Having problems with your Vacuums ?

Electrolux eob53000 cutting out

\015 Cut out when heated up\015

Answers :

1) test the drive belt worn, and replace
2) test the motor winding overtheating and bearing and replace.
3( test the input voltage motor, and repair if there are voltage and not Running.
see the video.
God bless you
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Electrolux eob53000 cutting out

1) test the drive belt worn, and replace2) test the motor winding overtheating and bearing and replace.3( test the input voltage motor, and repair if there are voltage and not Running.see the video. God bless you ... Vacuums

Electrolux airmax keeps cutting out - Electrolux Vacuums

Probably getting to hot. make sure the hose is completely clear and that your filters are not clogged ... Electrolux Vacuums

Electrolux 2 in 1 Ergorapido stick Vacuum. Motor runs then cuts out after 3 - 4 seconds. Sometimes it will run properly for 10 minutes so batteries are good. Why does it cut our usually?

If the hand held is working correctly (By itself) try pulling up a little bit on the 4 metal connection tabs on the wand. The connection tabs were not making a proper connection on my unit. ... Electrolux Pronto 2-In-1 Stick/Hand Vacuum - Cayenne

I have a nearly 9 year old Electrolux Excellio Z5228 vacuum cleaner. It has recently started cutting out during operation. I cleaned the micro filter (between bag & motor) via brush & hitting against wall & seems / looks quite clean. I washed the gore filter (output from motor to clean the exhaust air) as per instructions, then let to dry. It was very clogged but now very clean. The vacuum clearner still cuts out often. Even after a long rest (say overnight) it still won't start, then ano

... Electrolux Vacuums

Electrolux power nozzle, model 1692, power cuts on and off

... Vacuums

The red light on my electrolux vacuum comes on and cuts power.

If the bag full light keeps coming on, you can first try adjusting the dial on top of the vacuum cleaner. If that does not work, then you need to change the control valve. This is an internal component of the canister and is directly below the dial ... Electrolux Guardian Bagged Canister Vacuum

My Electrolux central vac wont cut off when you turn the switch off or unplug the hose from the wall. Any suggestions? Sheldon

Hi,\012The realy that turns it on is stuck... the relay will need to be replaced...\012\012heatman101 ... Electrolux Central Vacuum

The motor running the beater bar on ny Electrolux canister vacuum cleaner runs intermittently. It runs about 2 minutes and then cuts off and automatically starts again after a 1 to 2 minute interval. I have tried taking it apart and removing the dust and grit in the beater bar attachment but with no change in operation. What would you suggest?

Check all the wiring connections to make sure they're tight. \015\0121/2. Wiring to power nozzle motor or reset switch is loose.\015\0121. Cord from power nozzle to upper wand. If the plastic portion of the wand is cracked near the co ... Electrolux UltraLux 2000 Bagged Canister Vacuum

My electrolux ultraone keeps cutting out after a couple of minutes - there are no lights indicating filter or bag?

This is not an Electrolux Lux 7000. Totally different companies.However, check the hose for clogs. Drop a coin down one end and lift so it should drop out the other. If it doesn't, there's a clog that needs cleared. This can often be done b ... Electrolux Lux 7000 Bagged Canister Vacuum

My brand new Electrolux ultraactive vacuum has been replaced twice with the same problem. E 2/3 keeps flashing on the remote screen and doesn't work again after cutting out. I rang the company and they told me E2 or 3 flashing on the remote screen means a problem/fault that I could not fix and I have now returned the ultraactive for the second time!

... Electrolux Vacuums

I have the electrolux guardian-My full bag light indicater is coming on even with a new bag. It gets worst-the machine will cut off when I insert the hose or put my hand over the hole where the hose goes. I changed the filter on the back and put in a new bag. Help please :)

Hi,\015\012Check your hose you have something stuck in the hose...stretch it out straight and run something through it to push out whatever is stuck in there...\015\012\015\012heatman101 ... Electrolux Guardian Bagged Canister Vacuum

I have a Electrolux Epic 6500 SR canister vacum cleaner. It is nine years old and for the past few weeks it has started shutting off for no apparent reason.The symbol for bag change lights up and it cuts off, but even after I have put a new bag in, it still does the same thing. Do you have any suggestions? There is a little button or switch that the top of the bag fits on. Do you think it could be the problem?

Your machine is probably clogged, look through the wands, look in the bottom attachment, to see if there is anything stuck there. You can also drop a marble through the hose itself to see if anything is stuck there as well. To unclog the hose try hol ... Electrolux Harmony Canister Vacuum - EL6985 Vacuum

I have a electrolux oxy3 system vacuum cleaner. The floor is damaged, and the hose has been damaged and severed and the copper cables have been cut...so I need to purchase a replacement foot and hose/hand piece. regards Sandy

... Electrolux Vacuums

Vacuum keeps saying bag is full and cuts 0ff - Electrolux Harmony Canister Vacuum - EL6985 Vacuum

... Electrolux Harmony Canister Vacuum - EL6985 Vacuum

I have an Electrolux Commercial Upright vacuum Model U129C. It has a device which turns off the motor driving the beater bar if something gets stuck in it. There is a simple reset button to restart the beater after clearing the obstruction. Just recently on flat dense low pile surfaces the switch cuts in after just a few seconds and turns the beater bar off. This doesn't happen on high pile carpet but the motor doesn't quite sound normal. There is no obstruction - the beater bar can spin freely

The motor is having a problem.There might be two reasons...either the coils inside it got heated up which will be needing rewinding or you can buy a new motor or there r capacitors attached sometimes u can make a check on that also if that's gone Kap ... Vacuums

When using the powermate of our electrolux vacuum clearner to vacuum the carpeting, it continually cuts out. What can I do to remedy this?

Try turning the knob on top all the way to the right ... Kenmore 23812 Progressive PowerMate Bagged Canister Vacuum

Electrolux 2100 bag light stays on and power won't cut on

The problrm that you are facing is in all probability being cause by a faulty vacum sensor... now for replacing the vaccum sensor i'd suggest you go for a service technician but in the meanwhile I could let you in on a procedure by which you could ma ... Electrolux UltraLux 2000 Bagged Canister Vacuum

My electrolux oxygen canister cuts on and off. I have to open and close the vacuum, or take the base of the hose off and then re-insert. I have to do all these things before it will start up again. I sometimes shake the hose around, then it will come back on. If I try to dust with the dust brush (like a lamp shade or shelf) and the suction pulls against the object, the vacuum goes off for awhile. Sometimes I'll have to reset the vacuum by unplugging the electric cord. I never get to finis

Maybe you should have taken it back to that shop, it appartently isn't fixed. I would have replace that board, don't believe in modifing, you usually end up with other problems, like you have. One thing to check is maybe you have a partial clog in ... Vacuums

Electrolux 2100 bag light stays on and power won't cut on

SRING CABLE ... Electrolux UltraLux 2000 Bagged Canister Vacuum

I have a new electrolux el7025a-r and it keeps cutting off while I am vacuuming. I am using the small powerhead on hard floors and I have checked the hoses for blockages and the bag is new. I can not figure out why it keeps turning off in the middle of a job.

The wands are notorious for going out on that unit. One or both probably need to be replaced. Try to get it done under warranty if you still have the receipt, but they shouldn't cost you too much if you can't. \015\012\015\01 ... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

Our Electrolux Z432A Vitality vacuum cleaner thermal cut off switch is way too sensitive. Can it easily be adjusted or bought and replaced?

... Electrolux Vacuums

Electrolux vitesse pet lover 1700w. Keeps cutting out and electrical sparks in front vent

Hi there SmartAlec from NelsonVacuums.com.au here. I am sorry to be the bearer of bad news but if you can visibly see sparks and its cutting out then i would say that the m ... Electrolux Vacuums

Electrolux power nozzle, model 1692, power cuts on and off. I don't have the manual for it, but I'm trying to remove and clean the brush compartment. I removed the top, but not sure how to get to the brush. I would like to find a manual for it, because it's completely different than the one I use to have.

... Electrolux Vacuums

Have an older model Electrolux canister model. The electric plug is broken so I got a new plug to put on. When I cut the cord to replace the plug, the dang cord retracted into the unit. So how do I get access to the cord area so i can find the end to the cord!

Hi,\012\012You have to open the vacuum cleaner and look for the wire.\012\012It is located inside the circular wheel, where it wind itself up.\012\012Don't be afraid to open it, unless your willing to pay somebody just to install a ... Electrolux Vacuums

HI i have a electrolux vitesse pet lover 1600w modl ece09113.When used it runs for 10 to 15 min then turns of has been like this from new.I know it says it could be blocked but have cheaked and seems to be fine. As this hase done this from new could it be a thermo cut out switch faulty. Thankyou. Dave.

... Electrolux Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0270 seconds