Having problems with your Vacuums ?

Adapter for hoselock to nilfisk pressure washer

\015 Hoselock hose pipe with usual hoselock adapter is too big to fit onto the front of the pressure washer and water just gushes out\015

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Adapter for hoselock to nilfisk pressure washer

... Vacuums

Fault Nilfisk Alto pressure washer

See the diagram and repair swtich: ... Vacuums

Where can I get replacement rubber "o" rings for my Alto Nilfisk Dynamic 4350 pressure washer? I can't seem to find any data relating to the size of the rings for the hoses and accessory wands etc

... Vacuums

Nilfisk C120 6-6 PCAD X-Tra Big Accessory Pressure Washer manual

... Nilfisk Vacuums

Fantom vpw46h,house pressure washer.the motor runs,it was setting for sometime started,using it,but never had any pressure besides the house hose pressure, with the motor running,then the pressure startes to work great,while using it the wand hose came out of the pressure washer,i put it back in,now the motor will only run when i try to adjust the wand head but will not produce any pressure and will shut the motor off,it seem like as soon as the wand hose came out of the presure washer and after

... Vacuums


... Vacuums

My Karcher B302 pressure washer runs as soon as it's plugged in, regardless of the switch position and there is no pressure save the increase due to the narrower outlet. Allen keys are too short to reach screws so I can't even look inside.

... Karcher Vacuums

Hoover model U6476910 I was cleaning out the bearing sections of the brush when a spring type pressure washer fell on the floor. I did not see the washer when I took it apart and I can't tell where it goes in order to put it back together. It is very thin and measures about 5/8 inch with an 11/32 inch hole. Frank Nething

Hi frank this sounds like its a compression washer, you normally find these on the end of the roller to even out any movement from side to side, as you look at the hoover's brush head, it should slip into a groove on one side with the roller...hope t ... Hoover Self-Propelled WindTunnel Bagless Upright VacuumVacuum

The t racer on my karcher pressure washer is not spinning round, the water pressure is fine and the other attachments are working.

... Vacuums

Nilfisk 125.3 losing pressure

... Nilfisk Vacuums

Can I get a manual and parts for my pressure washer

The manufacturers web site should be able to offer the manual you can probably pick the part up from them as well ... Vacuums

C120 nilfisk wont give enough pressure cuts out

... Vacuums

Fix euro pro 1300 psi pressure washer

I would take it to a proper repair facility (Sears. I used to work at their Harrisburg Repair Center). They are trained to work on equipment like this. ... Vacuums

I have no power going to my nilfisk power washer

... Vacuums

How do i start the dewalt 3750 pressure washer

... Vacuums

Alto force 5000 pressure washer Q:- The motor cuts out and will not start again, I try changing fuses etc. Eventually it starts again? but for a short while before it cuts out again.

... Alto Vacuums

I need to get a owners manual for a Factory Reconditioned Power Boss 20344R 2,500 PSI 2.3 GPM 160cc Honda GCV Gas Powered Pressure Washer With 25-Foot Hose model # FO20296

HiIf this works I am a hero - is not I am sure I am a zero -but I think this is close enough to get the job done for you.http://w ... Vacuums

The pressure is low all of a sudden. - Nilfisk GD 930 Canister Vacuum

Remove cover and turn on machine placing your hand at the top of the motor. If you are satisfied with the power. Then check the seal around the lid and inside at the top of motor is a rubber casket. ... Nilfisk GD 930 Canister Vacuum

I am looking for a nilfisk c120.2 pressure hose replacement i seem to have looked everywhere

Need to be more specific,is it click an clean tube with tornado nozzel ,or 15m drain&tube cleaner. ... Nilfisk Vacuums

How do I store my pressure washer for winter?

Basically, make sure that it is completely emptied of all water, blow it through with compressed air if you can, and try store it where it is not subject to below freezing temperatures. ... Vacuums

Nilfisk GM 90 motor bearing Hi I have replaced the motor bearing on the GM 90 model but having problem with re fitting the turbyne I forgot the sequence it has 2 turbines and 4 2 inch washers Can you please tell me the sequence it is fitted Thanks,,,Ps the motor is 100% ok now Peter

... Nilfisk Vacuums

I need an owners manual for Karcher Pressure Washer ipx5 hds 945 1.027-881 year 2000

... Karcher Vacuums

We recently bought a Karcher K8.55. The pressure washer part works fine but we can't get the steam cleaner part to fire up. Any tips or hints would be most appriciated.

... Karcher Vacuums

I have a nilfisk E140.2 which needs washers - can anyone help with the assemble drawings inside tge handle mechanism

... Nilfisk Vacuums

Macallister 3 Electric Pressure Washer manual

Manual for mac 3 pressure washer ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0236 seconds