Having problems with your Vacuums ?

Simplicity scrp.4 simplicity


Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Simplicity freedom vacuum - Simplicity 7850 Premier Bagged Canister Vacuum


... Simplicity 7850 Premier Bagged Canister Vacuum

No power though simplicity 6550 - Simplicity Vacuums


... Simplicity Vacuums

Hi. I purchased a Simplicity Freedom about 2 years ago. I have had it in for various repairs several times. One persistant problem that the repairman cannot seem to fix is the dirt does not fall down into the bag - it just stays up around the suction hole. I only use simplicity bags. Any suggestions would be most appreciated. thank you


You can let the vacuum run alittle longer so the bag fills up with air, also make sure that the bag in on correctly and you have the right bag for the unit. Let me know if this helps. ... Simplicity Vacuums

Simplicity verve repair manual - Simplicity Vacuums


... Simplicity Vacuums

Simplicity scrp.4 simplicity


... Vacuums

Simplicity s36 canister vac inop.


... Simplicity Vacuums

Simplicity infinity.36 vacuum keeps stopping, why?


... Simplicity 7850 Premier Bagged Canister Vacuum

Simplicity freedom vacuum has a burnt rubber smell


If the belt is continually wearing out I would think that the brush cylinder is not free to rotate. Take the belt off and ensure that the brush cylinder moves freely. If is does not, then you need to investigate why - probably something wound round i ... Simplicity 7250 Deluxe Vacuum

Simplicity 7 Series Vacuum. Suddenly stopped.


There is a thermal reset button on your vaccum. It is on the rear of the unit, just below the attachments and next to the sticker with the serial numer etc on it. The vacuum is designed to turn itself of if too much heat gets built up to prevent it ... Simplicity 7850 Premier Bagged Canister Vacuum

Hi, I have a Simplicity Infinity 36. I just


... Vacuums

My Simplicity "Freedom" upright sweeper does not have any pickup suction - zero! However the roller beater works fine.


You must have a clog in either the hose or the dirt inlet at the bottom, by the brush roll. Also check the filters. Also if you haven't changed your belt in the last few months, they stretch and will slip under load, so you may want to change it to ... Vacuums

I'm looking for manual for a simplicity easy lock serger 804.


Copy this entire link: http://web.archive.org/web/20060508095821/http://www.simplicitysewing.com/ftp/whitepapers/804.pdf\012\012\012Enjoy! ... Vacuums

Simplicity S18L Vacuum cleaner, stopped working.


... Vacuums

How to replace Simplicity vac brush roll strips?


The caps will come out of the end of the metal roller. They can be difficult if it's been a long time as dirt and grime can build up. Try sticking a flat head screwdriver in and gently twisting to get the caps to slide out. ... Riccar Vacuums

How do I replace the electric cord for my Simplicity Shadow Vacuum cleaner model S13L? It's a canister cleaner.


Since the problem was with the plug on the electric cord, I replaced the plug, I cut the old plug, peel off the plastic cover on the cord, they were two wires, black & white, I purchased a new plug in a Home center, attach the wires to the new pl ... Simplicity Vacuums

Simplicity vacuum My vacuum just cut off and now it wont start. I pressed there restart button but nothing happens I have 2 fairly old Industrial hitachi dry vacuum in my workshop both 110v and both wont start. Both i was told were manufactured in Italy and both have a manual and auto switch. It has a black top, takes an orange paper filter inside and its bin is dark blue. Sorry i've forgotton the model number. I've inspected the wiring but it's fine, could it be the motor and how do i gain acc


Just take it in to your vacuum store. ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

Simplicity vacuum My vacuum just cut off and now it wont start. I pressed there restart button but nothing happens


Could be a bad cord or a switch problem. Could also be a problem with the motor. Will have to checked to find the right problem. ... Vacuums

I have a simplicity f3500 and while vacuuming the plastic part of the motor with the blades broke off, (the end plastic part of the motor....where can I buy that part without replacing the entire motor? Jodi


SURBAN VACUUM 315-4543111 ASK FOR KEN ... Simplicity 7850 Premier Bagged Canister Vacuum

Simplicity freedom model f3300 makes loud noise when running.


Sounds like the fan might be broken in the motor ... Vacuums

I have a Simplicity Vacuum-4800. I bought new filters and a new light bulb, but don't know how/ where to go to replace them... HELP


... Eureka 4874 Bagged Upright Vacuum

Simplicity upright vacuum 6 series is not sucking. Instead blowing out. Help.


There is a tube that usually runs along the side of the vacuum where all the dirt passes through. If you take the bottom off the vacuum you should be able to see it. This will clog from time to time. Try cleaning that out. ... Vacuums

I have a simplicity 6 series vacuum. the bag overfilled and vacuum will not run. No power. is there a fuse of relay inside the unit?


No just on /off switch and direct power to vac motor sounds like its burned up from bag being overfilled , now you have to get to the vac motor test it with switch on to see if its getting power if so then motor is burnt.use an ohms meter for power t ... Simplicity 7250 Deluxe Vacuum

I have a Simplicity S24 canister vacuum. It's about 3 yrs. old. In the past year I have had it in the shop 4 times because when using the rug piece, the piece turns on & off, on & off. The actual vacuum doesn't... just the rug piece. I recently spent $65 on a new part, after spending countless dollars the other 3 times it was in the shop for this problem. I'm ready to buy another name vacuum altogether as I feel this vacuum is not worth the money that was spent on it. I'm very frustrated.


Repair shop has not fixed the problem? complain until they fix it properly. This is a pressure fault / jamming issue or slipping drive. Repair shop should have fixed it 1st time. ... Vacuums

Over heating I have a simplicity canister we can see the dirt by thr inner filter how do we remove the top to clean or replace the inner filter?


TAKE IT TO A DEALER HE WILL HAVE THE PARTS FOR IT ... Simplicity 7850 Premier Bagged Canister Vacuum

Need to replace motor on a Simplicity upright vacuum and need help with the wiring the new motor. New motor is different from old one.


You might not have the right motor. Take the old one with you because it should go right back in as easy it was to remove. ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0074 seconds