Having problems with your Vacuums ?

My henry hoover will not switch on - Vacuums

Answers :

If you have an elcrical tester you can verify that your source of electricity is in fact working.
next test that the power is getting to the switch.
check that the switch is working properly.If you have power all the way to the motor but it still is not working, then its a safe bet that your motor and/or the capacitor is bad
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My henry hoover will not switch on - Vacuums

If you have an elcrical tester you can verify that your source of electricity is in fact working.next test that the power is getting to the switch.check that the switch is working properly.If you have power all the way to the motor but it sti ... Vacuums

Rewireing a new switch diagram on henry - Hoover Vacuums

This video may help you ... Hoover Vacuums

Hoover Upright Vacuum model U5470-900 - The On/Off switch on the handle does not properly engage the power switch deeper in the handle assembly. It appears to ride over the lower switch and doesn't engage it to operate it. If I play with it, I can get it to maybe turn on the vacuum, but, then the upper handle switch won't turn it off. Our current workaround is to use the power cord for on/off operation.

... Hoover Vacuums

My Hoover Windtunnel Ultra U6425-900 began shutting off after a few minutes of vacuuming. The time interval became shorter and shorter. If I leave it sit a while, it will start again. This does not happen when I used the attachments - only with the floor brushes. The switch has recently been replaced and the whole vacuum serviced by a Hoover dealer about a year ago. I have been told by a local repair shop(not a Hoover dealer) that it is the motor, there is nothing to do other than replace t

... Hoover Vacuums

When i switch my henry hoover on it works fine for exactly 50 seconds then switches of for approx same time then comes alive again for 50 secs and so on...driving me nuts.

... Vacuums

My Miele vacuum cleaner has the red triangle light on and keeps switching on and off. Is it broken? have been hoovering upstairs and I noticed the hoover had the red triangle light on. I changed the hoover bag but it still kept going on and off. Is this an overheating problem or is the hoover on the way out?

... Miele Vacuums

I have a Hoover Elite Rewind model #uh71009. We moved recently and it was jostled around and the red power switch popped out. I put it back in but it's stuck; it stays either left or right, it doesnt move back and forth. It appears there may be another piece missing from the power switch...all I have is the red switch and a tiny cylindrical metal tube with a spring on one end. This piece fits into the hole on the red switch. Inside the vacuum itself where this goes, there is quite a large cavity

... Vacuums

Carpet/Floor Switch problem on Hoover WindTunnel Vacuum

Well, you have to deal with it, you have to play with this electrical things if you want to fix this problems.\015\012\015\012The good news is, the sources of the problems is the switch already\015\012broken.The first things before you do ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

How to replace switch on a Hoover WindTunnel twin chamber bagless vacuum

... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

Hoover on off switch won't turn off. I have to unplug the vacuum to stop it. I have dismantled the handle and now I can't get the inditation in the handle to fit over the little silver knob. I saw there was an on/off switch under the handle that is controlled by a piece of the handle. #1 question for the manufacturer is why don't they put the switch on the outside instead of having gimicks that turn it on and off... arghhhhhhhh

Don't know what model you have, but sounds like you will need to replace the switch. As far as your question, you will have to contact the manufacture for an answer. We only provide solutions to your problem and a model number would have helped. ... Vacuums

The switch on our Hoover Windtunnel vacuum cleaner is not working. I have located the replacement part on your website...part#Ho-28161067, I've removed the wires from the switch. Is there any trick to actually removing and replacing the switch itself? It seems to be in there rather tight.

No, follow the directions to replacing the switch and you should be good. if you got the kit then splice the wires and replace them with the wires profied and the wire nuts, you should be good. ... Vacuums

Replace on/off switch on hoover vacuum

My wife picked one up on the side of the road that someone had tossed. The power switch would not turn off. I took the two bolts out of the top part of the handle, and then removed the screws along the back. This will remove the required panels to ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Henry hoover wont switch on

... Vacuums

Henry hoover won't switch on

... Henry Numatic "" Canister Vacuum

Wind tunnel by Hoover, vacuum will not turn off by using switch on upright handle. do not see a way to get to switch. modle no. U5458-900

Follow the cord and look for screws inside the bag compartment at the top. a panel should lift off allowing access to switch and cord. If swtch is melted it must be replaced with special hoover switch kit which has new wire and heavier duty switch. b ... Vacuums

Hi, I have the Hoover d14194 bagless pet vacuum..when I switched it on it worked but kept cutting out, I emptied it and cleaned the filters but now it won't even switch on.is there something I can

You could check the motor brushes, if they are worn and check for loose wire connections.Another possibility is that there may be a break in the lead, plug it in and shake the lead, if it starts and stops you have probably found your problem with ... Vacuums

HENRY HOOVER HOT WHEN USEING - Numatic Henry Bagged Canister Vacuum

... Numatic Henry Bagged Canister Vacuum

Hoover windtunnel vacuum overheat switched is set off too frequently and I cannot finish vacuuming the house in one session. Lemon?

Please remember this part is doing a service to you. its basically saying my motor is getting so hot picking up this dirt that i better make him rest before he burns up. in most cases you will find that you either have a clog or your filters need to ... Hoover Vacuums

My Hoover Wind tunnel has even a cheaper on/off switch and now, you can't buy a new one. I used to go to their website which had a wonderful diagram of the 'guts' but now the only parts are the obvious ones, belts, filters etc....I have to vacuum twice a day and I should be the test person cause its on and off on and off, but now for a vacuum I purchased 3 years ago for over 200 bucks and I can't fix it myself really makes me made or do you know where I can get this part? help? if not, I will ne

Have you tried going to appliancezone.com? I go there when I need parts... ... Hoover Ultra U6430-900 WindTunnel Bagged Upright Vacuum

I have a hoover windtunnel upright vacuum, It will not shut off and I have to unplug it to do so. If I take apart the upper handle and manually flip the internal switch it works just fine, only when using the external switch on the handle, wont shut off.

This is a common problem with this machine. The switch has too much resistance to be turned on and off with the switch button and rod. If you put in a new switch, ( # 28161075 ), your problem should be fixed. ... Vacuums

I have an older Hoover Elite Supreme vacuum. When we switched out the bags (using a Type A replacement) the bag inflates and pops the front cover of the vacuum off.

... Hoover Vacuums

Hoover u6425 switch replacement - Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

The roller brush on my Hoover Z700 vacuum no longer runs when you tilt the handle back. I have tested every part that I can: the motor is good; the "magnetic switch" at the pivot point is good; etc. I'm now stumped. Any help or suggestions would be greatly appreciated as I don't want to throw away a $400 vacuum.

Has this not got a rubber belt drive? ... Vacuums

My henry hoover has stopped sucking - Numatic Henry Bagged Canister Vacuum

Screw the pipe off and clean with cold water. \015\012\015\012check dust bag or change, \015\012\015\012check that nothing is abstructing the suckstion from the head & neck. of your hover,\015\012 ... Numatic Henry Bagged Canister Vacuum

Henry hoover problems - Numatic Henry Bagged Canister Vacuum

... Numatic Henry Bagged Canister Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0826 seconds