Having problems with your Vacuums ?

How to access cord connection Eureka 3712 B cannister

\015 Hi - we have an old Eureka canister 3712 B. The power cord has begun to break where is connects to the housing of the vacuum. I'm not sure how to access the bottom half of the vacuum to try to rewire it.\015

Answers :

This might be trial by ordeal---you may have to begin taking screws out until the unit separates where you can pull the case apart to get at it--note where screws go if different types etc.

This unit is so old a service manual might not be available for it but you can try to Google the model number with "service manual" to see.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to access cord connection Eureka 3712 B cannister


This might be trial by ordeal---you may have to begin taking screws out until the unit separates where you can pull the case apart to get at it--note where screws go if different types etc. This unit is so old a service manual might not be ... Vacuums

Electrical cord electric cord connection to cannister boby on filter queen is fixed by a plastic grommet or connection - how does this go into place without breaking or forcing plastic part?


It has a **** shell like closure on the inside and can normally be popped out by squeezing with pliers. It will have a slightly oval appearance, you must squeeze it round and pull. ... Filter Queen Majestic Canister Vacuum

I have my vacume electrical cord tangled inside and disconnected (I can see the open end of the connection from the power cord collector wheel! I need to take the vacume apart so get access to the wire inside. I need to know if there is something else to open other than the 4 screws. Your help is highly appreciated in advance.


Since you did not provide a model number for your vacuum, it is difficult to provide any precise directions regarding disassembly.\015\012\015\012However, most vacuum cleaners are fairly straightforward machines, and as long as you unplug ... Vacuums

The power brush floor rug attachment on my Eureka 6997 A Oxygen Canister Vacuum goes on an off as I use it. I replaced the The power cord from the handle has 2 plug in connections: 1 at the handle / upper wand 1 at the lower wand top of the power brush attachment I replaced the entire wand assembly and it worked great for a year or so and now it's doing the same thing again. I was told to keep the power switch on the handle set to off when connecting the power brush attachment or it will bu


This is from the prongs not making a good connection causing an arch inside the plugg causing what looks like rust on the plugg. I would try snugging up the connection by squeezing the female section to get a better connection on the prongs when it i ... Vacuums

Plastic Slides Trying to open Lux 7000 cannister to access cord spool but can't get plastic slides to move even using needle nose pliers. Plse advise.


Use a screwdriver to pry up one end. there's a little nubbie that snaps into the canister, then its just a matter of pulling the strip off.the back part with the rewind has two snaps on top internally. use a screwdriver to pry the back part dow ... Electrolux Lux 7000 Bagged Canister Vacuum

Power Cord I have a Miele S528 vacuum and it has been acting up lately. I often times have to move the power cable around to get it to work. I am sure it is a loose connection inside the vacuum but I am not sure how to access the inside of the vacuum.


Hi There,Greetings,\012This definitely sound like a cord reel issue to me. This is really the \012only problem that I ever see on a Miele vacuum \012 \012 9 times out of 10 the cord reel needs to be changed. If you purchase\012 ... Miele Filtration Guard S528 Canister Vacuum

I need to replace the power cord on my Eureka 2271, and would like know how to get into the connections?


... Eureka 2271 Bagged Upright Vacuum

Meile Solaris. Power cord connection faulty. Unit powers on/off when cord is being retracted/pulled out. Maybe a break in wire close to connection point in vacuum. Or, the connection point itself is loose? The problem likely resulted from trying to use vacuum at furthest extent of cord.


Cord reel likely needs to be tightened. requirs disassembly and large washers installed to keep reel connections tight. Jim ... Vacuums

Miele vacuum Sometimes when I hit the auto roll up cord button or even move the cord, the power vacuum goes off. I move the cord again and it comes back on. I took it apart and looked at the connection from the cord to the auto roller. These are the electrical slip on type connections and are still in good shape. There are no bends in the cord. I air dusted everthing inside, put it together (with no extra parts!). Good news..it powered up so I did not break it, but it still has the same problem.


... Vacuums

My home has a central vacuum system hook-up but no vacuum installed. My friend upgraded his central system and gave me his Eureka Mega Boss central vacuum system and the accessories, including the pow


The power head requires 120 Volts. Some hoses have a receptacle in the handle for the power head plug, and the hose has a cord at the wall inlet end that plugs into a receptacle. Some hoses have a plug at the wall inlet end that plugs into a 120Volt ... Eureka 1810 Central System Vacuum

Cords for an Eureka Oxygen 6992A


Yes, that short cord in the power nozzle can be replaced and BOTH wands should also be replaced, not just the one that appears burnt. If your locan vac shop won't fix it, contact Eureka at the customer service number on the bottom of your vacuum. The ... Eureka Oxygen s 6992 Bagged Canister Vacuum

Have an older model Electrolux canister model. The electric plug is broken so I got a new plug to put on. When I cut the cord to replace the plug, the dang cord retracted into the unit. So how do I get access to the cord area so i can find the end to the cord!


Hi,\012\012You have to open the vacuum cleaner and look for the wire.\012\012It is located inside the circular wheel, where it wind itself up.\012\012Don't be afraid to open it, unless your willing to pay somebody just to install a ... Electrolux Vacuums

I own an Oreck 2310RS upright vacuum cleaner. The cord is too short for my needs. The cord I need is a two wire 25 to 30 foot cord. Where can I buy this vacuum cord and how do I connect it? Thanks, Don


You can buy one at a oreck store but i would tell you to use an extention cord ... Oreck XL2200 Bagged Upright Vacuum

I have an old Friedland door chime (approx 30 years old). It has 5 terminal screws to connect wires. They are labeled 0-4. I removed the chime during remodeling and would really like to reuse it. I did not label the wires and where they connect when I removed it. I can't figure out how to wire it. I contacted Friedman and they were of no help... didn't have information on chimes that old. Can you help with how to wire the chime given it has five connections screws with no labels other t


... Vacuums

Pull cord all the way out vacum doesn't start. Push the recoil switch for a second then it will start. Bad connection or new cord needed? Also how do you reinstall the coil? Thank you.


Greetings,\012This definitely sound like a cord reel issue to me. This is really the \012only problem that I ever see on a Miele vacuum cleaner ... Miele S514 Solaris Bagged Canister Vacuum

Hose disconnected There is a clear circle on the part where the hose connects to the cannister (above the orange ball) that is in a position that has the hose disconnected. I can move the circle so that the hose connects, but it won't lock in that position. Help!


This video may help ... Dyson Ball DC24 Bagless Upright Vacuum

Eureka model 8803 how do replace cord - Eureka 5892AVZ Bagless Upright Cyclonic Vacuum


... Eureka 5892AVZ Bagless Upright Cyclonic Vacuum

TRYING TO REPLACE THE PLUG ON An ELECTROLUX Z5915 1600W vacuum cleaner, IT HAS TWO WIRES from the cord.....BROWN AND BLUE.....BUT 3 POSSIBLE CONNECTIONS ON THE PLUG NOTED N, L and the earth connection.


... Electrolux Vacuums

Need a source and a number for the cannister filter -tried at the Walmart store and now am trying on line... the vacuum label says Eureka ez kleen lightweight upright 12 amp and bagless. We need to get hold of the filters for the bagless cannister sections. We need a source near Belleville Ontario Canada or on line order.


This link may help:http://www.fixya.com/search.aspx?cstm=0&_s=Eureka+ez+kleen+lightweight+upright+12+amp+and+bagless+vacuum+partsJim ... Eureka 421A EZ Kleen Bagless Stick Vacuum

Want to replace connection pipe part #KC92PBZTZV06 that goes into the cannister. Want to seperate it from adapter #4370325 without breaking it. I have the new connection pipe.


... Kenmore Vacuums

Power cord I purchased a new cord. The one on my vacuum is frayed. How do you get to the connection to replace it? Thanks.


May need to break the unit down to replace the cord,there should be some tec screws under the belt cover to remove the motor housing cover, may be two to thee wires. the rest should be simple. ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

Our Winsdor Sensor XP12 does not show any power or lights, I did check the handle connection, it was fine. The power cord has been repaired with duct tape 3-4 x where someone has sucked up the cord, this may be the cause yet it ran fine last time it was used! so I am at a loss, please help if possible.08/31/2010 Steve


Any time the cord has been damaged badly enough to require taping, the possibility or intermittent "opens" exist. This means the wires are in contact much of the time, but will losed contact periodically. Even if it worked fine seconds ago, jigglin ... Windsor SR12 Sensor Bagged Upright Vacuum

The cord on my electrolux Epic 6500 has been pulled too far out and will not rewind. How can I access the cord reel to rewind?


There are two keys holding the body together, underneath the bumpers on the side of the vac. With the bag door open these keys when gripped with pliers will slide forward to release the body panels. Before opening the vac, gently push the ... Electrolux Epic 6500 Vacuum

How do I access the motor to my eureka capture? It has no suction at all but turns on just fine..filters are cleaned and there are no clogs or leaks on the hose....im thinking there must be something stuck in the motor possibly but there are soo many screws that im having trouble removing them all....whats the best way to access the motor to check it??


... Eureka Capture Upright Vacuum Vacuum

Eureka capture vacuum - Eureka 8802AVZ Capture Bagless Upright Vacuum, Telescopic Self Cleaning Duster, Power Paw Turbo With Riser Visor, Dual Powered Edge Kleener, Comfort-Gripped Oval Handle, HEPA Filtration, 15 Extra Wide Cleaning Path, 30 ft. Cord Length, UPC 023169120891 8802


... Eureka 8802AVZ Capture Bagless Upright Vacuum, Telescopic Self Cleaning Duster, Power Paw Turbo With Riser Visor, Dual Powered Edge Kleener, Comfort-Gripped Oval Handle, HEPA Filtration, 15 Extra Wide Cleaning Path, 30 ft. Cord Length, UPC 023169120891 88
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0453 seconds