Having problems with your Vacuums ?
Vax rapide classic burning stopped working
\015 Stopped working and burning smell\015
Repair Help & Product Troubleshooting for Vacuums
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Vax rapide classic burning stopped working
Burning smell using vax classic rapide
My Vax Rapide Deluxe Upright Carpet Cleaner just stopped working.
Vitamix 5000 stopped working. It stops working each time I use it; while blending I first smell a burning smell and then blender stops and will not start again. After sitting overnight it works again next morning and repeat same process. Any ideas how to repair?
It has an internal thermal shutdown. Let it sit for a while and it will reset itself. You can expedite by putting the motor base in the freezer for a few minutes, or by blowing a hair dryer into the base of the motor. ... Vacuums
Stopped working The cleaner stopped working when my wife was using it there was a noise like a 'phut' and it stopped. There is evidence of some smoke damage inside but I can't find any evidence of burning. Any ideas please?
This is a problem with your carbon brushes, remove old brushes, and check they have not become jammed in there brass sleaves, they are spring loaded.If they are not jammed but less than 20mm new brushes are required, available from most good vacu ... Numatics Numatic Harry Canister Vacuum
Stopped working Was working fine then it smelled like burning rubber, not the belt I checked. It sounds like the motor wants to run then it just stopped but the light is on. What do you think, go by a new one?? This has been a great vacuum cleaner and I can not seem to find a Sharp anywere. Thanks for your time.
Well it could be the motor, if it is it would cost around $80 or so for a motor. May be better to buy new, thre are a number of good brands out there. ... Sharp Twin Energy EC-12TWT4 Bagged Upright Vacuum
My vax rapide xl ultimate v-027y brushes not working..new belt fitted and same problem
Hello i have a vax rarid xl carpet cleaner when you switch power on just makes a buzzing noise can you help thanks ... VAX Appliances Vacuums
I have a kenmore grab n go bagless and I need to know the exact size of the belt, I lost the manual, and I have burn several belts at the bigining of the problem the motor stops and burn the belts I open it and I think it was a little piece of plastic, that cause the problem, but when I put the new belt it looks like the motor works fine,but still burn the belt, I'm using UB-1 #5275 belt am I using the wrong one?
... Kenmore 34722 Grab-N-Go Upright Vacuum
The KP1010 was at rest all winter long. It has worked beautifully before this. It is now working but we can't stop it from brewing. It works but it delivers the water at the rapid cycle. We have water all over the place. Is there a way to fix this?
Sounds like the flow meter is stuck open, letting water keep running. Go to www.krupsusa.com. Then to parts, then pick your model number, this will give you all parts for you machine. Also click on schematics and it will give you a breakdown for your ... Vacuums
Vax power pet 6 has stopped working
My hoover 2000w pets cyclonic stopped working, there is a burn smell coming out off it
... Hoover Vacuums
Stopped working, burning smell
... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
VAX vacuum stops working after about five minuits use then I have to wait an hour before it will work again
The symptoms you describe are those of a machine that is overheating. Almost certainly there is a blockage somewhere, or one or more filters are clogged, thus impairing air flow. Clear the blockage and the problem should be solved.\015\012If this doe ... VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum
My Electrolux central vacuum power nozzzle was working hit/miss and now has stopped working. The metal connectors in the wand and power nozzle get very hot, enough to burn. The metal connectors also
... Electrolux Central Vacuum
My Miele Cat and Dog has stopped working. There was a slight burning smell and then it switched off completely. Also, the bag was a bit wet, so have replaced with a fresh one but still not working. Help!
... Miele Cat & Dog 326i Bagged Canister Vacuum
The brush roller stops turning and I can smell the belt burning, then it will catch and start working normal. I looked under the plate to check the belts and they looked okay and no hang ups of string or anything. The only thing that seemed weird was that the smaller belt that actually attaches and turns the roller is a bit loose. The larger belt is tight but looks like its the one that is burning and causing the smell.
Better to replace both belts the smaller one is stretched out thats whyits slipping ,be sure to clean the old rubber off the motor shaft before replacing the belts.it will cause the new belts to run unevevly and go bad before their time ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
My Shop-Vac 5870400 was working just fine, and then one day while i vac the floor its just stop working, tried to turn on/off a few times, swicth to different outlet. i did even tried to open it, but found no burn or anything that suspicious. i never drop nor used outside, only inside the house for normal vacumm. please help. thanks.
Same thing just happened to mine. My solution is to get another one but a different brand. I think it should have lasted longer than four years of fairly light usage. From what I read, if it does as we both described, the motor is shot and not wor ... Shop Vac 587-04-00 Canister Wet/Dry Vacuum
I have the Kenmore Model 116.36722600 Vacuum; while cleaning the carpets the vacuum all of the sudden stop working; I didn't smell anything burning; it was almost like someone unplugged it. I checked the rollers and I can move it forward and backwards with no problem. Do you think the motor just burned out? Does this vacuum have a fuse that I can reuse? I love this vacuum and would hate to toss it. thank you
I was in the midst of vacuuming with my Dyson Animal when it stopped working. It smelled as though part of the motor burned up (there was hair and string wrapped around the brush so I stopped to remove it). Any ideas on an easy, quick, and inexpensive fix? Thank you!
Hi there,For guidance on clearing any remaining threads or hair from around the brushbar and resetting the machine, please follow the steps shown in the video below. Please note, the brushbar will never rotate when your machine is upright, so ... Vacuums
The vax 5130 stopped working
My Bissell 3760-1 has stopped sucking in the roller portion. The grab n go part are working fine. Checked the belt and it looks fine. Did I burn up the motor or a microchip?
Hey Lisa! Sorry you're having difficulty with your Lift-Off vacuum. Here's a link to troubleshooting steps to assist you with the suction.\015\012http: ... Vacuums
Same here... I have a DC-15 Animal, it was making a clogged type noise and before I had time to react, it stopped working and I smelled burning rubber. I also noticed that the ball was really hot. It's too late to call support, but I intend on doing so in the morning. I've only had my Dyson for a year, so I'm sure it's covered, however, I have no idea where my receipt is. Did they take care of your issue?
You sucked up something that stopped the brush from turning. This made the belt slip causing a burning smell. ... Dyson DC14 Bagless Upright Cyclonic Vacuum
Vax infinity 1900 suddenly stopped working now no power gets to it, i've changed fuse still no power.
I have an infinity nv29 that stopped working while I was vacuuming. According to the manual I was supposed to unplug it for about 45 minutes and then try it again. I waited for over an hour and tried it again and it still won't turn on. Any suggesti ... Euro-Pro NV31 Infinity Vacuum
Vax hoover, it has sucked up a piece of cellophane and stopped working have changed fuse but still nothing anything else we can do
There may be a thermostat at the motor, it is supposed to protect the motor if it gets overheated. It may have opened up and it will have to be replaced if this is the case. You also need to remove the clog if you haven't already done so. ... Vacuums
Can i use any soap in my vax rapide classic - Vacuums
No. Only use detergents (NOT soaps) formulated for use in wet and dry cleaners. ... Vacuums