Having problems with your Vacuums ?

The handle BASE broke on my Shark Sweeper V1900W. Where can I find a replacement?

\015 The handle BASE broke off from the main part of the Shark Sweeper unit (not just the handle, but the base as well).\015

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The handle BASE broke on my Shark Sweeper V1900W. Where can I find a replacement?


... Vacuums

Model v1945zn, handel broke at base and doesnt connect to sweeper where can I find replacement part


... Shark Vacuums

Model number U5763900 Serial Number 090400013588 Handle broke off just above the four screws that attach it ti the boby of the vac. Hoover does not list parts for models that are more than two years old. The vac operates perfectly but without a handle my wife cannot use it, where can I find a part replacement. easy to remove four screws and replace. dont want to drive 100 or more miles to find a authorized repair shop. Oh yes, this is a Hoover Preferred Wind Tnnel Bagless


Get over it and buy a new one!!! ... Vacuums

I had a house fire and lost most of my belongings. But I had just purchased a Shark Steam mop 3501. Loved it. Well it did not get destroyed in the fire but someone managed to break the handle off. Just the handle itself was broke off the rest of the handle rod is ok. I'm trying to see if I can replace the handle and not the whole shaft. Can you help me.


Yes you can replace jus the handle, the replacement part for the handle is available at the manufacturer's web site in the Parts and Accesories section. Enter M/N: S3501 to confirm it's the same as on your unit.\015\012\015\012 ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Handle broke handle of 2961avz somehow snapped in half. any ideas how to find a replacement handle?


Part # for the handle is 75765-3. You should be able to order thru a local service repair shop. ... Eureka 2971AV EZ Kleen Bagless Upright Vacuum

I need to replace the cord on an older Hoover upright, model S660, about 1986 vintage. The cord broke where it enters handle. Handle comes apart easily. Just not sure how to pop the switch out without breaking it. Was looking for a manual online to see parts diagram and/or instruction on disassembly and cant seem to find one for that old of vacuum.


Check ebay. those vacuums are worth fixing. I loved them. they would **** the carpet off of the floor! those cords aren't hard to replace.just remember the way you got the old one out. ... Vacuums

Can't find a site to order a replacement belt for my Shark model V15Z which I bought for our motor home. It was used very little before the belt broke. I will be trashing this vacuum, and will NEVER buy another Shark product.


This web site has the belt for V15Z http://www.appliancefactoryparts.com/vacuumcleaners/brands/shark/v15z.html I found this one works great Pain to get belt on but not a problem since then. http://www.totalvac.com/ROR-1040.html (Dirt Devil type 1 Bel ... Euro-Pro Cordless Bagless Upright Sweeper - Blue/Gray

I have the same rproblem with my little Shark V15Z hand held vacuum. the belt broke,there's no instruction on how to replace (and apparenlty it was not designed to be replaced (at least with out a lot of research). I see BElectric describes how to find the hidden path, but now where can we buy the correct belts??


... Euro-Pro HEPA Shark EP035 Bagless Handheld Vacuum

THE HANDLE OF MY sHARK cordless Model#V1930 broke at the base. Can this be fixed?


... Euro-Pro Vacuums

Am trying to find replacement charger for shark sweeper model V1900W


... Euro-Pro S3325 Handheld Steam Vacuum

Where can i find a replacement battery for a shark rechargable sweeper model uv 612c 7.2v-1.3ah ni-cd battery


... Euro-Pro Shark Professional Upright Vacuum with Bonus StickVac Red Bagless Vacuum

I broke the connector attachment handle on my Shark canister steamer S3325R. I need to find the parts for this model.


... Euro-Pro S3325 Handheld Steam Vacuum

The handle broke at the base of the sweeper - Vacuums


Same thing has happened to my shark sweeper, I am frustrated with all the junk that is sold in the market with manufactured defects. ... Vacuums

The belt broke, and I can't find out how to get a replacement (Shark Hand Held Euro-Pro Model V15Z. Help!


... Euro-Pro Cordless Bagless Upright Sweeper - Blue/Gray

My shark steam mop handle broke, is there anyone who sells the replacement parts for these?


I know of a great site that sells all kinds of shark parts check it out\015\012\015\012http://stores.ilikenew.com/-strse-Replacement-Parts/Categories.bok ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Loose handle on shark v1950 sweeper - Shark Euro-Pro V1950 VX3 Rechargeable Stick Broom Sweeper, 13" Motorized Brush Roll, Folding Handle, 2 Speeds, 50 Min Cleaning, Carpets & Floors


... Shark Euro-Pro V1950 VX3 Rechargeable Stick Broom Sweeper, 13" Motorized Brush Roll, Folding Handle, 2 Speeds, 50 Min Cleaning, Carpets & Floors

I Have two questions concerning my AIRVAC AV2500 Red Series Vacuum System. How do you replace the light in the floor power head sweeper and can you replace the permanent fabric filter? We had the system installed in 2004 and the light in the sweeper head just went out and can not find any manual on line on how to replace it. The filter if not torn but avter 6 years it probably needs some kine of cleaning or replaced even though it says permanent. Any help would be appreciated. Jim McCluskey


... Vacuums

Can i get a replacement adaptor for my Shark Sweeper


... Shark Vacuums

Floppy handle When I depressed the pedel to lower the handle on our Savvy there was a snap and now the the handle won't stay up. I assume there is a spring or someting else that broke. I can't find an exploded view of the vacumm to to take it apart to find out whats broken. Any ideas on what it is.


You have to take the base cover off to find out what broke,there are some screws on the bottom remove those to take the bottom plate off then,then up inside there are more screws to on the top remove the emblem and take that screw out ,that should e ... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum

The rotating sweeper on my Electrolux Discovery II isn't turning. Can I assume there is a belt that needs to be replaced? Also, how do I get at the sweeper unit to replace the belt? Finally, where can I find a replacement belt? Thanks!! Dewey


... Electrolux Vacuums

I have a Hoover Windtunnel U5472-940. The belt broke so I replaced it. Immediately the next one broke. The belt goes around the brush cylinder and a metal post. I think there is supposed to be something on the metal post to protect the belt but I can't tell from the owner's manual. I also can't find out if this is a part that can be replaced. I've only had the vacuum about a year and a half. Thanks


You may have something in your brush bearing that does not allow the brush to turn easily thus stretching the belt. Chris ... Hoover U6455-900 WindTunnel Vacuum

Can I buy replacement batteries for Shark Cordless Sweeper


I need a replacement battery for my Shark Stick sweeper model V1911 N. Can't find it on their web site. I guess it is old.\015\012Murnieruth ... Euro-Pro Shark Professional Upright Vacuum with Bonus StickVac Red Bagless Vacuum

Can't find replacement parts for shark


... Euro-Pro Ultra Steam SharkTM II Hard Surface Steam Cleaner Vacuum

Replacement wheel I broke the wheel on my bissell upright model 3760 and need a replacement wheel and possibly an associated side molding. I can't seem to find replacement parts such as these- any suggestions?


The rear number is 2036627, there is no side casing, you would have to replace the whole back, which Bissell isn't making avaiable. But o get the wheel, you might try bissell.com and see if you can order direct, or try a local repair shop to see if ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum

I broke the handle part of the shark steamer #53101. I don't have the book to try to tell you the parts I need. Can you send me a picture or a copy of the steamer. It is purple. The above number may not be the correct one. It is broken in the center part. It has a little small circular piece that joins the two pieces which are broken. The beginning of the handle at the bottom of the steamer and the next session which has the steam release. The top of the handle is okay . It the middle and bottom


Hi,Ann there are very few parts for these...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0643 seconds