Having problems with your Vacuums ?

Loss of suction when using upright. Suction remains for samll tools

Answers :

Over 21 years repairing vacuum cleaners, I have removed yards of duct tape,surgical tape and package tape from hoses.wands and cords. I have found the best repair method for torn hoses is a product called "Stretch and Seal". This is a silicone-based tape that has no adhesive, but adheres to itself as it is stretched around the hose. If there are any breaks. debris will not stick, because there is no adhesive. Because it literally becomes one with the hose. this is a permanent repair. The one caveat is that the applied surface must be clean, with no grease or loose dirt. At $7 a roll, it is not cheap, but saving upwards of $100 or more on a new hose is worth the expense.
I checked all the pipes and seals. There is a flexible pipe which you can see underneath that connects the front rotating brush assembly to the vacuum system. This pipe can crack and loss of suction occurs when using it upright. The pipe can be repaired temporarily with strong fabric sticky backed tape (e.g. carpet seal tape). A new pipe can be fitted with a few tools.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loss of suction when using upright. Suction remains for samll tools no suction when in upright position makes funny noise but ok when not used in that position kindest regards louis

U can remove the flexi pipe by pressing the inset button,it may be bit stiff if it had not being removed before.may be something is stuck at the bottom,also remove u bend where most of the stuff get stuck. i just posted how i fixed the suction and ... Dyson DC15 All Floors - The Ball Bagless Upright Cyclonic Vacuum

Loss of suction when using upright. Suction remains for samll tools

Over 21 years repairing vacuum cleaners, I have removed yards of duct tape,surgical tape and package tape from hoses.wands and cords. I have found the best repair method for torn hoses is a product called "Stretch and Seal". This is a silicone-based ... Vacuums

When using my vacum upright its very low in suction, it used to be so powerfull that it lifted my carpet slightly....when using the tools section its as strong as it should be please help, ive cleaned it out but still loss of suction in upright position, from mrs richmond

Check the following items:\015\012\015\012* The bag and connection - change it if it's full\015\012\015\012* Turn the vacuum over and inspect the beater bar area for any clogging. You may have to remove the bottom plate to ... Vacuums

No suction whether I'm using the tools or using the vacuum upright, there is no suction. I have checked the hose to make it is not clogged- still no suction. What is the problem?

Your intake hose might be clogged at the bottom ,it the clear hose that comes up from the bottom .you will see it from the back.take the dirt cup off there is a filter inside that most likely is clogged ... Dirt Devil M086700 Vision Bagless Upright Vacuum

My upright kenmore progressive vacuum will not suction up when using the sweeper. It will suction things when I use one of the tools. I have put in a new bag and have tried to see if anything is blocking the bottom. It sometimes makes a very loud noise when I try to vacuum. If I press the intell clean on and off yellow button the noise may go away but it still does not work.

Double check hose placement, making sure you have the hose inserted into the correct slot. The long attachment nozzle stores in the front hole on the right, and the sucking hose inserts into the rear hole on the right. I know this is too simple of a ... Vacuums


... Vacuums

My dirt devil upright dynamite vacuum does not pick up when i vacuum the carpet but the hose has good suction when I use the tools...what is wrong with it..

That means that your belt is worn, stretched or broken. You need to replace the belt. You can get replacement belts and view the manual:Dirt De ... Dirt Devil M084600 Dynamite Bagless Upright Vacuum

Sudden loss of suction. Using a dirt devil upright. Checked the belts that were changed recently and working. Changed the half full bag. No change. Checked for blockages and as far as I can see there are none. The blower is working as much as it ever was I think but I;m stumped.

R u sure there is nothing cought in the hose? ... Dirt Devil Featherlite Bagged VacuumVacuum

I have the Hoover upright windtunnel and have used it only once. It worked wonderfully the first time but now only the hand tool has suction. I can't find the book that came with it though. How do I get the main vacuum to work?

Seems like you must have suction at th hose. The either a belt came off or it is plugged up at the dirt inlet by the brush roll. Some Hoovers have a spring loaded door that opens and closes depending on whether the handle is down or in its upright ... Hoover Vacuums

My Dyson upright is not picking up like it used to. The suction from the tools is very strong and the beater bar is turning and clean. Please help

... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Hi when i use tools to clean stairs etc loss of suction have checked tube seems ok.........

First of all, are you using a extended piece on the hose? if so then you should feel around where the hose and extended piece are see if air is leaking ... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum

Loss of suction on hand tools (DC07) - Dyson DC07 Bagless Upright Cyclonic Vacuum

It sounds like there's probably a clog in the hose. Drop a small coin or marble down the hose and see if it falls through. There's going to be a loss of suction in the power nozzle too, just not as noticeable when vacuuming carpet.\015\012The ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Loss of suction in my Hoover Windtunnel bagless selfpropelled upright

There's also the possibility that the fan/impeller has stripped loose from the motor shaft and is basically sitting there while the motor turns. Also, you may have broken vanes on the fan/impeller that will drastically reduce the suction. Replacemen ... Hoover Self-Propelled WindTunnel Bagless Upright VacuumVacuum

Suction using dyson normally is fine,but when using tools its as if the suction has reversed and there is no suction for the tools

... Dyson Vacuums

I have a Bissell 9500 proheat 2X cleanshot w/dry Aire it works great on cleaning carpets. When I try to use the tools it will spray but will not suction. How can I get the suction to work when using the tools?

Ensure the handle is in the upright position and the selector is on tools,Please take the time to give this solution a fix ya ratingclarkco ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

After using my attachments I have a hard time getting suction when using upright again - how do I get the suction on my upright? It's a Hoover blue widepath Tempo~ thank you

It may be clogged underneath the vacuum where the roller is. Take the bottom plate off and look into the intake port. There may be some blocking the port. ... Hoover Tempo Widepath Upright Vacuum - Blue

I don't have any suction when i use the vacuum, if i use the tools adaptor i still have suction. how do i get the suction back to the vacuum?

Plugged lower,, hair,, carpet etc. ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

Loss of suction when upright

Check the Rubber Air seals and bottom Hose for splits. ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Ive got powerful suction from my wand when i am using my dyson upright, so the suction on the bottom not good

... Dyson DC07 Bagless Upright Cyclonic Vacuum

My dyson seems to have lost its suction therefore is not picking up anything yet i have found that when my dyson is standing upright it has a little more suction but nothing like how it use to work. This has only happend in the last 2 weeks. I sanded a floor & though the sander picked up majority of the dust i did use the dyson to pick up the excess and it is since then that my dyson has not been working to its full potential.

Hi there,\015\012\015\012Sorry to hear you're having a problem with your DC07. You should be able to resolve the issue by following these simple steps: ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My eureka optima upright bagless vaccum has VERY low suction using the floor part. the hose has excellent suction. i removed the little translucent door underneath and there were no blockages, i cleaned the brushroll thoroughly and that hasnt helped either. i know this probably isnt recommended but i turned it on to the floor setting with the brushroll off and stuck my fingers up the intake as far as i could, the suction was good further up but it just seems to stop down at the base. because i s

I will try and help here. Is the sole plate on the bottom of the vacuum complety on and there are no visible cracks along the seam where it meets the body? This is the usual cause for this. Onc you take of the plate to access the roller and brushes, ... Eureka 431A Optima Bagless Upright Vacuum

Need manual for Eureka Powerline Plus Model 9730 Type A - missing "door" that covers tool access port on body of upright motor...any ideas? This causes dirt to fly out unless tool hose is placed in "port"--don't always want to use tools, just main vacuum.

I found it at www.vacpartswarehouse.com for $4.79 + sh ... Eureka Powerline LiteSpeed 5845 Upright Vacuum

No Suction I have very little or no suction on the cleaner. It suctions o.k. with the hand tool, but not the upright cleaner.

Between the top edge of the clear noozle and the lip of the tank that sits on it, there should be a black oblong gasket, if missing, you will have no suction there. The other is the filter on the tank lid, is it clean? ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

My Dyson DC14 Animal doesn't have the suction it used to. The piece in the back on the bottom - a flap it appears - stays open now, causing the machine to make a louder noise than usual. At first, if I put my hand on the flap opening it would close, allowing for normal suction. Now, it stays "open" permanently", causing the loss of suction.

Hi its Darran at Dyson.Having had a look at a DC14 here, I am unsure as to the part you are referring to. So that we can help you further, please contact our Helpline free on 0800 298 0298, between the hours of 7am - 10pm, 7 days a week. ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

No suction my riccar 8850 has no suction. I cant find any clogs and there is some suction on the hose when using cleaning tools but when hooked up to the vaccum bag it wont clean

Replace your belt. Remove the baseplate, remove the brushroll, place a new belt around the motor pulley, then around the pulley on the brushroll, and pull the brushroll back into place in the nozzle. Spin it by hand to make sure it spins, (otherwise ... Riccar 8850 Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0978 seconds