Having problems with your Vacuums ?

Kenmore upright progressive 400 38912891 roller doesnt pick up hair


Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kenmore upright progressive 400 38912891 roller doesnt pick up hair


... Vacuums

Kenmore InteliClean 116.35923502 Two, I believe unrelated, problems. 1) The InteliClean sensor lights stay amber and red even when the machine is in the upright position and the suction line is disconnected from the cleaner head. 2) There is a lot of vibration and noise in the agitator roller housing. I picked a little hair out of the roller brushes but other than that they were clean. Thank you for any suggestion you might offer.


I had the same problem with the amber inteliclean light continually on. I found the problem to be in the plastic housing that connects the suction hose to the back of the upright section. You have to remove three screws and gently pull ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

Stuck brush roller on Kenmore progressive upright


... Kenmore 22085 Bagged Canister Vacuum

Lever & belt placement in Kenmore Progressive upright vacuum


You are correct. The belt is supposed to go around the peg that is connected to the lever so that when it is on the Floor /Tools setting the belt is not driven by the drive shaft. ... Kenmore Vacuums

Kenmore 318100 Direct Drive Bagged Upright Roller doesnt't turn


... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

I am replacing drive belt on Eureka 4870 upright. Before installing I removed bottomplate and was cleaning out accumulated lint, hair and grit. Found a pair of identical (reciprocal) felt gaskets sucurely inserted above and below the roller brush, and one small loose piece of felt approximately 1/3 inch wide by 1 inch long that came out as I was pulling out debris. It has a slight crease across the middle as though I was not resting on an entire flat surface, but I find no other clues as to wher


If you go to this URL:\015\012\015\012http://www.VacPartsWarehouse.com/Eureka-4870-Ultra-Smart-Vac-s/1928.htm\015\012\015\012in the exploded view of the unit, identifying the parts and look at item 18, I believe it is where your felt part ... Vacuums

I have the upright kenmore progressive with direct drive and the filter canister stops bringing in air and picking up when hose is put into vaccum, when you remove hose and use as an attachment it starts again


Check the hose after the brushes. With this problem there is normally a clog in between where you disconnect the hose (to use attachment) and the brushes that clean the carpet. ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

When using dyson in upright possition does not pick up very well. roller is going round. when you press front to begin hoovering carpets the front doesnt seem to drop onto floor low enough. dont think suction pipe is engaging properly !!!!!!.


Hi Peter, I'm sorry to hear you're having difficulties with your DC07. It sounds as if the internal hose may have become twisted - you should be able to resolve this by removing and replacing it as shown in the video below. Please make sure t ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Kenmore progressive upright, beltless vacuum, the roller w/ brushes won't turn, no belt to chane.


They usually have belts for that kind of thing at walmart! ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

Have Kenmore Progressive Direct Drive upright. Roller not spinning. Have cleaned all debree with no luck. Took apart and discovered white plug disconnected from motor. No visible place to reinsert. Need assistance or skamatic


... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

I have a dyson dc07 upright which no longer picks up lent and hair. The roller brush is not spinning when the vacuum is turned on. How can I tell if it is the belt that needs to be replaced or the clutch and belts?


Need replaced Clutch Assy and Brushbar \015\012\015\012Clutch Assy part no:900252-04\015\012\015\012Brushbar Assy part no:904174-01\015\012\015\012try cleaning all Hose\015\012 ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My Bissell BS3920F upright (similar to the 10N6F) has been working wonderfully for the past 3 years but suddenly seems to not pick up dog hair as well as it used to. It has been pulled apart by my husband to ensure nothing is blocking the hoses etc and when running the suction seems to be there. It seems to grab the dog hair and leave it in a straight line directly under the unit without picking it up. I then disconnect the hose and use to hose to pick up the dog hair. This works well but obviou


Check to see if your brush is not worn down, they do wear with age - compare the length of the bristles with a new one. Replace the brush ir there is a significant difference in bristle lengths. Also check the flexible ben ... Bissell Vacuums

Kenmore bagless upright Model 116 - Kenmore 35912 / 35913 Progressive Upright Vacuum


... Kenmore 35912 / 35913 Progressive Upright Vacuum

I have the Dyson animal upright vacuum. It's 2 years old and now it just isn't working as well as it once did. Suction seems to be lacking - it's not picking up pet hair or much else from the carpet. I have to go over the spot for a few minutes and still, the hair isn't picked up.


You might want to check and see if your cyclones are plugged with hair. this can happen and there is a great site to disassemble and clean the cyclone here: http://www.exonotes.com/content/node/4 ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Kenmore upright vacuums Model 11635922502 - Kenmore 31912 Progressive Direct Drive Bagged Upright Vacuum


What is the issue or problem? ... Kenmore 31912 Progressive Direct Drive Bagged Upright Vacuum

Kenmore bagless upright vacum model 11631100 - Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum


... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

Model #11636923502 Kenmore Upright vac - Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum


... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

My Kenmore progressive vacuum is extremely loud. The airflow and suction seem to be uninhibited, but the noise is loud and frustrating. Should the filters just be cleaned or is this a sign of a different problem? It's a Kenmore Progressive Bagless Upright Vacuum 35912 and we've had it for about four years.


... Kenmore Vacuums

Kenmore Progressive Direct Drive Upright - noise and bad suction


Had the same problem tonight. Took the entire thing apart only to find there was a much simpler solution. Check the small hose that runs from the brush rollers where the longer hose (on the back) attaches to the side of the vacuum. Easiest way to ... Kenmore 31912 Progressive Direct Drive Bagged Upright Vacuum

Kenmore Progressive upright vacuum - how to replace the belt


... Kenmore 33721 Upright Vacuum

Where is the sensor on the Kenmore progressive upright with intelliclean


... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

I have a Royal upright metal vacuum. The roller stopped spinning. I took the roller off and the ends were full of dust and hair. I would like to take the ends of the roller off to clean more -- how do I do this?


... Royal 4000 Classic Bagged Upright Vacuum

I have a kenmore progressive upright vacuum can't find the reset


... Kenmore Vacuums

How to change filter in kenmore vacuum - Kenmore Progressive Upright Vacuum with InteliClean System Slate Blue


... Kenmore Progressive Upright Vacuum with InteliClean System Slate Blue

I just bought a good Sears Kenmore Progressive 300 upright vacuum (116.38812891) today at a garage sale for five bucks. I left my relic Electrolux with the new owners of my former home during a recent relocation. In the interim I bought a Bissel 3750H which I do not care for, and borrowed a Eureka 7685 AU which performs somewhat better. I cleaned up the Kenmore, and though it seems to run well, noticed the drive belt is showing signs of degeneration. I would like to replace it, but was unable t


... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0893 seconds