Having problems with your Vacuums ?

Have a polti vaporetto 2400 been used 3 times approx but out of warranty heats up ok but wont release steam when trigger pressed.have tried flushing water in tank with no results


Answers :

These machines like to be used regularly. if allowed to sit (especially after using tap water) they may buld up lime deposits on valves and cause them to stick. you could try filling with vinegar and let set, also tilt it so vinegar runs into valve area. you could heat the vinegar and it will run through the trigger valve area. if this doesn't work you'll need to replace trigger valve.
Jim
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Have a polti vaporetto 2400 been used 3 times approx but out of warranty heats up ok but wont release steam when trigger pressed.have tried flushing water in tank with no results


These machines like to be used regularly. if allowed to sit (especially after using tap water) they may buld up lime deposits on valves and cause them to stick. you could try filling with vinegar and let set, also tilt it so vinegar runs into valve a ... Vacuums

I just bought a hoover steam vac model F5914900 and the clean water tank is leaking. I tried pressing the clean surge button and the trigger button that was suggested by someone else but it won't


Go to Hoover.com and find a local Service Station. They will replace it at no charge. MUST be a warranty location to get it free. Take your sales slip with you. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Cleaning I cannot get the cleaner to release solution on carpet. have lost manual. is there a trick to this? I have tried squeezing trigger handle to dispense solution with no luck. have followed instructions (2 capfuls cleaner, fill with hot water to fill line) on filling tank.


Either you have a pinched or clogged water line, or the rod in the handle is pushing down like it should. The drw back is Bissell has deemed this unit and its parts obsolete. So any parts are hard to find.\015\012\015\012 ... Bissell 1950-3 Quicksteamer Plus Vacuum

I have a Bissell Proheat 2XTurbo carpet cleaner. No water will come out when I squeeze the trigger. I have filled the solution tank and the water tank. I read the troubleshooting in the manual and have tried turning it off for a minute and restarting and nothing. I took out both tanks and reseated them and nothing. It has sat for over a year but did not have any water in the water tank. Some solution was left in the solution tank. How can I make the water come out? HELP!


Call BISSELL Consumer Services.\015\0121-800-237-7691\015\012Mon-Fri: 8am to 10pm ET\015\012Sat: 9am to 8pm ET ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

November 2008 I bought a Simac Stirella 9000D steam generator iron. Recently its been leaking water out the bottom of the regenerator. It makes a noise when it is trying to get the steam to the iron and it works then but afterwards when the noise stops it stops steaming and I find a puddle of water underneath the regenerator. Also a little steam comes out of the water tank at the top. I understand this is happening because of scale in the base unit. Can I get something to get rid of the scale? -


... Vacuums

Steam doesn't come out anymore when I pull the trigger. I think the water in the tank is getting hot, but when I pull the trigger, only a little water comes out. No steam


Try putting some white vinegar in the tank to dissolve any hard water deposits. You should use only distilled water in this machine. Don't try to clean anything with the vinegar in it, but take it outside to run the vinegar through. ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Hello i can turn my steam buddy platinum 44G258 on, water boils, press hand gun get a buzzing noise like you do with a jet wash, but no steam comes out, it seams the water is not coming through, have check the cap on water container thats ok, its where it releases the water to is seams to be where the problem is, i think ! first time we have tried to use it many thanks steve.


... Vacuums

I have a hoover f5861-900 steam vac. the trigger mechanism seem to not work anymore. Water dribbles out without using the trigger. Taking the water tank out I can see the rod very slightly moving on the diaphragm. I removed the top part of the vac to hopefully reset the rod connection. But, didn't make any difference. I appreciate any help you can give me. thanks


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Bissell Powerease Lighweight Deep Cleaner. (Shampooer) After I fill the solution tank with the solution and water, I put it in it's slot, but all of the contents just come flowing out. I have only used this machine twice and it worked ok. You are supposed to press the trigger and the solution sprays out and then release the trigger when you want it to stop. But like I said, now I just put the tank on and all the contents come flowing out. I don't know what's wrong or how to stop it.


... Vacuums

While using my mop yesterday, it stopped letting steam come out. Tonight I plugged it up again and you could hear it trying to steam. I push the button in to release the square frame and it pushed out a burst of steam and pushed the head off. Put it back together and it still will not let steam out. No matter how much water is in it.


\012Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Ste ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I own a Bissell Proheat Pet Model 8910. After just a few uses and changing both the brush and pump belts (trying to resolve problem) carpet doesn't get wet any longer. Carpet solution comes out normally but the water barly leaves the section of the tank I fill water into, resulting in carpet recieving to much solution and not enough water. Any advice?


... Bissell 8910 ProHeat Clear View Upright Vacuum

Water seems not being introduced to heating element,which is hot, Depressing the handle appears not to be releasing water from tank; very little if any steam or water comes out base even after holding the handle down for a prolonged period and or pumping the handle.


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have used my Steam Vac for carpeting, but until today, had never tried cleaning upholstery with the spin-scrub brush. I spent a miserable afternoon trying to control the spray, which seemed to go everywhere AROUND the furniture, but not ON the furniture! Additionally, I never did get the water into the recovery tank, despite many attempts to connect and re-connect the hoses and recovery tank/lid.


I can sympathize. My vac came with two handheld attachments. I have better luck with the handheld attachment that doesn't have the spin-scrub pads. To keep the water from going all over the place, you need to keep the part the you hold only about 1 ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I have a Polti leco aspira 710. The water in the tank is heating but when the trigger is activated no steam comes through. The machine is showing one green light and is emitting a continuous beep. The vacuum cleaner is working fine - but no steam at all


... Polti Vacuums

I have a powersteamer and it does not spray water when I squeeze the trigger. The clean water tank is full, the cleaning solution is full and this is the same problem I had with my last Bissell steam cleaner, which I assumed was just that I had it for a few years, but this cleaner is only over a year old.


Every line has an O Ring at each end. inspect each one by removing the O Ring for nicks and cracks. Lubricate the with Vaseline and reinstall if ok so they will hold the prime to pump and vacuum up Your leaking O rings will draw air causing your p ... Bissell Vacuums

My steam blaster S3350 will not heat up when I fill in with the correct amount of water. Tried it plugged into other electric sockets & still have no steam.. The red light always came on when heating, now as soon as the power is on the yellow light comes on, & no results


... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have bissell Model 1697 Powersteamer Pro. i filled bucket up with water and no water is releasing when I try to steam clean, carpet is dry.Am I filling it up correctly, manual lost. Is there a way to view the online manual.


The pump belt may be worn and that is why it is not dispensing water. Here is a link where you can get the belts and you can view the manual: ... Vacuums

My steam vac leaks water quickly out of the tank all over the carpet even when the trigger isn't touched. I checked that all the hoses were properly seated. What do I do next?


Might have a problem with a faulty gasket or the inlet valve on tank ... Hoover Vacuums

X5 mop water keeps streaming out of the pressure release valve and not a lot steam coming out, how can I fix this I have not over filled the tank dont know why it has started doing this, any help appreciated


... H20 x 5 Mop

My hoover steam vac is losing all the cleaner and water out of tank the trigger isn't stuck


You will need a resevoir. This is the valve that the solution tank sits on when put on the machine. If your exact part number is not available ask to look at another model series, you may get a different colo but you will have a working steam cleaner ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I recently purchased the Bissell Proheat Clearview from a flea market. Used once for a demo. I tried to use it yesterday, and while the handheld upholstery attachments work like a charm, the scrubber itself does not release any water when the trigger is pulled. Any suggestions?


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 8910 ProHeat Clear View Upright Vacuum

My brand new Hoover F914-900 steam vac spin scrub will not release the water. I have tried all of the trouble shooting advise in the owner's manual.


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

We bought a Philips Intellicare 8030 ironinng system in 2005. Two days ago water from the plastic water container does not go inside bigger water tank where we think the water gets heated up. When the heating tank is empty there is no steam that comes out of the iron. Also, there is water dripping off profusely from under the iron where the steam normally comes out. Can you please advise how we should remedy this problem Please advise which service centre in Sydney, Australia would we be able to


... Philips Vacuums

I have a Thane h2o mop ultra, I added some bleach to the water tank to clean better, the unit worked for a while, enough to clean 1 room, then even if the tank is still full of water the steam is not


... Vacuums

Bissell pro heat steam carpet cleaner, not releasing water.


That means that you need to replace the pump belt. Here is the belt you \012need and a manual you can view:\012\012Bissell 7901 Belt and ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0676 seconds