Having problems with your Vacuums ?

How to pull apart a hoover core-plus - Vacuums


Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to pull apart a hoover core-plus - Vacuums


... Vacuums

Hoover core plus vacuum cleaner manual - Vacuums


... Vacuums

Taking apart hoover core vacuum - Vacuums


... Vacuums

Pull apart vacuum head of a hoover hygiene PB4


... Hoover Commerical Conquest C1119-080 Vacuum

Hoover WindTunnel S3765. The motor spins and the belt turns when I turn the brushes on, and the brushes will spin. The problem is that when I do this on carpet, the brushes stop spinning. As soon as I pull the "head" off the carpet, the brushes spin again. It's almost as if the vacuum suction is too great. I took the head apart and watched the motor turn the metal spindle that the belt rests on, and the belt turns as well.


The belt is stretched and needs replacement.(Belt # 38528036) . The brush is not turning against resistance. ... Hoover Vacuums

Remove a marble from inside a hoover core plus vacuum cleaner


... Vacuums

How do I take the Hoover Spirit canister vacuum apart to unjam the power cord? The cord is stuck and I can't pull it out.


... Vacuums

Vacuum, Hoover Elite 350. Rag sucked up how to take apart


... Vacuums

My hoover vacuum runs for about 10-15 minutes then the saftey feature shuts it off(overheat?). i have taking it apart a cleaned it with no results, added new bag also. after an hour it cools down and works again. do i just need a new vacuum?


Do you have suction through the tools? Does it look like it picks up when it runs? The machine could be clogged and that would cause the problem, but unfortunately the sensor that shuts the machine off could be bad if the machine isnt clogged. Its no ... Hoover Ultra U6430-900 WindTunnel Bagged Upright Vacuum

HOW TO EMPTY FILTER - Hoover Fusion Plus Cyclonic Upright Vacuum Vacuum


Here is the manual > http://hoover.com/file/445/ enjoy ... Hoover Fusion Plus Cyclonic Upright Vacuum Vacuum

I bought my Hoover...U5180-910...@ my local Wal-Mart. It is literally falling apart. The sweeper has NOT been abused. Yes, we have 2 cats & a dog but the problems I am having w/ it should not be warranted. The handle has broken. The wheel/roller on the bottom of the machine has broken off & now it has just stopped working. I repeat, this vacuum has NOT been treated badly @ all. I can not be w/out a vacuum. Thank you for your help, hopefully. Debi


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=729453\015\012Generic problem for all Vacuums\015\012I bought my Hoover...U5180-910...@ my\015\012Poste ... Vacuums

REPLACE BELT TO BRUSH - Hoover Fusion Plus Cyclonic Upright Vacuum Vacuum


... Hoover Fusion Plus Cyclonic Upright Vacuum Vacuum

Very little suction from vacuum is occurring after I pulled a string from the roller. Hot air is blowing out of unit. Was working fine until I pulled out a string...Suction is occurring from wand.The brushes now make a loud sound too when activated...do I have to take the unit apart to readjust them or something?


Yes re adjust ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Where can I get a filter canister door - Hoover Fusion Plus Cyclonic Upright Vacuum Vacuum


... Hoover Fusion Plus Cyclonic Upright Vacuum Vacuum

Hoover core vacuum cleaner. My son has vacuumed water into machine. will this ruin it


Allow it to dry dry for sometime , clean all the filter after keeping it open, then run it open without any attachments , the bag or the filter till all traces of water/moisture goes off. I dont think there will much of problem unless it has gone int ... Hoover Vacuums

Folks, My wife and I own a three-year-old Hoover U6434-900 self-propelled "Wind Tunnel" upright vacuum cleaner. The problem is that, even on the highest setting (front-end as high as possible), it gets bogged-down in even shallow pile carpet to the point that the brush stops. I've cleaned the machine thoroughly, pulling hair, thread, dental floss and such from the brush (and everywhere else), including unscrewing the brush end caps and pulling out the cat hair mats which formed in there.


Check to see if the V belt sits too deep in the brushroll groove, if it sits too deep you will need to replace the brushroll. the top of the belt should be about flush with the brushroll. also you have to take the screws out of the self propelled uni ... Vacuums

I have a Hoover Tempo plus attached tools vacuum cleaner, 12 amps, Model #S2541, Series J3.6 and I do not have instructions on how to use it. Can you e-mail me the instructions for this vacuum cleaner? Thanks!!!


... Vacuums

Loss of suction - Hoover Fusion Plus Cyclonic Upright Vacuum Vacuum


Check the hose and plugged filters. ... Hoover Fusion Plus Cyclonic Upright Vacuum Vacuum

Hi. I borrowed my friend's Hoover VC340 to clean my house. I was vacuuming when i noticed the cannister was full, so I turned the vacuum off, pulled out the barrell, and followed the instructions on the barrell to empty it. I put it back into the machine, but it wont turn back on. I tried different power outlets, but to no avail. any thoughts?


... Vacuums

I have a Hoover Turbo EmPower 4600 and the roller will not turn when we turn on the vacuum. The vacuum is fairly new, and hasn't seen too much use, but now the roller won't turn, so it's not picking anything up. There also doesn't appear to be a belt or any way to take this apart. Can you help me? Thank you!


The beater belt is broken. There are 4 phillips head screws on the outside (2 on top of the base on either side of the upright, and 2 on the front edge on the underside of the base near front edge). and 4 phillips head screws on the inside (holding ... Hoover Vacuums

My hoover 600 elite is really load. I took it all apart to find the motor fan is damaged with a broken off piece which must have been vacuumed up into the bag. If I replace it sith a new plastic fan will this quiet the vacuum? right now it is tremendously loud.


... Hoover Elite U5061-900 Bagged Upright Vacuum

Hoover tempo plus attached tools manuel - Hoover Tempo Widepath Upright Vacuum - Blue


... Hoover Tempo Widepath Upright Vacuum - Blue

I need to replace the cord on the beater brush attachement for s3614 hoover powermax.. can't find parts. I was able to pull apart the brusher, but I cannot release the wire to resplice and reconne


... Hoover S3614 Vacuum

I want to take apart a hoover core vac


... Hoover Vacuums

V-belt flapping on Hoover Self-Propelled WindTunnel Bagged Vacuum


... Hoover U6441-940 WindTunnel Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0829 seconds