages for a local vacuum shop and have them fully inspect your vacuum for any clogs. ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

No suction the vaccum sounds like its working and it picks up a little but it does not suction like it did 2 days ago. It is a hoover windtunnel bagless. the model number is U6600-9RM.


Have u checked all of the filters. I know that when not all the filters r clean the machine will turn on but then it will sound louder and still have no suction. Most times there is a filter under dirt container thats sits above motor and if this ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

Bosch BUC11700UC Cyclone Jet Upright Bagless Vaccum


I had the same problem. I ordered a new switch from a local appliance\015\012place part#417915 (also try 54542), but it can be found on-line for\015\012~$2+shipping. There are 11 screws to remove. Remove all nine screws\015\012that hold on the back o ... Bosch BUC11700UC Cyclone Jet Bagless Upright Vacuum

My eureka optima upright bagless vaccum has VERY low suction using the floor part. the hose has excellent suction. i removed the little translucent door underneath and there were no blockages, i cleaned the brushroll thoroughly and that hasnt helped either. i know this probably isnt recommended but i turned it on to the floor setting with the brushroll off and stuck my fingers up the intake as far as i could, the suction was good further up but it just seems to stop down at the base. because i s


I will try and help here. Is the sole plate on the bottom of the vacuum complety on and there are no visible cracks along the seam where it meets the body? This is the usual cause for this. Onc you take of the plate to access the roller and brushes, ... Eureka 431A Optima Bagless Upright Vacuum

How to clean filter on dyson vaccums - Dyson DC07 Bagless Upright Cyclonic Vacuum


The filter on the side of the of the unit can be washed out with warm soapy water leave for 24hours to dry somewhere warm do not tumble dry the filter under the bin just replace as the cannot be washed. ... Dyson DC07 Bagless Upright Cyclonic Vacuum

The brush roll on my Eureka Bagless The Boss 4 dimension cleaning vaccum itsn't working. How do I fix it?


Take either the plate over the brush roll off, if it doesn't come off, then the top cover comes off, should be 2 or 3 screws on the top to remove. Then you can get to the belt and brush roll. Check the brush roll, make sure the ends turn freely, if ... Eureka Vacuums

My panasonic MC-E4103 bagless vaccum cleaner stops after 20 seconds instantly have to wait for few hours to start again


... Panasonic Vacuums

How to assemble the eureka vaccum - Eureka Power Plus 4703D Bagless Upright Vacuum


... Eureka Power Plus 4703D Bagless Upright Vacuum

My DC07 Animal Bagless Upright Cyclonic Vacuum has a small attachment for vacuuming carpeted stairs. This attachment is currently not spinning its internal brush necessary to pickup the dirt on the stairs. The rest of the vaccum is working fine. The suction cap on this attachment is pulled out, as it should be. I have checked the vacuum over thoroguhly and there are no bloackages anywhere.


Make sure to extend the wand straight up and completely out of the handle and watch that you don't kink the hose. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Dear tech, I have a 12amp bissel bagless cleaner model# 4220-P the part i need is under the foot lever to lower the vaccum cleaner to sweep. The part is the slide pin that locks the sweeper from lowering.It has a spring attach to it. can I buy this part bob Yurkovich


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=805734\015\012Generic problem for all Vacuums\015\012Dear tech, I have a\015\012Posted by yurk on Jul 1 ... Vacuums

Our vaccum cleaner does not clean up. - Eureka 4700A Maxima Bagless Upright Vacuum


If the floor unit is not picking up, check for a broken belt for the beater brush or for a frozen beater brush.\015\012Might be a good idea to remove the beater brush and clean it of any debris and squirt some WD40 on the two end pieces that hold the ... Eureka 4700A Maxima Bagless Upright Vacuum

I am looking for the filter for the Eureka bagless Altima vaccum cleaner


There should be an toll free # to call for eureka and they can direct you to the nearest authorized eureka service center in you area. If its a new model places like wallmart wont stock it. There are so many vacuum makes and models its impossible fo ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

Vaccum will not remain standing - Bissell 6591 Power Trak Revolution Bagless Upright Vacuum


A spike-impulse or "delta function" has an interesting frequency spectrum. It is composed of all possible sine waves of frequencies 1,2,3,4,etc. When a large set of sine wave signals are all added together, they cancel out everwhere except at the zer ... Bissell 6591 Power Trak Revolution Bagless Upright Vacuum

Windtunnel bagless vaccum model uh6000 on/off switch no longer working, must plug/unplug unit to use. Can switch be replaced?


Hi, \015\012\015\012Yes they can be replaced and are relatively easy to fit. In my opinion, Hoover are one of the best vacuum manufacturers when it comes to obtaining spares and you should have no problem getting one. I did a (very quick) ... Hoover Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0244 seconds