Having problems with your Vacuums ?

Vax upright vacuum cleaner blockage blew the fuse but now it has stopped again

\015 A blockage blew the fuse, i thought i had unblocked it but it stoppped again and i have changed the fuse but to no avail, has it got an internal one as well or is it likely to be the motor.....\015

Answers :

Most motors have a thermal protector and it may have opened up. Usually it is right by the motor, connected to the motor.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Vax upright vacuum cleaner blockage blew the fuse but now it has stopped again

Most motors have a thermal protector and it may have opened up. Usually it is right by the motor, connected to the motor. ... Vacuums

Hi. We have a Riccar N2100 vacuum cleaner, which has served us well for many, many years. I'd like to attempt a repair on this unit, and looking for advice and/or a parts diagram to proceed. The unit makes a groaning sound when shut off. The sound tapers off in pitch as the motor and beater bar come to a stop. The sound only happens when the vacuum cleaner is turned off in the normal upright position. The sound does not happen when the lower unit and main housing are both laying flat. I took

... Vacuums

Vacuum cleaner blew the fuse in my house!!

Are you sure that the vacuum motor went bad? If it did, then if would just have to be replace again. Doubt that you would find a different motor other then what belongs in there. If you did it would have to the right size to mount right. Some mot ... Vacuums

I have a Model 116.35922500 Kenmore upright vacuum cleaner. It makes a loud air noise when using the vacuum. I have disconnected and removed the hose to see if anything is lodged in the hose and it appears clear. It makes the noise when the hose is connected. When I remove it, the noise stops. When I place my hand over the hose, the nose re appears. I sounds as though the noise is coming from the fan or internal parts of the machine. So, when there is a load or pull on the machine, it mak

... Kenmore Progressive 35922 Bagged Upright Vacuum

I have a Hoover U3330 001 upright vacuum, while using it today the power suddenly cut out and it stopped working. I have replaced the fuse with a new and tested fuse, but the machine will still not power up. please can you help?

... Hoover Vacuums

We just were vacuuming and it stopped as if we blew a fuse. I checked the breaker and it is on and plugged something else in the outlet with no problem but the vacuum won't turn on. Any suggestions?

You said you checked the main breaker but did you change the fuse in the plug ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Cleaner stop spraying - Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have a Hoover Windtunnel 2 upright vvacum cleaner. During regular use my wife turned it on and it staarted cleaning, then all of a sudden it stopped and then started again then stopped for good. I unclugged the hose, cleane4de the brushes , blew the main filer and still cannot get it to start. The motor seemed hotter than usual. Can you help me? Lenny Rentz e-mail [email protected]

Actually, if you don't have continuity, then you have an open, not a short. ... Vacuums

I have a Samsung SU3352 vacuum cleaner that was working(very loudly) one moment, then stopped. I have checked the fuse etc, but still not working.

... Samsung Vacuums

Vacuum cleaner I am needing to buy a vacuum cleaner - the flooring in our house is mainly oregon pine with loose rugs. I suffer from back problems and find the cylinder vacuums cause a great deal of back strain. I have been told that an upright vacuum is not suitable for wooden floors - I would appreciate any advice, particularly if u know of an upright vacuum cleaner that works well on wooden floors Thank you

Http://geeksquad.fixya.com/ThreadView.aspx?prdid=517227&thid=728380\015\012Vacuum cleaner\015\012Posted by che9 on Jul 01, 2008\015\012I need to buy a vacuum clea ... Electrolux EL7055A Bagless Canister Vacuum

My oreck xl 3800 H2 upright vacuum cleaner does not turn on. It worked fine the last time I used it. Is there some sort of fuse that may have burned out?

Usually no fuse on these.\015\012\015\012Assume the outlet has been checked?\015\012\015\012I'd look at the on/off switch (that is a 2 speed unit, tight?) or the diode the gives the 2-speed choice, or the power cord as my firs ... Oreck Vacuums

My vacuum cleaners has just stopped working. I have changed the fuse, but it hasn't made a difference.

... Morphy Richards Vacuums

I have a kenmore vacuum cleaner model # 116.23612. When the hose is attached to the canister it runs, but if you remove the head to just use the hose the unit stops working. Is the motor dead or is there some type of reset or fuse. Could you please tell me how to test this. If so could you please send me instructions on how to replace the motor. Thank you in advance for your help, Tony

... Kenmore Vacuums

Evoluction 6502z stopped to work - Evolution 6502Z Upright Vacuum Cleaner 6 Stretch Hose

... Evolution 6502Z Upright Vacuum Cleaner 6 Stretch Hose

Eurika Whirlwind vacuum cleaner. Nearly new. Suddenly lost succion.l I cleaned and dried the filter. It developed an odor, then stopped short. I believe the motor may be burned out. Motor is cool, but it won't start. Is there a fuse??t

Look around the nozzle it might have a reset switch ... Eureka WhirlWind Litespeed 5844 Upright Vacuum

Folks, My wife and I own a three-year-old Hoover U6434-900 self-propelled "Wind Tunnel" upright vacuum cleaner. The problem is that, even on the highest setting (front-end as high as possible), it gets bogged-down in even shallow pile carpet to the point that the brush stops. I've cleaned the machine thoroughly, pulling hair, thread, dental floss and such from the brush (and everywhere else), including unscrewing the brush end caps and pulling out the cat hair mats which formed in there.

Check to see if the V belt sits too deep in the brushroll groove, if it sits too deep you will need to replace the brushroll. the top of the belt should be about flush with the brushroll. also you have to take the screws out of the self propelled uni ... Vacuums

My Miele Twist Vacuum cleaner won't get in the upright position. It stops at about 60 degrees

I know this is an old post, but in case it helps anyone newly with this problem... the same thing just happened to my Miele Twist vacuum and I was able to repair it myself. \012\012Problem: vacuum fell gently backwards, went into the fully re ... Miele Vacuums

Brushes stopped spinning - Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Usually that the belt has broken, turn it over and see if the brush rods turns freely. \015\012\015\012There are two belts, one that conects the two rods together, one that drives them. if they both still move together, then it is likely ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My dirt devil vacuum cleaner is not working - Dirt Devil M130000 ''i'' Dual Cyclonic Upright Vacuum Cleaner Vacuum

Please specify whether the vacuum motor does not turn on when you flip the switch or it simply does not have suction. ... Dirt Devil M130000 ''i'' Dual Cyclonic Upright Vacuum Cleaner Vacuum

I fear the motor has failed on my Electrolux Oxygen EL6988D. Just six months after the warranty expired, I was vacuuming when it suddenly stopped. There was no blockage in the tube and it wasn't working hard or long . . . it just stopped. I looked around the Internet and it appeared that many similar Electrolux units have a fuse. I hoped my problem might just be a blown fuse, so I took the machine apart. There are two small printed circuit boards, but no fuse. There is an in-line

Hi,\015\012\015\012I don't think you need a new motor, but please stop testing the machine with live power. It's dangerous and unnecessary. Your tests indicate to me that the motor is fine and your thermal-fuse - I think this is wh ... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

I have a DC 17. In the middle of vacuuming the vacuum stopped working when it was in the upright position. It only works when the head is down and i am using the bar. I can not use the extension bar, becasue when I put the vacuum upright it shuts off. Where is the problem?

Hi there, it's Jack at Dyson.\012 \012 Like most Dyson vacuums, DC17's main suction motor is protected by a thermostat which shuts the machine down if it starts to overheat. This could be due to a blockage, and the filter may also need a wash ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My Oreck vacuum cleaner will only stay on in the upright position. If I try to recline it to vacuum, it shuts off...put it back up and it turns back on. Of course I can't vacuum in the upright position...what do I do?

It sound as if you have a short in the cord or it has come loose from the motor you can take it part by removing the four screws in the buttom of the base plate to see if any of the wires are loose. ... Oreck Vacuums

Miele 5000 vacuum cleaner stopped during use. no lights on

Could be your retractable cord assembly's contacts..push the power on while pulling out the cord. see if it tries to start. ... Miele S558 Red Velvet Bagged Canister Vacuum

Bosch Vacuum Cleaner: I changed bag. Cleaned out all suction hose and hepa filters, however, my 1450 w 12 amp upright vacuum cleaner will die after five minute run - overheating. Please advise.

Greetings from GoVacuum.com,It sounds like you may have a bad thermal switch inside the machine. Most vacuum cleaners have a switch connected to the motor, so if the vacuum cleaner is running hot, it will shut off to prevent any damage ... Bosch Vacuums

I have a Dyson DC14 upright vacuum cleaner that after cleaning out I am unable to stand the vacuum upright so that I can use the tools any idea of the problem?

Normal\012 0\012 \012 \012 false\012 false\012 false\012 \012 \012 \012 \012 \012 \012 \012 \012 MicrosoftInternetExplorer4\012 \012\012 \012 \012\012\012\012\012\012 /* Style Definitions */\012 table.MsoNormalTable\012\011{mso-s ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0952 seconds