Having problems with your Vacuums ?

I want blockdigram of electrolux wascator FLE804


Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I want blockdigram of electrolux wascator FLE804


... Vacuums

I want to know where is Electrolux service centre in Qatar?


... Electrolux Vacuums

I want All Problms of Wascator FLE-804


... Vacuums

Want to read an instruction manual for Electrolux Vitesse 1300 W


... Vacuums

Hi, belt came off ny Electrolux Velocity 2000w upright, got belt back on but have a metal srip that looks like it belongs at the motor end to keep belt on. which way in does this go as plasticlooks bit damaged and dont want to force it in wrong way,


... Electrolux Vacuums

Have Electrolux 1590 whole house vac, and can't see how to get brushes out. Leads so short, and don't want to break them trying to free brushes. Do they slide out of plastic housing? My eyes not real good, but it looks like the leads are part of a brass sleeve that slides into the plastic housing. It also looks like the plastic housing may be a snap lock type, but I don't see how to open it.


... Electrolux Vacuums

I want to change the motor on my Electrolux 6500 Epic. How do you get the shell open?


Some use computer proof torx screws,youll ned a v long screwdriver.cheaper to buy another one new ... Electrolux Epic 6500 Vacuum

The plastic 'bracket' for want of a better word has been 'snapped' on either side of the vacuum hose entry point to the head of the vacuum. I have the Electrolux Maximus AMX7025 (made in the EU). Can this part be replaced or do I have to purchase the whole vacuum head?


... Electrolux EL4100 Bagged Canister Vacuum

Electrolux oxygen plus 2100w telescopic tube is stuck. I wanted to extend it but the handle will not release and is stuck. Can you offer any suggestions?


I have a electrolux 2000 and my tube has a small tab that you push before it would let me release it. I had trouble getting it off as well. What I did was push the tab, Plasing one foot on the vaccume head holding it down while pulling up and twistin ... Electrolux Vacuums

I have an Electrolux ra122b fridge for my camper van 12volt and 240volt I want to no how to connect the 240volt to it


... Vacuums

Electrolux twin clean vacuum cleaner. After 5 minutes it keeps of thinking the filters need cleaning (and they don't). I re charge the power, and all seems fine and then it goes back to wanting the filters cleaned. The suction is also not working to full capacity.


Because the suction is not working fully it feels that the bags must be full and the air cannot be pulled through the bags. It could be due to 1) bags not being of correct quality. The air has to pass through them to allow all the dust to reach there ... Vacuums

Want instruction on how to change the belt on electrolux velocity


N mine the roller it goes around has a 1/2 block set on each end held down by a spring (streight type) or 2 screws 1 on each side of the block. ... Vacuums

The brush on my Electrolux Ambassador III vacum stops turning after vacuming for only a few minutes every time I use it. The power nozzel is less than a year old and except for the brush not wanting to turn, it operates just fine. Any suggestions on how to fix the problem?


... Electrolux Vacuums

User manual i have a electrolux masterlux z77 3 in 1. i want to shampoo the carpet but i have no user manual how does it work


HiHeres the instruction bookhttp://safemanuals.com/user-guide-instructions-owner-manual/ELECTROLUX/Z77A-_ERob ... Electrolux UltraLux 2000 Bagged Canister Vacuum

My built-in Electrolux vac is about 10 years old and I want to clean and oil the main suction motor. At which points do I oil the motor and will 3-in-one oil work or is there a special lubricant. John


Do not oil the motor as it is not required, nor is there any place to put oil. the carbon brushes should be replaced though. carefully remove one brush and bring it to a vacuum repair facility. they should be able to match it up. there is a # on the ... Electrolux Vacuums

ELECTROLUX OLYMPIA ONE HOSE


Usually the older hose get replaced, they just weren't made to be repaired, if it looks like something that will come off, then try either warming the sleeve up with hot water or a hair drier to see if you can work it off after it has warmed up. ... Vacuums

Electrolux Epic 8000


YES,JUST TAKE OFF THE HEPA FILTER.\015\012IF I MAY SUGGEST,IF YOU WANT TO BUY AN AREUS/ELECTROLUX YOU MAY WANT TO LOOK AT THEIR "BOTTOM OF THE LINE" MACHINE, THE "CLASSIC" IT'S HALF THE PRICE AND A MUCH BETTER DESIGN THEN THE NEW "FLAGSHIP" MOD ... Electrolux Epic 6500 Vacuum

Electrolux EL8605 type a 1 no suction


... Vacuums

Electrolux Model E switch wiring diagram


Hi,\015\012 You may need to trace where the supply comes from, but essentially, you need one black wire from the motor and one from the capacitor to go to ground.\015\012The other capacitor lead needs to attatch to the other motor wire as ... Electrolux UltraLux 2000 Bagged Canister Vacuum

MANUAL FOR AN ELECTROLUX STEAM CLEANER Z355A


... Electrolux Vacuums

How to open electrolux ultraone?


... Vacuums

Electrolux z8220 - is it possible to get a power head for it?


... Electrolux Centralux Vacuum

Electrolux, Model Number ZUA3860P


... Electrolux Vacuums

Ambassador 111 Electrolux canister vacuum, model C101H, how do you replace a back wheel?


... Electrolux Vacuums

How does the cord winder spring install on a electrolux canister style vacuum cleaner?


... Electrolux Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0249 seconds