Having problems with your Vacuums ?

Central vacuum keeps blowing fuse

\015 Dirt devil\015

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Central vacuum keeps blowing fuse


... Vacuums

Fuse keeps blowing - Bissell Vacuums


Hi Ji! You may want to bring your machine into one of our Authorized Service Centers to have it inspected. Here's a quick link to help you locate one in your area: ... Bissell Vacuums

Plug fuse keeps blowing


... Vacuums

The F1 fuse on the PCB in my Dyson upright keeps blowing.


... Dyson Ball DC24 Bagless Upright Vacuum

Vacuum keeps running after unit is unplugged - Broan-NuTone CV353 Central Vacuum


... Broan-NuTone CV353 Central Vacuum

Low suction I have a Hoover central vacuum system. I've reset the fuse box, checked the fuses, all of the lines are clear and there are no holes for escaped air to travel out. The filter has been cleaned as well. The vac works well with high suction when hooked directly to the unit, however when using any of the indoor connections there is extremely low suction. The machine still turns on so I do not believe it is an electronic issue. I have troubleshooted the issue as best I could and would


... Hoover L2310 GUV Central System Vacuum

I have an electrolux central vacuum in my house. My central vac hose has something stuck in it, I think, maybe a sock. I tried to put a long dryer wand down it but the hose is just too long. Does this need a repair man or new hose?? Any idea of a way to blow it out? Thanks.


The best way to clear an obstruction is to blow it out by attaching the wall end to the exhaust of a shop vacuum, or using an air compressor.\015\012You can try holding the wand end of the hose directly to the CV in port and turning the machine ... Electrolux Central Vacuum

Dc15 fuse The roller brushes on my dc15 stopped working..I checked the obvious and then noticed that the 2 amp fuse was blown on the circuit board . I've replaced it with the same type bought from Maplins but it keeps blowing .. I tested the yellow an blue wires leading from the circuit board to the roller brush head and the are in tact and I can run a current through them ... Any thoughts from anyone .? Your help would be. Appreciated thanks Lee


Hi Lee,I'm sorry to hear you're having difficulty with your DC15. If you'd like some help, please give us a call on 0800 298 0298 - we may be able to resolve the issue with some troubleshooting over the phone.Best wishes,Jack ... Dyson DC15 All Floors - The Ball Bagless Upright Cyclonic Vacuum

Changed the motor carbon brushes on my Beam central vacuum cleaner equiped with an IntelliWatch system. This system includes the Alutron DB100 module. This Alutron module needs to be reset so that the vacuum cleaner can operate properly. I believe that this module keeps log of running time and disables operation after a predetermined time. Can you help me with providing a reset procedure that will reset this module. Thanks


... Sunbeam Vacuums

My vax essentials hoover, model number vec-01 keeps blowing fuse as soon as it is plugged in and turned on. Cleaned the filters and have changed the fuse 5 times


... Vacuums

Hoover EmPower 4600 keeps blowing circuit breaker. The number of outlets in the house that will allow me to run the vacuum is dropping quickly. It is a 4 year old house and all the circuit breakers are 20 amps. The vacuum only has a 12 amp motor. I am at a loss to solve this problem.


Take it to a friends house and plug it in if it does the same thing then the problem is in the vacuum cleaner.check your cord and see if there are anny cuts in it.you can open the breaker box then plug in the vacuum and watch the breaker box.you migh ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

I have a Z345 Electrolux cylinder vacuum cleaner, from the 1970s probably, but not used much. I have lost the guide. I forgot to change the bag before it was full. Smoke started to come out - smelling of burnt paper, not rubber. So switched off. It did not blow the fuse, and may be OK. I wish to inspect it. How do I open it up? Alos I have an air filter and a motor filter for it. I have often changed the air filter on the top. How do I get at the motor filter, if there is one? Than


Good day! OK you have to is replaced the bag and that's it.And don't forget to change the bag again to avoid that problem.Thank you ... Electrolux Guardian Bagged Canister Vacuum

I WAS VACUUMING AND IT TRIPPED A BREAKER. dID i BLOW A FUSE iT JUST SHUT OFF AND WOULD NOT COME BACK ON.


Hi there it's SmartAlec from NelsonVacuums.com.au here. It is most likely that the cord where it goes into the machine has a short in it. It is also possible that the motor ... Oreck XL Ultra Bagged Upright Vacuum

Our dyson ball vacuum keeps blowing air out of a valve at the top of the collection canister causing it to lose sucction. why?


That unit redirects the suction to that valve to protect the motor. check both of your filters and also check for a clog. make sure to clean the inside of the canister as thouroughly as possible. ... Vacuums

My daughters X-Treme Scooters | X-360 - 350 Watt Electric Scooter - Pink the fuse keeps breaking or blowing in it. Do you know what could be causeing that? Please help she really loves her scooter and we dont have a clue nor a manual to see what is wrong with it. It will run until she pushes the gas all the way and it gets hot.


Hi, be sure you are using the right amperage fuse in it. Check any exposed wires on it they may have got skinned up, causing a short and blowing this fuse. You say it gets hot when she gives it full power, so its blowing when its drawing the most amp ... Vacuums

BEAM model 178 central Vacuum. Motor will not start. Has power but just won't start. No click when switch is turned on. Is there any fuse to check? Could it be the relay? Any other thing to check? Thank you. Pierre


... Vacuums

My vax Mach zen Hoover has been loosing suction and now keeps cutting out due to blowing fuses. Anyone else have this problem or know what to do please ????!!!??


... Vacuums

My electrolux harmony vacuum suddenly won't turn on. Replaced the bag and filter. Still have no power. Did I blow a fuse?


... Electrolux Vacuums

When you plug in vacuum it blows fuse in house fusebox


I have the same problem and I don't know what to do?\015\012anybody? ... Electrolux EL5020 Vacuum

When I turn it on it is blowing the fuse box - Vacuums


This is either a problem with the vacuum or a problem with the house's electrical circuit.\015\012\015\012Does that breaker in your panel trip or blow a fuse any time other than when you use the vacuum?\015\012It is possible that th ... Vacuums

Keeps cutting out, and blowing the fuse, not so if tools are being used though


The information you've given suggests a problem with the main brush drive motor. Unfortunately this motor is in a place where it can very easily get wet - hence fuses blowing. Repair is something you probably won't want to attempt yourself (lots of p ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

My dyson keeps blowing the fuse, what can it be? as soon as you turn it on it stops? thank you


... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Motor keeps running after hose is removed - Broan-NuTone CV350 Performance Bagged Central System Vacuum


This is usually a stuck relay. Unplug one leg of the low voltage wire at the unit and see if that solves it. If it doesn't then the relay in the machine is bad. If it does then there is a short in that wire somewhere in the home, or a piece of metal ... Broan-NuTone CV350 Performance Bagged Central System Vacuum

Cyclovac dl-200 sv control card blew,why? Changed card installed new card different rev. ,rev.c instead of rev.e fuse on card keeps tripping vacuum only operates on one speed high.


... Vacuums

Keep blowing 6.3amp fuse on vax carpet cleaner


... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1028 seconds