Having problems with your Vacuums ?

How do you install the bag?

\015 I have a Master Vac 6.5 gallon machine and I don't know how to install the bag.\015

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I had a real heck of a time with the bag installation, because after the pop i zipped it up and started to use it and then the bag of the vac, not the replaceable bag fell off and i kept putting it back on but it kept falling off and when i looked inside the bag to reattach it to the vac cleaner i noticed that the dust was all inside. i haven't even used it that much as i keep it to do the upstairs bedroom only. i love that it is so lightweight and easy to use and i hope that someone can co


Mary, I have some wonderful news for you and your Oreck XL2600 Vacuum, I called 1 800 989 3535 customer service and inquired about your bag attach problem, it seems to be a docking station problem that "may" be warranteed, however if it is missing ... Oreck XL2600 Vacuum

Can't install a bag for my Craftsman 16 gallon shop-vac


Well, good news, you don't need a bag! The trash just settles to the bottom of the bucket and you just dump it out.\015\012\015\012I own one of these -- it has many little operational anoyances -- like wheels falling off, lid popping off ... Shop Vac Vacuums

Have new oreck quest canister and having trouble figuring out how to change vacuum bag. I have the plastic piece that you attach bag to, but don't know where the piece fits into the vacuum. looking for a diagram or manual to see where to install the plastic piece


... Oreck Vacuums

No suction I just replaced the bag, and normally after this I have a lot of suction. Now that I have changed the bag I have less suction that I had before. Not even enough to picj up dog hair. I snaked he hose and checked all of the connections. It seems to have an air leak but no amount of tape will fix this. I cleaned the filer as well with warm water and dried it and re installed but still absolutely no suction. I am ready to throw it out! Any suggestions would be appreciated


1, Does the blower (discharge) side blow bunches of air??Yes: Something is clogged from the bag to the hose end. Try blowing out the hose from the discharge side.Or: The bag is not properly seated. Make sure that the plastic piece is ... Kenmore 23313 Whispertone Bagged Canister Vacuum

I have a Nilfisk GS90 and trying to install the internal fabric filter bag. There is a metal bar. Not sure how this holds the bag in. Trying to find the manual that might explain how to maintain the unit. It is a great vac and is clean to use. Rich


... Nilfisk Vacuums

My eureka smartvac 4870 has no suction at hose or floor. all hoses are clear, filters clean and properly installed. bag not full and properly installed


Your eureka has no suction kuz the vacum hose needs cleaning ... Eureka Smartvac 4870 Bagged Upright Vacuum

How do you install oreck bag docking system - Oreck XL Ultra Bagged Upright Vacuum


... Oreck XL Ultra Bagged Upright Vacuum

Paper bag adapter installation - Beam BMBGADPT Paper Bag Adapter Kit Central Vacuum


... Beam BMBGADPT Paper Bag Adapter Kit Central Vacuum

Installing cloth bag filter on Hoover S2571


... Hoover S2571 Quick Broom Bagless Stick Cyclonic Vacuum

Install oreck bag hanger


... Oreck Vacuums

How do you install the bag?


... Vacuums

Hoover spirt vacum bag installation


... Hoover S3410 Spirit Bagged Canister Vacuum

My shop vac is plugged. The hose is clear. The filter is removed. The filter bag is not installed. It still won't draw a suction. It sounds like it is plugged. The motor whines at a higher-than-usual pitch. What can I do?


Turn off the vac, take the head off of it and remove the filter paper. Inside, there's a white ball (bigger than golf ball, smaller than baseball) that's inside a cage. This is designed to keep water out of the blower when the vac tips over, and sh ... Vacuums

Help hi there. i have a hoover savvy u8172-900 vaccum. the hose has great suction, but there is limited suction on the main unit and the brush does not spin when i try to use the product. we have cleared the brush of any debris and have also installed a new bag. a few days ago, we disconnected the hose to make sure there was not any foreign bodies stuck in the unit...nothing seems to help. any advise?


As the hose fits into the base (if i am correct) the power at the base should be fine, make sure the base is clean and free from blockage,\015\012you say the brush doesn't spin, has the belt broken, if so replace it, (very cheap) and only a couple of ... Hoover U8171-900 / U8172-900 / U8173-900 / U8174-900 Savvy Bagless Upright Vacuum

How do I install a new vacuum bag on my bosch vacuum?


... Bosch BSG71310UC Bagged Canister Vacuum

I have a Shop vac model 90L550A wet/dry vac. Do I remove the cartridge filter when I install the disposable filter bag?


... Shop Vac 925-09-62 QSP Plus Wet/Dry Vacuum

How to install bag on dirt devil 712 - Dirt Devil Vacuums


... Dirt Devil Vacuums

I need instructions for H30 bag and filter installation for Hoover S3332 Telios Canister vac. Where can I find the instructions. I have long since misplaced any instructions which came with the vacucum cleaner purchase


Go to hoover.com,when the page comes up click on customer service at the top then when that page comes up look on the page for product manuals and info,you will get what you need there. ... Hoover Vacuums

How to install Kirby g4 fan - Kirby Generation 3 Bagged Upright Vacuum


It needs to be stripped completly down, if you are confident at doing this then here goes.\015\012It has been a while for me so take your time and some of the steps may have to be completed slightly differently.\015\012Isolate / unplug t ... Kirby Generation 3 Bagged Upright Vacuum

The CV750 stopped working. It will come on sometimes but most of time it will not work. I installed new bag and cleaned filter. Green light on side of unit is on. Switch on side of unit will not make it come on either.


My CV750 comes on but makes a very loud noise. it sounds like something is stuck then it lets loose but the noise sounds terrible and the unit smells warm. I installed a new bag and cleaned filter. Green light on side of unit is on. Switch on side ... Broan-NuTone CV750 Central Vacuum

How do i install a vacuum bag in a bosch vacuum cleaner


... Bosch Vacuums

Install bag in model 116.23613300 - Kenmore Vacuums


... Kenmore Vacuums

How to install KIRBY belt lifter HOOK Assy - Kirby G4 Bagged Upright Vacuum


Hello, saI was trying to help you out here. Maybe this will help some? I was going backto some customers that asked questions in the recent past and even fartherback. It appeared that no one answeredsome of them, So, I thought I would take ... Kirby G4 Bagged Upright Vacuum

Installing roller brush for oreck XL 21 - Oreck XL Ultra Bagged Upright Vacuum


Uh, probably not sure what the issue is, but \015\0121. unplug unit.\015\0122. Remove the multiple screws from the bottom of the unit.\015\0123. remove the bottom baseplate (usually black)\015\0124. the brush roll is now visib ... Oreck XL Ultra Bagged Upright Vacuum

Install kirby belt 301291 - Kirby Ultimate G Bagged Upright Vacuum


I just figured it out myself.\015\012\015\012Thanks ... Kirby Ultimate G Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0346 seconds