Having problems with your Vacuums ?

Oreck m900 will not dispense any water. this is the first time it has been used.

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Oreck m900 will not dispense any water. this is the first time it has been used.

Check this manual out ht ... Vacuums

My Bissell Pro Heat Select 2X does not pull up the dirt from the carpet into the water. The water just slowly disappears. The first time I used it the water got really dirty. The very next time I used it it worked differently and the water just disappeared until it was all gone. I've only used it a couple times and I don't see where it is working. Has anyone else had this problem?

Inside the plastic suction lid is a little red plastic filter that has to be cleaned out every time you use it because it sounds like your vaccum is not picking up all the hair and debri before you clean the carpet causing the water to be injected in ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Just bought and used the Hoover MaxExtract 77. First time the water was extracted from the carpet. Second time NO water in tank. Now I have wet carpet. I've taken the machine apart 3 times and cleaned the filters and still the water is not extracted from the carpet.

... Hoover F6055-900 SteamVac Maxextract LS Wet/Dry Vacuum

We have a series 90S, 2.5 gallon Shop Vac. We used it for the first time to try and **** up water in the basement. Each time we turned it on, it would shut down after collecting less than 1" of water. We had to remove and squeeze out the foam sleeve each time, before it would work again (nowhere near 2.5 gallons!). Any ideas? Is the plastic sleeve that can move up and down inside, the float (poorest manual I've ever seen!)? Should there be a ball float that we're missing? Thanks for any s

Remove the foam sleeve when using the unit to pick up water.\015\012The float is in there to indicate when the unit has "enough" water in it. The float rises with the amount of water and when the water reaches a certain height the float is "pulled" ... Shop Vac Vacuums

I'm using a steam vac for the first time, i wanted to know if the bottom piece that you empty out the dirty water has to have water in to use it. or is it suppose to be empty?it's an upright hoover steamvac for heavy traffic areas and spot cleaning

Hello,\012The bottom piece should be empty when you use your machine. Make sure you rinse it our real good when you are finished.I hope this helps. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

I got my bissell for $7.50 from a thrift store, if you can believe THAT. Used it for the first time today after reading the manual online first. After filling the clean water bladder full of hot water and setting everything up the way I wanted, proceeded to turn things on and go for it. Well, the water/solution just kept coming and coming, without my finger on the trigger. Obviously something is jammed in the open position but where? The trigger moves freely.

This is the answer I got from Bissell:Please\015\012check the gasket at the bottom of the tank to ensure it is attached and\015\012not lodged in the reservoir of the machine. If this is not the problem,\015\012take the machine for i ... Bissell 8910 ProHeat Clear View Upright Vacuum

I just bought a shop vac to **** up the winter slop in the garage. the first time I used it, it worked perfectly but the 2nd and 3rd times I used it, it spits water from the exhaust. Why? It doesn't seem to have a plug/clog and I have the foam sleeve plus the circular paper filter on it, as per directions. Help!

Too much water in the unit causes what you describe. Water should be drained and the unit completely dried between water events, or unit will rust and have shortened life. ... Shop Vac 925-13 Canister Wet/Dry Vacuum

Hello i can turn my steam buddy platinum 44G258 on, water boils, press hand gun get a buzzing noise like you do with a jet wash, but no steam comes out, it seams the water is not coming through, have check the cap on water container thats ok, its where it releases the water to is seams to be where the problem is, i think ! first time we have tried to use it many thanks steve.

... Vacuums

I used the Scooba 390 for the first time this weekend and it seems that the robot had problem sucking up the dirty water from the floor. When I emptied the dirty water tank, there was hardly any dirty water. Can you please let me know what can cause this problem?

... Roomba iRobot Scooba 390 Floor Washing Robot

We just took our dirt devil Platinum Force Carpet Shampooer Model CE7900 out of the box - first time used. It puts soap and water down fine, but we can't get any dirty water picked up. None of the trouble shooting suggestions in the manual apply. HELP! (We had only the power on when trying to pick up the dirty water.)

... Dirt Devil Easy Steamer Upright Wet/Dry Vacuum

My Bissell doesn't appear to be sucking up any water, it is the first time to be used. The carpet isn't saturated but when I went to dump the "dirty" water, there was no water. So apparently it is in the carpeting.

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Recently our Vitapur water cooler has not been dispensing water. The problem is the water is freezing in the upper reservoir. We have tried unplugging the unit overnight & turning it back on at the minimum cold setting several times which has not worked. We have also used the Vitapur cleaning kit to clean the unit, which also did not help.

The problem is a comon one and simple. You just need to replace the themostat.\015\012Good luck ... Vacuums

Eureka Atlantis 2590 Deep Steam Extractor clean water tank leaks out the first time I use it

... Eureka Vacuums

Lost Suction This is my second hoover steamvac and i am having the same problem with my new one as i did with the old one that i tossed out. I have used it about 12 times and it worked great the first 6 times... Now i'll empty a full tank of water and only half will get sucked back up. I have tried taking it apart and cleaning and also the rubber seal had some gaps so i sealed those thinking that it was leaking air from there...can anyone help? I am so close to chucking this one and buying somet

Usually when there is no suction, one cause is the lid to the recovery tank is not on all of the way in the back. Also if you have that foam filter on the underneath side of the recovery tank lid, it needs to have a 1/4 in or so gap from the top of ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

My Bissell 9200 Pro Heat 2X has only been used 4 or 5 times since bought about 2 years ago. Now it won't dispense water from the bottom, but it is dispensing soap

Hi,Don't worry this is small issue.It is due clog problem.Clog in the heater.Unscrew all the screws on the base.Remove the cover\015\012 over the motor. Doing so will reveal the hoses attached to the soap \015\012dispenser. ... Bissell 9200 Upright Vacuum

Model 79011 ProHeat - First the water and cleaning solution wouldn't come out without pressing the trigger several times. Now the trigger doesIs there a spring on it inside the handle or do I just need to order new trigger. I have only used the cleaner 3 times.

... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

It leaves water after finished. That's the first time I use it but it leave water on the floor and it stops.

According to iRobot make sure that the Scooba is clean, including the parts (vacuum hose & filter, bottom roller)\015\012Make sure the battery if fully charged, and that you let it complete the cycles! ... iRobot 5800 Scooba Vacuum

I used my Hoover FloorMate, SpinScrub Hard Floor Cleaner for the first time today. My intent was to clean the grout in my kitchen/family room floor. Since the water was dirty I know it cleaned the grout but I was only so-so pleased with the results. Any hints? What about the grout solution? Do you mean I can only use the Hoover product?

The Hoover model 800 has seperate brush assembly to do grout. The 500 model (yours) has only the one hight brushes so other means must be taken to do grout. I have a 500 and all tile floors and I'm bumbed too.\015\012\015\012Kirk Thompson ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

My first proheat lasted four years so I bought a new one. After I used my Pro Heat for only the fourth time my first issue occured, the gear on the pump that runs the brushes came off, so I had the one from my old proheat, I just changed the gear spindle that is screwed to the pump and fixed that problem but now it will not pump water. That is why I bought a new proheat, I could not get the old one to pump even after a new pump and made sure all lines were not cloged.

Is your new machine a 2X or like the old style proheat? ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

My new bissell pro x will not suction water, it worked the first time I used it but will not work today when I tried to use it.

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell Vacuums

For the first time, I tried using my Kirby Sentria shampoo attachment. I've lost the manual but found instructions online for making the swap from regular vac to shampoo-er and got it all assembled. The foam laid down just fine, however, when I run the vac back over the foam to pick it up, there is not a stitch of water showing up in the tray. First I thought maybe it was bc I hadn't put that much of the foam/water onto the carpet, but 12 hours later, the carpet is still wet in spots. Clearly

Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=638285\015\012Generic problem for all Vacuums\015\012For the first time, I\015\012Posted by MHicks on J ... Vacuums

The attachment to clean furniture will not spray out water this is the first time we have used this just out of box. Also the detergent will not mix with the water

If you can see the cleaning fluid at the nozzel yet the it does not spray than the nozzles are clogged with dried soap. You can soak the the sprayer in a small bucket over night with a cleaning solution like CLR also used to break up hard water stain ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I am using my Hoover Steamvac FH5001 for the first time. It worked great until I had to empty the dirty water tank and refill the solution tank. Now it will not spray solution. I have double checked to make sure both tanks are inserted correctly, but to no avail.

Check all o rings to see if they are seated correctl= on the hoses that were disconnected. If not you will not receive suction to spray ... Vacuums

The Eureka Environ Steamer won't heat up. It feels lukewarm and no steam is emmitted. It worked perfectly the first 3 times I used it but now, nothing! There is water in the tank, and the electrical outlet is working. The green light is lit on the unit, but it doesn't get warm.

... Eureka Enviro Steamer 310 Stick Vacuum

We used our Hoover SteamVac F6207-900 for the first time today and it did not suction at all. Please help. It emptied all of the clean water/detergent as I cleaned the carpet, but no dirty water came up into the empty tank. Thanks!

Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=639624\015\012Generic problem for all Vacuums\015\012We used our Hoover SteamVac\015\012Posted by medgl ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 1.8041 seconds