Having problems with your Vacuums ?

DO you replace a power cord on a d3c rainbow as you do on the d4c ?


Answers :

Here is video witch may help you
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

DO you replace a power cord on a d3c rainbow as you do on the d4c ?


Here is video witch may help you ... Vacuums

How do you disassemble Rainbow D4c to replace power cord? Took four screws loose but unable to see how to get housing loose...


Gently pull on the rubber gasket that seals the water tank to the canister. Although there are more screws under there - they aren't necessary to remove only to replace your cord. It is the gasket that is holding the motor flange and the plastic hou ... Rainbow 75th Anniversary Canister Vacuum

I have a d4c rainbow vacuum, need help replacing the electrical cord


You have to splice them. \015\012Use crimp-on wire connectors (best), or threaded twist-on wire connectors. Do NOT just twist wire strands together and tape wires without using wire connectors . . . that is a NO-NO. ... Rainbow 75th Anniversary Canister Vacuum

Rainbow D4C power switch replacement


As far as I know, that switch with 6 terminals is still available. But if not, I would wire the 2 for the power head and the 2 motor wires together. Then you would have 4 leads to attach. ... Rainbow 75th Anniversary Canister Vacuum

D3C RAINBOW VACUUM POWER CORD - Rainbow Technologies D4 Bagless Vacuum


If you mean you wont to replace the cord this video will show you ... Rainbow Technologies D4 Bagless Vacuum

Replace power cord on rainbow aquamate 2 - Rainbow E series Canister Wet/Dry Vacuum


... Rainbow E series Canister Wet/Dry Vacuum

Rainbow mod. D4C have new on /off switch, 2 black, 2 blue wires. need to connect power cord, motor and carpet sweeper?


Are the wires still attached to the old switch? If they are, hook them up to the new switch in the same, physical way. If they aren't attached, you might take it into a vacuum repair shop- they could probably help you figure it out, if you bought ... Rainbow Technologies D4 Bagless Vacuum

There was a foam piece above the motor of my rainbow d4c power nozzle. When I took the plate off it desintigrated and fell off. Was that supposed to be there? If so how do I find a replacement?


You said "above the motor", so I assume you meant the smaller foam piece located there, and not the gasket seal that is affixed to the inside of the metal bottom plate, (which is what the previous solution responder was referring to).Most ... Rainbow 75th Anniversary Canister Vacuum

Replace power cord for tristar vacuum a101r - Rainbow 75th Anniversary Canister Vacuum


... Rainbow 75th Anniversary Canister Vacuum

From [email protected] -- How to i change the power cord for my rainbow D4C thank you


... Rainbow 75th Anniversary Canister Vacuum

The power brush floor rug attachment on my Eureka 6997 A Oxygen Canister Vacuum goes on an off as I use it. I replaced the The power cord from the handle has 2 plug in connections: 1 at the handle / upper wand 1 at the lower wand top of the power brush attachment I replaced the entire wand assembly and it worked great for a year or so and now it's doing the same thing again. I was told to keep the power switch on the handle set to off when connecting the power brush attachment or it will bu


This is from the prongs not making a good connection causing an arch inside the plugg causing what looks like rust on the plugg. I would try snugging up the connection by squeezing the female section to get a better connection on the prongs when it i ... Vacuums

Replace power cord


Http://www.rainvac.com/schE1.pdf ... Rainbow 75th Anniversary Canister Vacuum

Need to replace the power cord


Pry out the clear plastic covering the Fins going around the body\015\012Surprise no fins in there but there are some screws ... Rainbow E series Canister Wet/Dry Vacuum

Power cord can not find replacement power cord for power brush attachment on kenmore canister vacuum, model #2491290 power brush attachment model # 5491290. i can not even find those model #'s anywhere online, not even partsdirect.com. any help would be great. thanks, david


Call 1-800-948-1358 ask for Buck mon.-fri. 9am-5pm est sat.9am-1pm est ... Vacuums

Replacing Power Cord to Power Nozzle


The height adjust mech. has 2 tabs, that you have to unlock, It also is easier when you tip the power head so as not to puit pressure on the Ht. Adj. wheels. Use a flat blade screwdriver and if you look down bertween the ht. adj. mech. and the elbo ... Kenmore 22812 Bagged Canister Vacuum

I have a Hoover Wind-tunnel Vaccum (Model U5433-900) that needs a new power cord. I am looking for step by step directions for replacing the power cord


... Hoover Vacuums

My dog chewed through the power cord on my Dyson DC15. I have purchased a new power cord and need instructions on how to remove the old one and replace it with the new one.


... Dyson DC15 All Floors - The Ball Bagless Upright Cyclonic Vacuum

Power cord how do you replace the power cord on a G5


Go to Goodvac.com and follow instructions in pictures 1,2 and 3 and then 19, 20 and 21.\015\012\015\012Rocky ... Kirby G5 Bagged Upright Vacuum

A family member recently gave me their Kenmore Vacuum Cleaner (model 35821) and I did not notice that the power cord was missing at first. I tried to look closely at the manual online to see if this was something I would be able to purchase or if the vacuum was no longer any good. Do you happen to know if there is a replacement part for the actual power cord for this item?


Any power cord 17 gauge or lower will work ... Vacuums

Replace on/off switch on rainbow D3 vacuum - Rainbow D3 Canister Vacuum Cleaner Power Nozzle Reset Switch Vac Cleaner Power Nozzle Reset Switch


... Rainbow D3 Canister Vacuum Cleaner Power Nozzle Reset Switch Vac Cleaner Power Nozzle Reset Switch

Need to replace power cord and can't find how to open canister to replace


I had the same problem and could not find the other screws. You need to pry off the power cord retraction button, you will find two more screws under there. It's pretty easy after that!!!! ... Kenmore 22612 Bagged Canister Vacuum

Replacing Power Cord Kenmore Progressive Upright


That actually sounds correct, if it's the model I'm thinking of. As long as you're talking about connecting to the wires that are held in by the wire nuts you should be good to go. \015\012\015\012-R ... Kenmore 23613 Progressive PowerMate Bagged Canister Vacuum

How to remove the bag housing from the handle in order to replace the power cord on a Hoover vacuum U5209-930


... Hoover Vacuums

Kenmore Canister 116.20712007 replace power cord


... Kenmore 22612 Bagged Canister Vacuum

Hoover U5465-900 Power Cord Replacement


Click here to see an exploded view of your vacuum. ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0918 seconds