Having problems with your Vacuums ?

I have a vaporsimac pv20 no problem steam cleaner which is heating up the water but no steam

\015 My vaporsimac pv20 steam cleaner heats up but no steam pls help\015

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a vaporsimac pv20 no problem steam cleaner which is heating up the water but no steam


... Vacuums

I have a Vaporsimac PVT 2050 No Problem steam cleaner which is heating up the water but producing no steam. Could you advise me on local repairs, Glasgow


... Vacuums

We bought a Philips Intellicare 8030 ironinng system in 2005. Two days ago water from the plastic water container does not go inside bigger water tank where we think the water gets heated up. When the heating tank is empty there is no steam that comes out of the iron. Also, there is water dripping off profusely from under the iron where the steam normally comes out. Can you please advise how we should remedy this problem Please advise which service centre in Sydney, Australia would we be able to


... Philips Vacuums

My Bissell Pro Heat 2X steam cleaner is not releasing the water


Have you tried cleaning out the small filterfrom the reserve tank? Also, check the tank/resevoir valve is operating properly, when you take it out to fill try to make water release from tank. ... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

DZ9080 IRON IS NOT VERY OLD, BUT HAS HEATING AND STEAMING PROBLEMS. IT MAY BE ALL HEATING RELATED! MY WIFE WILL SOMETIMES JUST LEAVE IT "ON" FOR TWO HOURS AND THEN IT WILL START STEAMING AGAIN. I CANNOT MAKE SENSE OF THE HEATING INDICATORS; SOMETIMES IT WILL STAY GREEN NO MATTER WHERE YOU SET THE DIAL ---- AND IT DOES NOT FEEL HOT! WHEN I TRIED IT AGAIN TODAY, THE SHOT-OF-STEAM WORKED FOR A WHILE (AND THE SPRAY WORKED), BUT THEN ALL IT WOULD DO IS DRIP WATER AT THE TIP WHEN TIPPED DOWNWARD.


I couldn't find any warranty information on this iron, but I suspect that the heating element either has a faulty connection or part of it has cracked, making contact at time, but poor contact at other times. The unit will have to be taken apart an ... Rowenta Vacuums

Problems with the Hoover Steam vac Heated carpet cleaner


You'll have to go into the turbine assembly and check the bearings. Mine stopped spinning and this solved that problem. I simply began working the seized bearing until it rolled again, packed it in grease and reassembled. ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

Bissell pro heat steam carpet cleaner is not releasing water


... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

I have had my shark steam cleaner for 6 months now and I love it, but I have hit a snag. I have not useed it for a cople weeks and when I plugged it in today - no steam. It seems to heat up, but there is no water coming out - the cleaning pad stays dry? Am I supposed to do some sort of regular cleaning of the water resovoir to prevent clogging or something?


Hi,No, these things don't last long...send it back...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have a Propress 2500 series steam cleaner which requires a heating element. It stopped working during a small steaming session. I notice now that with sufficient water in the cylinder both lights come on, the on light and the low water light , the second light remains on all the time. Can you help.


... Vacuums

I have a powersteamer and it does not spray water when I squeeze the trigger. The clean water tank is full, the cleaning solution is full and this is the same problem I had with my last Bissell steam cleaner, which I assumed was just that I had it for a few years, but this cleaner is only over a year old.


Every line has an O Ring at each end. inspect each one by removing the O Ring for nicks and cracks. Lubricate the with Vaseline and reinstall if ok so they will hold the prime to pump and vacuum up Your leaking O rings will draw air causing your p ... Bissell Vacuums

Bissell pro heat steam carpet cleaner, not releasing water.


That means that you need to replace the pump belt. Here is the belt you \012need and a manual you can view:\012\012Bissell 7901 Belt and ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Problems with the Hoover Steam vac Heated carpet cleaner


This happens when the filter on the inside of the lid for the dirty water tank is pushed all of the way up. You need to leave a 1/4 in. gap from the top to the top of the filter. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Steam will not come out, water is still heating shark steam mop-gray purple model, the problem occurs when it is plugged in (cannot use it, no steam) I have not tried anything yet


\012\012\012Hi,Here\012is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it\012may not be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have the purple Pro Shark floor steam cleaner mop, Model #3501. The mop heats up, but the steam does not come out until I remove the mop head, then it blows the mop head off and explodes the steam and water all over. It almost burnt me.


... Vacuums

Bissell Pro Heat 2x steam cleaner, problems!


Must likely the brush motor is bad. The top cover has to come off to check it, this is where the tank sits on. Part # 2036757 and is #35 in the pix.\015\012\015\012 ... Vacuums

My Shark Steam Cleaner has stopped heating water to make steam, how do I repair this? This is an older model and no longer under warranty, but when it was working it was GREAT and I want it to work again.


... Euro-Pro Ultra Steam SharkTM II Hard Surface Steam Cleaner Vacuum

My proaction steam cleaner has stopped working. the green light is always lit in amber and the water doesnt heat up nor does it eject steam.


... Vacuums

I am having problems with my Bissel ProHeat Steam Cleaner. It will not pick up the water from the carpet. Don't know what the problem can be.


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

After two years, my Euro-Pro Shark Steam Mop, Model S3101, no longer ejects steam. I have used tap water. I think the line is clogged with mineral deposits. The light is on when plugged in, and the unit heats up. I even put in vinegar for about an hour to break up the calcium deposits, but it did not correct the problem. How do I fix it, or, where can I take it locally to be fixed (Orange County, CA)?


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Bissell 1425 Little Green ProHeat Steam Cleaner - had a problem with leaking. I got replacement parts, installed in the water / soap tank, now it won't spray out any water or soap.


Did you do this work yourself?\015\012What parts were replaced in the unit?\015\012Sounds like the connection to the pump has come loose. ... Bissell 1425 Little Green ProHeat Handheld Steam Vacuum

My euro pro s3300 shark steam cleaner heats up but doesn't steam when you press the button. It is gray in color and the light turns on and is hot to the feel. What is the problem can it be fixed by me or anybody.


If you use it for more than an hour theres an automatic kill switch located on the inside designed to make you buy another one , but you can take it apart and hardwire it to bypass that kill switch , and your steamer will work once again. ... Euro-Pro S3325 Handheld Steam Vacuum

I own a Hoover Steam Vac V2 deep cleaner with Auto Rinse feature. The Model Number is not available ex: was on the bottom of the machine and the sticker is completely worn off the machine. I am having a problem with the bottle you fill with detergent ex: this bottle is seperate from the main clean water tank. THE PROBLEM: The little plastic part that goes in the bottom of the bottle has an "O" ring ex: cone shaped with a spring.....it keeps falling out. Can you supply a part number for this


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=641300\015\012Generic problem for all Vacuums\015\012I own a Hoover Steam\015\012Posted by w_brennan on ... Vacuums

I have a Polti leco aspira 710. The water in the tank is heating but when the trigger is activated no steam comes through. The machine is showing one green light and is emitting a continuous beep. The vacuum cleaner is working fine - but no steam at all


... Polti Vacuums

My Lavor Star steam cleaner will not heat water , the lights come on still - only used 8-10 times


... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0727 seconds