Having problems with your Vacuums ?

Pulling apart a miele

\015 Disassemble\015

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Pulling apart a miele


... Vacuums

There is something stuck in the handle of my Miele vacuum. I unscrewed all the screws hoping that I could remove the hard plastic handle from the hose. I was only able to flip up a piece of plastic where the switch is. Should I pull harder to pry the plastic apart? I was afraid I'd break something. Thank You, Chrissy


... Miele Vacuums

Miele Galaxy vacuum hose and wand don't come apart


... Miele Blue Moon Bagged Canister Vacuum

How to pull apart the cyclone barrel on my Dyson DC11


To Pull Apart the DC11 Cyclone section there are three more screwsbut to get to them you need to remove the button (the one that unlocks the flap to empty the dust out) There is a small rectangular hole on the other side of the button, pushing ... Dyson DC11 All Floors Bagless Canister Cyclonic Vacuum

Very little suction from vacuum is occurring after I pulled a string from the roller. Hot air is blowing out of unit. Was working fine until I pulled out a string...Suction is occurring from wand.The brushes now make a loud sound too when activated...do I have to take the unit apart to readjust them or something?


Yes re adjust ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Shopvac 90L400 quit working (4 years old). Thought the switch was bad but not the problem. I read that there is a fuse link in the motor that frequently burns up. I tried to take motor apart but not sure of the process. I was able to get to the motor but cannot pull it out of the armature. It appears I have to take the aluminum blower unit off the shaft (it appears to be pressed on with a retaining washer). Do I have to take it off to pull the shaft and motor assembly out? Is that where the fuse


By pass the switch and take power right to the motor leads.. that should tell you if the motor is ok.. have not seen fuse link on a vac motor.. graingers has new motors, but not inexpensive ... Vacuums

How does Miele handle come apart - Miele Vacuums


See the next diagram and proceed according: ... Miele Vacuums

How to take apart a miele s5210 vacuum - Miele Vacuums


Found this:\015\012http://www.asciimation.co.nz/bb/2009/12/29/tearing-apart-my-miele-s5210-vacuum-cleaner ... Miele Vacuums

My daughter pulled to hard on the ceiling fan pulling out the chain. i have taken it off and apart, nothing appears to be broken but im trying to figure out how to put it together so it retracks, i assume it has something to do with the tension of the small spring inside of it, but not sure how to put it back together im wondering if there is a internal diagram of this ???


Don't even bother to repair the pull chain switch, get a new one at KMart, HomeDepot or similar store for less than $2.\012\012Two times I've repaired one, it comes apart when I need it the most.\012\012Good Day! Don't forget to rate thi ... Vacuums

I need to know how (if) I can take apart a Miele electric telescoping wand apart to clear some debris from it. Thanks!


Take a close hanger, Or a stick end push it though to clean it out. ... Vacuums

The powerbrush seb 217 on my miele red velvet stopped spinning yesterday and the red & yellow lights came on the head. I took it apart and there are no strings clogging. It appears that the gears doesn't spin anymore. Took it apart and cleaned the contacts. still no luck. is it likely it is the motor?


... Miele Red Star Bagged Canister Vacuum

How to pull apart dyson 29 turbine head


Hi Garry,Thank you for your question. We would like to provide further assistance but it would be difficult to provide all of the information in this space. We would appreciate the opportunity to discuss this over the phone in greater detail. ... Dyson DC08 Cylinder Bagless Canister Cyclonic Vacuum

Pull apart vacuum head of a hoover hygiene PB4


... Hoover Commerical Conquest C1119-080 Vacuum

How do i pull my DC08 Dyson barrel Vacuum apart


... Dyson Vacuums

How do I take my Miele S251i apart to be able to chenge the powercord?


\015\012HOW TO OPEN MIELE 251 VACCUUM:\015\0121-Unplug from wall and disconnect power cord\015\0122-Remove black switch panel at back of top panel:\015\012\011A-Use Phillips screwdriver, remove two silver screws visible\011 ... Miele S251i Plus Bagged Canister Vacuum

I need to replace the cord on the beater brush attachement for s3614 hoover powermax.. can't find parts. I was able to pull apart the brusher, but I cannot release the wire to resplice and reconne


... Hoover S3614 Vacuum

Hw to take miele hose SES130 apart


... Miele S514 Solaris Electro Plus Vacuum

Suction is not good. It is more hassle to empty. You have to take apart top filter & pull out everything stuck uptop. I end up with more dust on the outside when I change. I miss my bags. No dirt to deal with.


Yeah i agree with you...Sometimes you have to disconnect the primary vacuum hose at both ends and clear the debris in it..Then take the plastic top off the motor houseing and clean it out aswell...Its a pain rest assured :) ... Eureka 5849A Boss Bagless Upright Cyclonic Vacuum

Miele vacuum Sometimes when I hit the auto roll up cord button or even move the cord, the power vacuum goes off. I move the cord again and it comes back on. I took it apart and looked at the connection from the cord to the auto roller. These are the electrical slip on type connections and are still in good shape. There are no bends in the cord. I air dusted everthing inside, put it together (with no extra parts!). Good news..it powered up so I did not break it, but it still has the same problem.


... Vacuums

Our meile vacuum has a short in the power cord - i think my son pulled it out too far. How do I take it apart to look at the base of the cord?


A how to take this vacuum has been posted here\015\012\015\012Good luck! ... Miele S318 Bagged Canister Vacuum

Extension arm The extension arm will not pull all the way up from the holder and I cannot use it - is there a way to take this apart - or something that can be done to fix it?


Hi,\015\012\015\012Try pulling wand up from hose with machine turned off.\015\012\015\012Or are you saying that the wand & handle wont uclip from the body of the machine ?\015\012\015\012 ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Need proper wiring connections inside unit, where they have pulled apart from squeeze connectors.(Wiring diagram needed) Can someone E-Mail this to me? Fritz (an ''old'' mechanic) Folks I have talked to, say there is no specific model number for these units. They are just described by name, and serial #. and I have relayed exactly what was labled on the unit. Please post this and quit asking me to enter a "valid" product.


Fritz , thanks please confirm... there are likely more than 2 leads from the motor?? I have not seen or worked on the Tristar CXL as it is very new.You will have a high low function but: Should the power head function at both spee ... Vacuums

My Hoover Steam vac has also stopped sucking... I have pulled it apart to clean it. Is there a way to take the bristles off to clean them as well as are there any other parts that could be the problem?


Based on your description, poor suction is related to only a few things\015\012\015\012Check filter inside lower tank\015\012Check the lower tank lid to be on properly\015\012 ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

The brush wouldn't work when the selector switch was in carpet mode. Took the power head apart and removed the motor. Everything o.k. in the power head. Checked and found that the neutural wire had pulled out of the connector, the connector was never crimped at the factory. What a day! Took 2 hours and a large pizza to get it done. Neutral wire was in the hose just below the handle. Reconnected the wire and crimped it, put everything back together. It works!!!!


Great. ... Kenmore Vacuums

Cord/recoll/turn on The miele white star vacuum will only start if I pull out the cord very fast and hard. I assume there a relation between the cord extraction and the power switch. What is it and how do i fix it? Drew


This is a tricky problem and if your are not mechanically skilled can destroy your cord reel. Basically the reel spring has collapsed inside and you need to install two washers to help push the contacts back into place. Take the entire unit apart and ... Miele S514 Solaris Bagged Canister Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0462 seconds