Having problems with your Vacuums ?

Ive just brought a electrolux 2008 roller iron serial number 40423/0000841. i've been looking for a intrustion book to down load but with no look. please can you help

\015 S/n 40423/0000841\012\012qc no 84000007\012\012prod no 988260056e\015

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Ive just brought a electrolux 2008 roller iron serial number 40423/0000841. i've been looking for a intrustion book to down load but with no look. please can you help

... Vacuums

I would like to see how to change the belts on the bissell 8910 pro heat I have looked for hours now. I saw the book but it mentions and shows nothing on how to replace them. Help please.

Turn the vacuum over so that the bottom side is facing you, remove the 4 screws on each side using a Philips screw drive set the screws and the brush cover aside.- pull brush straight out and you will see the gray rubber band.-replace the ... Bissell 8910 ProHeat Clear View Upright Vacuum

I have lost my instruction book on how to use my Kitchenaid countertop oven/toaster etc. It is Model KC01005ER-1. It has 1400 watts, 120AC and 60HZ. I bought it from costco. I would like to down load the instruction book. Please send me the website by email so that I can download the book.

Check out this site.http://shared.whirlpoolcorp.com/product_literature/search.jsp?siteCd=KAD ... Vacuums

Loose wire ive got a loose wire inside my vax cyclonic 1700w and ive stripped it down but cant see anything and its still not working but it was working when i moved the wire from side to side. Please help

Sounds to me like you have a open wire. There is a break in the wire inside to the insulation and as you move it, it gains and loses connection. You can test it with a continuity tester as you move the wire or just replace it to see if that solves th ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

I have model # EC2T-36 HPF and TCP# 12536Q and I am looking for a repplacement ballast and a light cover but I am having trouble finding the parts department online and the 1-800 number on the fan is a musuem line. So I need help to get these few parts. can you help please? Matt 937-572-2386 Thank you, Matt

... Vacuums

We do not have the instruction book to help us convert to CANISTER pLEASE HELP

Here is the customer service # for Kirby\015\012United States and Canada: 1-800-494-8586 \015\012M-F 8am-5pm (EST) ... Kirby Ultimate G Bagged Upright Vacuum

I can see the height adjuster under my Bissell pet hair eraser vacuum, but it doesn't adjust. The parts don't look like they're touching. It's been iffy since I took it out of the box. Now it doesn't adjust at all. Used only five times. Looks like I should be able to fix it myself. No local repair available. Could you help please?

Http://uk.bissell.com/images/UserGuides/3920E_508.pdf\015\012\015\012This is the pdf manual. If you look at page 12 you'll see that the bo ... Bissell Vacuums

Bissell cm2000 i picked up a bissell powersteamer cm2000 at a thrift sale. I have looked everywhere and cant find a manuel on how to use it. the site given to someone else on this site was not helpful. please help


I purchased a used Minuteman 2400 series buffer/burnisher over the weekend from a store that is closing. The unit is about 7-8 years old. I did not get a manual with this item, can you help me out with this. I would like to read up on it so if I have problems I can look back on it. Even as far as the operation of it would help to have a book for it. Linda

I have this manual available via email. chris321 at gmail. ... Vacuums

I have Hoover whisper Cyclonic. I just opend beacuse it was showing Clogged. I removed all dirt etc from the belt and now roller are not moving round and the smell of burning is coming due to rubber not moving on the roller. I looked at the manual which tells me in cased on roller being Jamed if need to use the stich to reset. I looked all over could not find the switch. Can you guys help me please.

... Hoover Sh40080 Zen Whisper Bagless Multi-Cyclonic Canister Vacuum


Http://www.kirby.com/Portals/S_Africa/homecareproducts.html go to this website and they can help you find bags. Just call the number for South A ... Kirby Heritage II Vacuum

Bissel vacuum My bissel powerforce somehow is loosing its suction Ive no clue why Ive checked for clogs etc. but Icant find the problem please help!!

Take the dirt cup out and turn the bottom of it that will let you get to the filter,there should be some finger twist plates on the top,turn and take it out,there will be a foam cover around the filter,take that off and clean with warm warter,when do ... Bissell 3522 PowerForce Bagged Upright Vacuum

I have a Necchi super utility model sub 22 and have mislaid the parts book. i need anuber of aprts and would like to purcahse this book. Please can you help?

... Vacuums

My eureka Hello im not sure what kinda of eureka it is a friend gave it to us...and I went to change the bag and vacuum and the spinner isnt going...and i dont think its the belt...help please! i looked on the back and it gave me a modle number its 4475

The belt may look ok, but am sure it is stretched and when this happens, the brush roll won't turn like it should. Did you check the brush roll ends to see if they turn freely, if not replace it. ... Vacuums

Hoover SteamVac F7222-900 steamvac Brushes do not spin. Looked at filter as per manual instructions but it was free of lint. Need to fix it, help please? Vacuum was used less than 10/12 times

Solution for Hoover SteamVac (F7452-900) brushes not spinning\015\012Uses the turbine model and same solution would be similar. Root cause is simply the main gear attached to turbine becomes stuck. This problem shoul ... Hoover Vacuums

I bought 2 Euro-Pro Shark steam cleaners Model Sc618HD but there were no instruction books included. Please help. [email protected]

Http://www.sharkclean.com/manual/SC618HD_REV_0804.pdf ... Euro-Pro Shark SC-505 Handheld Steam Vacuum

Theres no spray coming out but theres solution in. ive checked seals, turned off left it and primed it. it works for 1 stroke then im bk to square one again. please help me

You need to check the seals. It is loosing prime after one stroke. I had the same problem and found obstructions causing a seal to leak and allowing air into the sytem. Take it completely apart and clean thouroughly.Also do you have the dial to choos ... Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum

Looking for a Electrolux dealer in South Africa, please help..... or supply web address

Enter "Electrolux South Africa" in Google (or other search engine) and you will find what you seek. ... Electrolux Central Vacuum

I have a Hoover Windtunnel Farrington upright model U6431-900 It has worked flawlessly until last week. The roller brush has stopped turning and I believe it is the belt that has broken but I am not sure how to remove the cover to inspect it and replace the belt if that is the problem. Please inform me how to perform the operation and what I should I look for? Is there a site with a diagram on how to replace said parts? Thanks for any and all helpful info that you can supply me with. Larry

Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=783264\015\012Generic problem for all Vacuums\015\012I have a Hoover WindTunnel\015\012Posted by ... Vacuums

I have a vax cylinder model V-094. Working fine then started to play up. Switch it on and the motor seems to struggle to power up. Kind of wurrs up and down. Was thinking it could be the brushes have worn. Tokk to bits and cleaned her up, took a look at motot and brushes, cleaned them too, back together and still them same problem. Help please, hoover is not old but has done some work really don't want to through away something that can be fixed.

Hi.\015\012\015\012after all you have done I would be pretty confident its the motor thats faulty they are expensive to buy so machine is going to be scrap,\015\012\015\012Sorry.\015\012\015\012 ... Vacuums

Hello! I have a Kenmore Progressive bagless vacuum with the Easy Clean extended life filter. The model number on my vacuum is 34728401. I was vacuuming the carpet when it just stopped running. The dirt sensor light will come on, but nothing else. The belt looks fine, and I don't see anything keeping the beaters from rotating. Help Please!!!

You can have power to the dirt light sensor, but it seems like the motor itself is not using the power supplied. ... Vacuums

Hoover 2000W dust manager cyclone- Have had this for about 2 months and the brushes stopped turning thinking that the belt had acme off turned it over to try to get in to look at belt now the bottom wheels have came off and will not go back on have not lost any bits literally just undid one screw! Please help!

... Hoover Vacuums

My dyson turns on but when i push it to vacuum it makes this awful sound like something got sucked up and caught. i turn it off and turn it over and nothing is stuck. My husband even looked at it and he thinks it's the belt. The belt doesn't turn as loose. Please help.

If yours is one of the DC07 models that has a clutch (there's a knob you can turn, close to the front on the right side - right as you look from behind, that is). Sometimes this problem is cured by simply turning that knob from one extreme to the oth ... Dyson DC07 Bagless Upright Cyclonic Vacuum

When using my vacum upright its very low in suction, it used to be so powerfull that it lifted my carpet slightly....when using the tools section its as strong as it should be please help, ive cleaned it out but still loss of suction in upright position, from mrs richmond

Check the following items:\015\012\015\012* The bag and connection - change it if it's full\015\012\015\012* Turn the vacuum over and inspect the beater bar area for any clogging. You may have to remove the bottom plate to ... Vacuums

I am looking for a filter for Wet/Dry QSP 2.25 (86769 - 50), but can't find anywhere. Please help!

... Shop Vac 925-09-62 QSP Plus Wet/Dry Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0467 seconds