Having problems with your Vacuums ?

Infiniti pro conair spin air brush

\015 Won't spin\015

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Infiniti pro conair spin air brush


... Vacuums

I have a Bissell Pro Heat 2X carpet cleaner and the brushes spin, then stop. I turn it off and when I re-start, the brushes do not spin until I push foreward. The it spins and stops again. Both belts are tight. The brushes spin if held above the carpet, but upon contact with carpet it stops. Same thing on a hard surface.


The reason for the brushes to stop when it is above any surface is there is a switch in the handle that stops the brushes so it dont burn your motor up it may have a faulty switch. ... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

How to clean the head of the conair spin brush


... Conair Vacuums

Shark Euro-pro EP621 Bagless Upright Vacuum. Q regarding the brush not spinning / after troubleshooting and taking actions listed below, it now spinning for a few secs, but then stopping. Already removed hair, strings, etc. Checked that belt is aligned properly, checked that small wheel that turns belt is working (spins fine when belt removed. Oiled the turning parts a bit, that made it spin better, but still stops. It turns about 3-4 seconds then stops. If I switch it off and on again, I get ag


... Euro-Pro EP621 Bagless Upright Vacuum

Bissell Pro 2X. The brushes spin as soon as I turn it on but only spins for an instant then it quits spinning. The vacuum stays running. the handle is down.


It might be the drive belt slipping if the unit is off then the belt is locked onto the belt and then when the unit is switched on the belt slips and if its loose it doesnt hold the belt to the motor shaft  ... Bissell 9200 Upright Vacuum

Air flow indicator stays activated after filter has been cleaned. Brush spins, but very little suction. Dirt doesn't spin in cup.


Your vacuum is clogged. Check all of the air pathways, hoses, etc. The most common places to check are anywhere there's a joint in the airways, and also directly behind the brushroll. \015\012\015\012-R ... Hoover U5507900 Elite Rewind Bagless Upright Vacuum

I have a Euro-Pro Shark Cordless Sweeper Model UV610. The motor still runs but the spinning brushes are no longer spinning. Can someone that is familiar with this appliance please assist me at repairing it and/or what parts I may need for repairing it? Thanks T.R.


IT SOUNDS LIKE YOU HAVE A BROKEN BELT, THAT CONNECTS THE MOTOR TO THE ROTOR BRUSH. ... Euro-Pro Shark Cordless Stick Vacuum SV775R Vacuum

Hoover Elite Deluxe rewind... Air flow indicator stays activated, after filter has been cleaned. Brushes spin, but very little suction. Dirt is not spinning in cup


... Hoover Vacuums

No Suction/Brush not spinning on Bissell Powersteamer Pro Deluxeb


Make sure hoses are clear and check belt ... Vacuums

My vax power 8, 2200 watts 300 air watts 4L capacity upright Hoover is brand new, I emptied out the dust/dirt collecter and cleaned the motor filter yesterday for the first time, i switched it on and all fine, the brush is spinning and the hose is sucking, put the Hoover to work it's fine for about 30 seconds then then suction stops and its dead it won't collect no more, so switched off taken apart again and the motor filter is blocked and full of dust, so I unblocked it, do the same process aga


I had the same problem. It looks like the seal on the lid on the bottom of the cylinder has fallen out when it was emptied. There is no longer a proper vacuum being created so you don't get the cyclone effect and the dirt doesn't collect where its su ... Vacuums

Need replacement roller brush for euro pro infinity NV29


... Vacuums

My Steam Vac F59149 will not vacuum up the cleaning solution. I have checked the usual culprits. The dirty water tank is empty, the yellow float is not up too high. This is a relatively new appliance, so the way for the water is not blocked, there is just no suction. The warm air is blowing, the brushes are spinning. What next?


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Brushes not spinning on my Bissell carpet shampooer (pro heat turbo 2X)


Dog hair may cause this, clean this unit, take sissors and cut hair. ... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

Vaccum will not **** up the water, it is blowing hot air and the brushes are spinning, how can i fix that?


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My brushes are not spinning? - Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum


... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

I need the belt that makes the brush spin - Bissell 1697-7 Powersteamer Pro Deluxe Vacuum


Here is the belt you need:http://www.vacbelts.com/bissell-6960-w-belt-combo-pack.htm ... Bissell 1697-7 Powersteamer Pro Deluxe Vacuum

Brush roller quit spinning. - Euro-Pro V1828 Shark Stick Vac Bagless Vacuum


... Euro-Pro V1828 Shark Stick Vac Bagless Vacuum

My Bisell pro heat turbo 2X brushes do not rotate and does dot pick up water. The belts are good but do not spin.


Hello! Thanks for choosing Fixya! Let's repair the water pickup first. \015\012\015\012\015\012Possible Cause Remedies\015\0121. Check to be sure you have the dial set at tools, or pretreat, or floor cleaning. \015\012\015\0122. Pres ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

I have the Bissell Pro-heat 2X which is new and only used one time and today I am trying to use it and the brushes will not work at all. They will not turn and spin like they are suppose to.....Please Help ! John Baumgartner Roanoke, VA


Look on the front of the little gree guy and where the switches are you should see a small diagram of a brush above or below one of the switches flip the switch to the brush diagram ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

Hi. I have a Hoover Wind Tunnel Deluxe vacuum, and the rotating brush does not spin any longer, but still has air suction. Cause ? Sincereley, Teresa T. [email protected]


Could use the model number. Most use a belt, if yours does, then you may need to relace the belt, also check the brush roll. ... Vacuums

Need new brush ( power beater bar) and belts - Euro-Pro NV31 Infinity Vacuum


Hello,You're in luck! We carry both the belts, as well as the roller brush for your Shark Infinity model that you listed this repair under.Here are links to both parts you are requesting: ... Euro-Pro NV31 Infinity Vacuum

Its not sucking up the water off the carpet , no suction , it's spraying , the scrubbing brushes are spinning , I can feel air blowing out of the side, I don't know if i usually feel that are not


Hello. Take out your recovery tank, remove the lid, and re-attach lid rolling it from the front to the back, there are two tabs on the tank that the lid has to be aligned with, you will hear it "click" when it is tight. I think this might be the tri ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

We ordered parts for our Infinity pet pro vacuum : model NVC33C March-3-2011. We ordered a replacement roller brush and new drive belt. Our credit card shows the payment of $46.85 has gone through on March-9-2011. Our understanding of the shipping time was two to three weeks. Any information would be helpful. Thanks John Jamieson 12461 202 street Maple Ridge BC Canada v2x4t5


Hi,You'll have to contact the place you ordered the parts from. We are a DIY fix it yourself site.Handie andie ... Euro-Pro NV31 Infinity Vacuum

I have a dyson animal dc24. It is 7 months old and has stopped working. The hand tool is working fine but when I insert it to engage in normal vaccuming the suction stops. I can hear a strange air sound. Also the brush is spinning but it is not picking up. I have taken it apart and checked for a clog but I don't see one. Any advice?


Hi there,I'm sorry to hear your DC24 Animal isn't picking up as well as usual. Although I note you've already checked for blockages, it sounds as though this is likely to be the cause of the issue.To locate and remove any blockages, p ... Vacuums

Have Hoover F7452900 spin vac carpet shampooer and brushes won't spin. The screen by the brushes is clean and they are place in position to clean on carpet. I noticed that when I have the brushes out of the machine and turn it on that the white square that is on the base of the machine does not spin--this is where part of the brush connector fastens to make bristles spin.


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0582 seconds