Having problems with your Vacuums ?

Vacuum stopped in the middle of vACUUMING - Vacuums

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Vacuum stopped in the middle of vACUUMING - Vacuums

... Vacuums

I have a DC 17. In the middle of vacuuming the vacuum stopped working when it was in the upright position. It only works when the head is down and i am using the bar. I can not use the extension bar, becasue when I put the vacuum upright it shuts off. Where is the problem?

Hi there, it's Jack at Dyson.\012 \012 Like most Dyson vacuums, DC17's main suction motor is protected by a thermostat which shuts the machine down if it starts to overheat. This could be due to a blockage, and the filter may also need a wash ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

In the middle of vacuuming the other day,the vacuum just stopped

Check another outlet.turn the switch on and off real fast if it comes on the switch is bag.unplug it then reach under the base and turn the brush roller by hand a few times then plug it back in and try again.wiggle the cord around because you might ... Oreck XL2200 Bagged Upright Vacuum

Vacuum stopped in middle of vacuuming our carpet. Would not startup at switch. Tried other electrical outlets wondering if this was the problem and checked breakers, but it still did not go back on.

2 guesses.... One is that you vacuumed up a pice of cord or sting that got wound up on the roller (if it's that tyme of machine, and NOW everything's completelt "loced." Cure: look at the brush roller and "unwind" the cord or string.\015\012 ... Vacuums

My vacuum has stopped working and shut off in the middle of vacuuming. What could the problem be

No power, plugged/jammed impeller. some newer ones have a sensor that turns it off when it is full of dirt... ... Hoover Elite Rewind Bagless Upright VacuumVacuum

My Sharp Vacuum, Model EC-S2365 just stopped working in the middle of vacuuming. I'm not sure what happened and I can't turn it back on. Any suggestions?

Just before it shut down were you pulling on the cord? For it to shut down like that it almost sounds like the electric cord has a break in it-probably at the plug ... Sharp EC-S2365 Upright Vacuum

I have a Kenmore DuraPower Dual Cyclone Action 12 Amp that just randomly stopped right in the middle of vacuuming. I assumed the plug had come out of the wall so I went to check and this wasn't the issue. I tried multiple outlets and that wasn't the issue. I made sure nothing was stuck and there is nothing stuck. Nothing happens when I press the red "ON" button. What could this be? Thanks!

... Kenmore Vacuums

My hoover elite rewind stopped running in the middle of vacuuming. Is it dead forever?

Cord may have gone bad, if so you will have to replace the cord rewind. Could be a problem with the switch, maybe the motor. Just have to have it checked out. ... Hoover Vacuums

Suddenly stopped running in the middle of vacuuming a room. Tried another outlet and still no power.

You have to go to the electrical panel that serves your home or apartment and locate the fuse that is blown [ if there are fuses, replace the blown one with a new one of the same amperage] or the circuit breaker which has kicked part way off. With a ... Panasonic MC-V5481 Upright Vacuum

I have a Dirt Devil Easy Lite. In the middle of vacuuming it simply stopped running, completely turned off, and will not turn bac on.

... Dirt Devil Easy Lite Quick Vacuum

My dyson dc44 just stopped running in the middle of vacuuming, I checked the battery, cleaned the head, I emptied the bin. Is there a reset button anywhere for this machine?

... Dyson DC44 Animal Cordless Vacuum

Our Dyson keeps stopping in the middle of vacuuming and then it will not come on except when you lower it and then periodically it will go either way.

Hi its Darran at Dyson.Your machine is fitted with a thermal cutout which will stop your machine should the motor become too hot. After an hour or two it should come back on. this is caused by a dirty filter or a blockage. ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

I have a Hoover self propelled WindTunnel vacuum( Model U6425-920) that stops in the middle of cleaning. I have changed the flat belt and I'm still experiencing the problem. I usually have to wait an hour or so b/4 it would work again. Any advise?

Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=632298\015\012Generic problem for all Vacuums\015\012I have a Hoover self\015\012Posted by thjunk2007 o ... Vacuums

Won't start. My son was using the vacuum & Didn't change the bag. The vacuum was making the full bag smell, but the light was't on & it didn't stop. I stopped him, changed the bag, checked the filter, closed the compartments & turned on the vacuum. Nothing happened. I checked to be sure that it was plugged in, that wasn't the problem. I've let the vacuum "rest" for several days, It still won't start. Any suggestions?

There is a reset button at the back of the powerhead. The user manual can be downloaded from the electrolux website, although I didn't find it very useful. There was some info on how to change the powerhead drive belt. ... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

While vacuuming the red light for the bag of the vacuum came on and the vacuum stopped. The bag was no where near full so I replaced it with a new bag - same problem. It vaccumes for a minute or then stops with bag light on. It is the correct bag for the machine - so what's the problem?

I'm assuming this is the Epic 6500 or similar model.\015\012Detach the hose, turn vacuum on. If it runs, place palm of hand against inport hole. If it shuts off the problem is with either the control valve setting or the control valve assembl ... Electrolux Vacuums

Vacuum stopped working

Hi Melisa\015\012Because it has a dirty fan system where dirt is picked up and put through the fan impeller before it goes up the back spine and into the bag, it sounds like stones or hard dust has entered the fan and bounced off into the motor ... Oreck XL2600 Vacuum

Cleartrak vacuum suddenly cleartrak started to make weird loud noise i cleaned. When it got jammed I stopped the vacuum and dislodged the jam and it worked fine. How to stop the weird loud noise?

... Vacuums

Hi, I can't get the warning lights to stop flashing on my vacuum.... it had caught a string on my door mat... I removed the string, did all of the trouble shooting that my guide recommended including looking for blockages etc. The vacuum seems to **** fine except I can't change the settings and the lights won't stop flashing...any advice? I bought it out of country so I have no warranty (so much for me saving over $100 in price!!)

Try to reset or find the reset button it means the trouble about the string was on the memory of your vaccum that trigger the flashing of light. try to unplug your unit then after plug it on ... Dyson DC28 Animal Bagless Upright Vacuum

My red kenmore canister vacuum cleaner model 721.23083500 stop turning on no power while i was vacuuming just stopped

... Vacuums

My oreck halo starts and stops when vacuuming. you get two or three motions and it stops. my hand tingles when i vacuum. can you tell me what is wrong. it was bought in March of 2009

Sound like you have a loose wire inside the unit, " DO NO USE TILL ITS FIXED ". Carefully start taking apart in the locations where the wire runs through. Pay attention to all the wiring, any little nick could be the problem. Somewhere in there a wir ... Oreck HALO100 Bagged Upright Vacuum

Motor Fried? Eureka 431BX Vacuuming, and then all of the sudden the motor just stopped. Well idk if it's called the motor; the beater bar still spun, it was just the fan that stopped spinning Here is the whole vacuum in pieces http://i28.photobucket.com/albums/c237/SirFafner/Vacuum001.jpg Bottom Part, beater bar already taken out [Functions Fine] http://i28.photobucket.com/albums/c237/SirFafner/Vacuum002.jpg White Wire connecting to the fan motor [Looks black, i think it's fried, and that's the

Funny you said that,I went today and bought a bissel at Wal-Mart.Sure hope it lasts longer then the Eureka did.I will probably try to take the other one back to the store if I can find the receipt.Thanks so much. ... Eureka 431BX Bagless Upright Vacuum

Stopped working while vacuuming heavy dust on patio the vacuum suddenly stopped working. I tried it on other outlets with no luck. I cleaned the filters and still no luck. Is there a circuit breaker if it get hot?

It cooled down and worked 20 minutes later ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

My dc16 dyson root vacuum stopped working abruptly with no indication of a weak battery, the charger does not show a charge on battery. usually the vacuum slowed before it stopped with a dead battery, any suggestions

... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

I have a windsor vsp 14, it is making a bad grinding noise, when I take the top blue piece off it stops, the brush works fine and when I put the top back on it grinds really loud and gets hot. it still vacuums and the belt and brush are working fine, can't figure it out. and when the lid is on I cant see what its grinding on. It only makes a grinding noise when you pull handle back and engade to vacuum flor and stops when you put it upright.

... Windsor VS14 Versamatic Bagged Upright Vacuum

Brush Roll belt stops turning durring vacuuming on WindTunnel self-propelled, v belt is a little loose with handle down. Tensioning roll is engaged OK, but fully at the end of its travel. Replaced belts flat and v, but still stops turning even on high carpet setting when vacuuming. Carpet setting and height adjustment appears to be working OK, roll is clean and turns easily when out. Also turns easily until it engages the carpet. Self propel function works just fine.

... Hoover U6485900 Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0640 seconds