Having problems with your Vacuums ?

My preclinical vacuum stopped sucking up - Vacuums

\015 \015

Answers :

Is there sound when its on?
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My preclinical vacuum stopped sucking up - Vacuums

Is there sound when its on? ... Vacuums

Unbeknownst to me, someone took the bag out of my Kenmore Progressive vacuum and failed to replace it. I have been vacuuming without a bag for months, and today the vacuum stopped sucking. When I opened up the front to replace the bag, tons of dirt and dust came pouring out. I thoroughly cleaned the vacuum, put in a new bag, but still no sucking power. Just dust coming from the rear vents where one of the filters is. Is the vacuum ruined, or is it a simple solution of buying a new filter?

Sounds like you need to buy a new motor. All that grit and dust will ruin a motor and I'm surprised it lasted as long as it did.\015\012This is where a vacuum that won't run without a bag would have been nice. (Aerus for one) ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

My vacuum cleaner is not sucking. It's overheated and stopped

In this case it is motor problem, you can sort out only by calling the technician. Call the customer care and check out the cost for repair, if it is very high you can go for a new one and be in peace of mind.Thank you. ... Sanyo Performax SC-U126 Vacuum

My oreck vacuum has stopped sucking up things.

It won't turn the brush because the belt is stretched or broke from the heat of sucking something too big up. If you have your service manual it should show you the location of the belt covers to replace it. ... Montgomery Ward Oreck XL Celoc Hypo-Allergenic Vacuum Vacuum

I have a vacuum cleaner model Z5245 and the flexible hose keeps sucking together and stopping suction. This is the bit with the stop start controls on it. How do I repair this or replace it?

If theres a clog, then youll have to remove the entire section of hose from the vacuum and use a non blunt stick - bamboo sticks are excellent for this purpose. Stretch the whole hose out and put the stick down the hose until you can wriggle the stic ... Vacuums

It stopped sucking @ brush stopped turning - Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Usually on this vacuum those two problems are not related, but if you got a lot of stuff stuck in the brushroll and in the suction tube at the same time it could happen. Check the belt to make sure it's not broken. If the vacuum is over a year old th ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

My bissell vacuum cleaner has stopped sucking things up as well as it was when I first purchased it two months ago. It also seems to be pushing more air out than it is sucking up.

With most vacuum cleaners the problem stems from carpet fuzz (especially in new carpet instalations) to build up of pet hair I have repaired several vacuum cleaners & my solution has use a shop vac if possible 15 amps or more clean the hose, check th ... Vacuums

Using a Hoover Steamvac to clean my carpets. It works fine in some areas, but others it makes a clicking noise and stops sucking water. Once I turn the vacuum off and wait a few seconds, it clicks once more and is okay to use again. Certain parts of my carpet this happens so frequently I can't vacuum.

1)clog in the hose or air/tank full you must , need replace or emptied,test the belt for broken or worn.2) noises can be area motor , test for fan blade defective or broken3) You must go http://hoover.com/support/video-instruction-guides/ for ... Vacuums

When the vacuum is on and in the "stand up" position in oder to use the hand held part of it, the top makes a strange sucking sound that it never did in the beginning, But as soon as you use it as a floor vacuum it stops.


Hi good day, I have a Kenmore Grab n Go 12.0AMPS Vacuum cleaner, Model# 116.34722402 & serial#T53601507. The vacuum is now having a problem whereby the rolling brush underneath is not spinning when the vac is on. This has caused it to stop sucking up dust. Could you please advise as to what might be the problem. Thanks in advance for your kind assistance. regards, Clarance

... Kenmore 34722 Grab-N-Go Upright Vacuum

My fantom vacuum stopped sucking stuff up

Most likely there is a clog, either in the 'knuckle' between the power head and the wand, or in the connection where the hose comes into the canister. In either case, unplug the hose and you should plainly see it. ... Fantom Vacums Lighting Canister Vacuum

My Grundig VCC 7650 vacuum cleaner sucking is weak and after some minutes it stops and a red line is up

... Vacuums

A large screw got sucked up the vacuum. Since then the motor,which I replaced probably only 12 months ago, sounds very "winey" and when you stand the dyson upright the front brush still keeps going round instead of stopping. Any ideas? David

Sounds like the clutch mechanism has somehow been damaged.\015\012\015\012Have a look at the following site which is a great source of info on faults, dismantling, repairing and re-assembling:\015\012\015\012 ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My Euro-pro Shark NH15 Ultralite Multi Vacuum stopping sucking up, what would be the issue?

... Euro-Pro Shark NH15 UltraLite Multi Vacuum

Hoover HWD015 wet and dry vacuum cleanerThe safety seal float keeps on getting "sucked up", thus stopping the suction of the cleaner. The dust bag is in very good condition and the filter has been thoroughly cleaned. Any solutions for me please?

... Vacuums

Wife sucked up a nickel cleaning daughters car. Vacuum stopped, smoked before she could turn it off. New motor? Is it worth it? How much is a new motor? Thanks in advance. Jim Troup [email protected]

You can buy a new motor HERE and we will install it with no additio ... Kirby G4 Bagged Upright Vacuum

My henry hoover has stopped sucking - Numatic Henry Bagged Canister Vacuum

Screw the pipe off and clean with cold water. \015\012\015\012check dust bag or change, \015\012\015\012check that nothing is abstructing the suckstion from the head & neck. of your hover,\015\012 ... Numatic Henry Bagged Canister Vacuum

It stopped working while vacuuming. Still getting power, compressor still working but not sucking.

I would look for a clog, or look for a broken belt ... LG Electronics Kompressor Pet Care Upright Vacuum Cleaner LUV200R

The vacuum has stopped sucking things up. The belt appears to be okay.

Hi there,I'm sorry to hear you're having difficulties with your DC28. If it doesn't seem to be picking up as well as usual, it's possible that there's a blockage in the system - I'd also recommend giving the filters a wash.The easiest ... Dyson DC28 Animal Bagless Upright Vacuum

Stopped sucking! - Dyson DC14 Low Reach Bagless Upright Cyclonic Vacuum

Have you emptied the dirt and cleaned the filter? Hope this helps. Good luck! ... Dyson DC14 Low Reach Bagless Upright Cyclonic Vacuum

Stopped sucking after changing the bag - Kenmore Magic Blue 24195 Bagged Canister Vacuum

... Kenmore Magic Blue 24195 Bagged Canister Vacuum

My Bissell 3760-1 has stopped sucking in the roller portion. The grab n go part are working fine. Checked the belt and it looks fine. Did I burn up the motor or a microchip?

Hey Lisa! Sorry you're having difficulty with your Lift-Off vacuum. Here's a link to troubleshooting steps to assist you with the suction.\015\012http: ... Vacuums

Won't start. My son was using the vacuum & Didn't change the bag. The vacuum was making the full bag smell, but the light was't on & it didn't stop. I stopped him, changed the bag, checked the filter, closed the compartments & turned on the vacuum. Nothing happened. I checked to be sure that it was plugged in, that wasn't the problem. I've let the vacuum "rest" for several days, It still won't start. Any suggestions?

There is a reset button at the back of the powerhead. The user manual can be downloaded from the electrolux website, although I didn't find it very useful. There was some info on how to change the powerhead drive belt. ... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

Was vacuuming and it just stopped.

Take the vacuum apart. There probably is something stuck in the tubes ... Dyson DC25 The Ball All Floors Yellow Bagless Upright Vacuum Cleaner

While vacuuming the red light for the bag of the vacuum came on and the vacuum stopped. The bag was no where near full so I replaced it with a new bag - same problem. It vaccumes for a minute or then stops with bag light on. It is the correct bag for the machine - so what's the problem?

I'm assuming this is the Epic 6500 or similar model.\015\012Detach the hose, turn vacuum on. If it runs, place palm of hand against inport hole. If it shuts off the problem is with either the control valve setting or the control valve assembl ... Electrolux Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0932 seconds