Having problems with your Vacuums ?

Little suction on Bosch formula hygenix hoover

\015 Suction decreased on hoover.\015

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Little suction on Bosch formula hygenix hoover

... Vacuums

No suction how goes it.. my hoover windtunner v2 has no suction through the hose.. it does however have suction from the body, but once i put the canister in, it has very little through the hose.. no blockage in any of the parts.. whats up

Check again for obstructions in the hose. Also underneath where the debri goes when it is being sucked up. Also make sure all your hoses are connected as this could effect the suction. ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum


I took mine apart, cleaned otherwise inaccessible pipes, and assembled\015\012it back (that went well, huh!). The clog was made of human hair and and\015\012other long fibers (carpet pieces, etc). ... Hoover U8143-900 Upright Vacuum

Suction When putting down the salution, my hoover doesn't want to pick it all back up. Very little suction. Any tips to what I can do myself?

Take the recovery tank out, there is a filter on the handle part where the tank sits in, make sure it is clean. Check for any other filters to make sure they are all clean. ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

I have a Hoover Wind Tunnel Self propelled 12amp. There seems to be very little suction. I have cleaned the hoses and filters but still not much suction. any ideas? thanks.

I have the same problem , and Like the the person who asked the Question ,, there is no Blockage ,, Im thinking maybe these filters have a very short life span ,, and even cleaning theses filters with a brush, etc , may not be enough, and could have ... Hoover Self-Propelled WindTunnel Bagless Upright VacuumVacuum

No suction the vaccum sounds like its working and it picks up a little but it does not suction like it did 2 days ago. It is a hoover windtunnel bagless. the model number is U6600-9RM.

Have u checked all of the filters. I know that when not all the filters r clean the machine will turn on but then it will sound louder and still have no suction. Most times there is a filter under dirt container thats sits above motor and if this ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

Have an lg Hoover and the red light on the handle keeps flashing and the blue light on the Hoover is also flashing and then it cuts out. Has little suction with the head on it but better when you take it off. How do I fix the problem?

... Vacuums

Very little suction with my Hoover U5288-900 - Hoover U5288-900 Upright Vacuum

... Hoover U5288-900 Upright Vacuum

Hoover U6476-910 - Very little suction from the bottom

If you haven't already, remove the beater bar. This is accomplished by unplugging the vacuum and turning it beater bar up. Remove the clips or screws that hold the plate on the beater bar and set aside. The beater bar sits in sockets, so carefully ... Hoover U6476-910 WindTunnel Upright Vacuum Cleaner Bagged Vacuum

Very little suction on my Hoover Windtunnel Bagless twin chamber vaccum hose while using the tool attachments

... Vacuums

Hoover 6446 900 WindTunnel Bagged Upright has little suction at the floor brush but plenty at hose if disconnected. It does not seem that there is anything blocking the inlet at the floor brush.

Check for a clog in the brush hose ... Hoover Tempo Widepath Upright Vacuum - Blue

Hoover linx platinum stick vac has little or no suction. Motor/brush operate fine.

... Hoover Platinum LiNX Cordless Stick Vacuum

My hoover U5491-900 is not picking up any dirt . very little suction. i clean every surface of the vacumm. there is nothing stuck any where . and its still not working

... Hoover U5491-900 Bagged Upright Vacuum

My Dyson DC07 has recently been service and was making a clattering noise and very hard to push. We have taken it back and he has changed the clutch mechanism under the base which has solved the clattering, but it is still really hard to push because of the suction. It is even lifting the carpet in one room. Can you tell me what the possible reasons for this could be? One thought we had was that the little rubber wheels on the bottom cover could have worn so the hoover is closer to the floor

On the sole plate you should have 5 little wheels, these are prone to jamming after a while. You should make sure these are not jammed in anyway.\012\012You can release these with a screwdriver, but be careful not to prize too hard as you ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Need A manual for U5025-900 Hoover Sprint vacuum want to check if the filters are correct. Was given the vacuum, seems like there is very little suction for the hose. Any help would be appreciated

Wasn't able to locate a manual, but you may be able to get the info you need from this page:\015\012\015\012U5025900 Parts ... Hoover U5025-900 Bagless Upright Vacuum

I have a Hoover windtunnel T series. Model #UH70105. The system check indicator was almost red so I cleaned the filter. There are no clogs and it vacuums fine without the hose, but when I go to use the hose there is very little suction and all the vacuum dust flys out of the end the hose piece fits into when not in use. Can you please tell me what is wrong?

... Hoover Vacuums

Hoover Elite Deluxe rewind... Air flow indicator stays activated, after filter has been cleaned. Brushes spin, but very little suction. Dirt is not spinning in cup

... Hoover Vacuums

Hoover floormate Gets little to no suction when set to both Dry and Wet Pick up.

First make sure that you are getting suction from the bottom of the \015\012machine. Most of the time the squeegee is worn out which does not allow \015\012it to pick up the water like it use to. Turn over the machine and \015\012inspect \015\012th ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

Dc11 dyson the brush head turns very slowly but when i take brush head cover of (the yellow part) and put my hand over the suction inlet part the brush head turns really fast. Have cleaned out collection chambers eg the hoover bag have washed the sponge with the little pictures of taps on it what now . thanks alan

I have taken the brush heads off and pulled all the hair out of the small gap between the chrome shaft and the plastic gear housing. Then a small amount of 3-in-1 oil into that gap to lube the internals and just a little through the air intake on th ... Dyson DC11 All Floors Bagless Canister Cyclonic Vacuum

I need the recovery tank front panel for the Hoover Carpet Cleaner, i have the tank can i just order the little piece that goes in the front of that for the suction to the recovery tank

Unfortunately its only available as one unit the hood, and suction cover ... Vacuums

Little suction - Hoover Vacuums

Most vacuums have an air intake adjustment. If this intake is opened,the suction is affected. It is on the hose usually and is a simple procedure to turn it to closed. If yours is an upright, there may be something lodged in the machine that keeps th ... Hoover Vacuums

I have a Hoover Windtunnel Model U573-960, the belt turns the bar still has alot of life on it. I have very little to no suction at the end of attachment hose. I replaced filters and looked for blockagaes with no luck.

... Hoover Vacuums

No Problems with suction on hoses, however brush area it seems to lose powe, and has little suction r

We had a similar problem with ours and had to finally take it to the repair shop. They informed us that we needed to replace our clutch and that you needed to do that every 2-3 years. It cost less than $100 and has been well worth it. ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Hoover Windtunnel My Hoover Windtunnel is 3 years old. It worked great until yesterday when it lost all suction. I have followed the manual to trouble shoot any possible clogs and could find none. Then I noticed that when I remove the dirt collection cup and held my hand over the vent the suction is fine and strong. So... I replaced the hepa filter thinking that might be the problem. That didnt' work. The motor runs fine. The suction without the dirt cup inserted is strong. As soon as you insert

Either the hose has a clog, or the inlet down by the belt is clogged. Is there suction at the end of the hose, if not then it is clogged. If there is suction, then it has to be clogged down below by the brush roll, check that inlet. There also is ... Vacuums

The suction for carpet cleaning is great but there is very little suction through the hose. I have cleaned out the hose but there is still very little suction. What else can I do?

Have you tried cleaning the hose from the vacuum end, the end that feeds the sweepings into the cannister/bag? Might be something close to that end of the hose.\015\012Also, one reason for a hose not to work is the possibility of a cut or broken hos ... Eureka 5849A Boss Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0619 seconds