Having problems with your Vacuums ?

My zanussi 1829 bagless vaccuum cleaner cuts out

\015 Put new fuse in plug works a bit then blows\015

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My zanussi 1829 bagless vaccuum cleaner cuts out


... Vacuums

I have a Zanussi 1700W bagless upright vacuum cleaner which keeps cutting out after about 5/10 mins use. I had to replace the rubber drive belt which snapped not long after purchasing and it was fine for a while, but now its just keeps cutting out after a small amount of use. Nothing wrong with belt which is still intact so we don't know what the problem is. It's a great cleaner otherwise - but it's driving us mad!! Please help!


... Vacuums

Last year my wife and I bought a new Dirt Devil Reaction All Surface vaccuum cleaner to replace the older Platinum Force. After using it a couple of times the new one gets clogged with dog hair easily and shuts down. I cleaned it out completely including the hepa filter but it will not handle the dog hair. The old one never had a problem and still works. We went back to using the old vaccuum cleaner because we can not find the receipt and had not registered the new one and are stuck with a new 1


Greetings jettin_us,\015\012\015\012Normally you can contact the store you purchased the unit at, and if you paid with anything other than cash, they may be able to retrieve your receipt for you. \015\012\015\012Once you get t ... Vacuums

When I sart to run my bagless vacuum, it runs for a second and then shuts off. I replaced the belt and the filter. The repairman told me that on bagless vaccuums, the motor and bearings get clogged w


Take the brush roller off and on the ends are the bearing caps.try to take those off and clean the bearings ,carpet strands and hair will cause that.after you do that make sure the roller turns freely if not then the bearings might be bad and if that ... Vacuums

I have an Alba Vacuum Cleaner model AVC1502(Bagless cyclonic cylinder 1500w) I am in desperate need of a filter cover. As I have severe arthritis this vac cleaner only weighs 5.1kg(not able to lift much weight) please I need help tracking down the filter cover, perhaps a later model may have the same cover, need all experts assistance thanking you sincerely for any help that can be offered. In anticipation Dee


Www.searspartsdirect.com ... Vacuums

My Hoover Steamvac Widepath will NOT pickup the water after dispensing. I checked the hose inside the cleaner, there was a cut in the hose so I put electrical tape and completely sealed the cut. Still will NOT pick up water. I can't find any other problems with the hose. Any suggestions?


HelloHere are some suggestions you might want to follow to solve this problemFirst double check if there are other cuts in the hose or any sort of blockage or clogging in the hose and be sure to remove any form of debris ... Hoover F6213-900 SteamVac Agility TurboPOWER Steam Vacuum Vacuum

I have a nearly 9 year old Electrolux Excellio Z5228 vacuum cleaner. It has recently started cutting out during operation. I cleaned the micro filter (between bag & motor) via brush & hitting against wall & seems / looks quite clean. I washed the gore filter (output from motor to clean the exhaust air) as per instructions, then let to dry. It was very clogged but now very clean. The vacuum clearner still cuts out often. Even after a long rest (say overnight) it still won't start, then ano


... Electrolux Vacuums

Z4700 series vitesse+petlover. Cleaner is 20months old and cuts out after about 5minutes use. Have tried the recommended remedies -- empty dust container, cleann filter check for blockage but still cutting out as if overheated. Would be glad of some advice! Mrs K Black


... Electrolux Vacuums

I have bagless samsung air track 2000w tein cleaner vaccume cleaner..it has only one switch for on and off...cant find a switch to put the cord back????? .


... Vacuums

I have an Alba Vacuum Cleaner model AVC1502(Bagless cyclonic cylinder 1500w) I am in desperate need of a filter cover. As I have severe arthritis this vac cleaner only weighs 5.1kg(not able to lift much weight) please I need help tracking down the filter cover, perhaps a later model may have the same cover, need all experts assistance thanking you sincerely for any help that can be offered. In anticipation Dee


... Alba Vacuums

My brushes do not turn on my power glide pet vacuum cleaner after I accidentally sucked up the hem of a curtain. I switched off the machine then removed the hem. Now when the vaccuum cleaner is turned


... Electrolux Vacuums

Homewell vacuum cleaner, bagless Model SKU3358 won't pick up via the floor brush. Seems to have plenty of suction in the hose. I have cleaner filters & checked there are no blockages.


... Vacuums

My bissell power force bagless model 6594-w vaccuum is not sucking up when vaccuuming but if i use the hose it works


Remove the bottom plate that covers the brush assembly and check the air passage that goes out where the vacuum is jointed between the vertical parts and the sweeper head. Look for any clog in that area. A bent hook on the end of a piece of coat hang ... Bissell 6594 PowerForce Bagless Upright Vacuum

Dear tech, I have a 12amp bissel bagless cleaner model# 4220-P the part i need is under the foot lever to lower the vaccum cleaner to sweep. The part is the slide pin that locks the sweeper from lowering.It has a spring attach to it. can I buy this part bob Yurkovich


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=805734\015\012Generic problem for all Vacuums\015\012Dear tech, I have a\015\012Posted by yurk on Jul 1 ... Vacuums

I bought a Eurolab Bagless Vacumm cleaner from Deals Direct in April 2008 On the 21st September a strong smoke smell ocurred and sparks from the filter end of the cleaner I need to have it repaired but do not know where to take it I live in the Eastern Suburbs of Sydney Thank you Alfredo 0421 463 832


Hi Alfredo,I'm a Customer Service representative at Dealsdirect.com.au and we'd like to offer our assistance. Unfortunately, we don't have a specific repairer we can refer you to however, if you would like to send us an email ... Vacuums

My Panasonic MC-E3001 vacuum cleaner works for a few minutes & then cuts out. I changed the bag & it worked again for 2 minutes but then cut out again.The pipe that sticks out of the side has a clip on it but it doesn't seem to be holding anything.


... Vacuums

I have a Panasonic MCE6003 vacuum cleaner. I regretfully leant it to a neighbour and it came back full of dog hair and keeps cutting out. I cleaned out the dust container and the main filter but it still kept cutting out after 5 minutes. I decided to unscrew the part with the motor and wash the filter inside.It was all going well until a large rubber washer bit, a piece that looks like the thermostat and a little white button attached to two black wires fell out and now I have no idea how to put


... Panasonic Vacuums

Is there a diagram/picture to help me visualize how to put cleaner belt back in vacuum? I was taking base of vacuum apart so I could get rid of hair that were wrapped on the roller. The cleaner belt came to loose and I could not figure how to fix it back. the model is eureka upright bagless series 430


Hi,Sorry to hear your belt fell out. Not good if you've never replaced a belt before...Here is a website where you can read a detailed description of how to change a belt: http://www.ehow.com/how_8034505_eureka-belt-replacemen ... Eureka 431A Optima Bagless Upright Vacuum

I have the Bissell upright cleanview bagless vacuum cleaner. My belt broke and someone else took it off. I bought a new belt but do not know where it goes on the cleaner. Please help


Easy to do. Unplug the vac. Turn the vacuum over and look for three finger latches on the bottom behind the brushes. Unlatch these and pull the faceplate off. Then, grab one side of the brush and pull straight up (they just sit in grooves on the ... Bissell CleanView 3596 Bagless Upright Vacuum

Zanussi steam cleaner


... Vacuums

Sebo vacuum cleaner cuts out ?why


It might be the bag.just check with your local vacuum store ... Sebo X4 Bagged Upright Vacuum

Kirby Vaccuum Cleaner:


Likely a broken belt. turn vac over and see if roller turns free. if it does the belt is broken. turn the handle on front of vac. turn latch under headlight and remove head. open bottom plate and return handle to normal position. belt and brush roll ... Kirby Vacuums

Miele S326i Vaccuum cleaner hose broke


Any miele warranty center can help you with ordering a new part, look on line for close center. Or try main office. ... Vacuums

Where can I buy a spare hose for my electrolux bagless vaccumm cleaner Z4009?


... Electrolux Vacuums

Nutone CV556 Vaccuum Cleaner -Continuously running


Start with this. Unplug the vac to shut off, then disconnect the low voltage wiring at the vac.Plug the vac back in. If the vac still runs you have an internal short on the relay or wiring inside the vac. If the vac stops then the vac and final ... Broan-NuTone CV556 Cyclonic Bagless Central System Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0743 seconds