Having problems with your Vacuums ?

My Eureka the boss capture bagless works fine but extremely loud. Please help, my ears are ringing after I'm done!


Answers :

Would sujest you change the brushbar and end cap bearings
http://evacuumstore.com/s-1171-4700a-1.aspx
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Eureka the boss capture bagless works fine but extremely loud. Please help, my ears are ringing after I'm done!


Would sujest you change the brushbar and end cap bearingshttp://evacuumstore.com/s-1171-4700a-1.aspx ... Vacuums

LOUD hoover It's vacuuming well but is extremely loud. I'm a drummer so I don't have what you'd call sensitive ears, and my ears are ringing after a mere 10 minutes of having the vacuum on!


If this sounds like an airplane taking off, then for your hoover U5288-900 it will have to be the fan that is inside the motor compartment. i have looked at hoover.com and cannot find the part num. to the fan, but i know that you can replace it. you ... Hoover U5288-900 Upright Vacuum

I have a Fein Turbo III shop vac for several years now...about a year ago, for no apparent reason it changed into a hideously LOUD beast! It's previously low decibel drone is now so loud it makes my ears ring afterwards...its sound is high pitched, almost like its hose is blocked, but it isn't...and suction remains good...I just can't take the sound...Help me.


It sounds like the bearings in the motor are shot. You can try to get a replacement motor, or if you're a mechanical genius type, you might be able to repair the motor bearings. If the shaft is worn, you'll have to buy a new motor.\015\012Y ... Fein 9-77-25 Turbo III Bagged Canister Vacuum

Eureka Capture 8803AVZ - EXTREMELY loud


Had it checked for the noise. Motor bearings go out after a few months is what the AUTHORIZED repairman said. Toss it. ... Vacuums

Extremely loud I purchased the vacuum last September and have been satisfied with it, but the last few weeks it has been extremely loud. I replaced the belt last evening and it did not help. What do I do to quiet it down?


Where did you get brushroll for these vaccum ... Hoover U5507900 Elite Rewind Bagless Upright Vacuum

Loud noise?? my vacuum suddenly just got really loud. it suctions fine, i changed the belt, but when the roller is off its not loud, but when i put it back on the 11noise is horrific. it vacuums fine i just cannot stand the noise. please help


I have the exact same problem. I've taken the thing apart and cannot figure out what is causing the noise. It's not the belt and it doesn't seem to be coming from the engine. It sounds like the spinning brush is hitting something, but it's not, th ... Bissell 6590 CleanView Bagless Upright Vacuum

Loud DC25 Ever since we cleaned the filters on our DC25 it is extremely loud and even louder as it is shutting down. I have taken the filters out and reinserted them but it hasn't helped. Any ideas?


Hi Amy,I'm sorry to hear you've had difficulty with your DC25's filters. We should be able to resolve this for you, but we'll need to discuss this with you directly. Please give our Helpline a call on 0800 298 0298 (UK), or 1-866-693-9766 (US ... Dyson DC25 Vacuum

LOUD noise Turned on vacuum one day and it made a reallly loud noise like the belt had broken. So we replaced the belt correctly, and turned it on and the noise is still there it is also rattling violently. HELP PLEASE not exact same model but close enough


The armiter or fan is broken and if you get it replased it should work like new ... Hoover U5227-930 Elite Upright Vacuum

My Old Henry hoover is making a VERY loud noise when switched on! Its still works but very loud, please help!


Most likely the motor bearings have worn out. You can fit a new motor quite easily, but if you need to pay someone else to do it for you the labour plus motor cost will probably make the job uneconomical. Sorry to be the bearer of bad news... ... Numatic Henry Bagged Canister Vacuum

Ear piercing whistle


Its an inherent problem with any Dynammite model = the fact that the motor is at the front means that it is extremely noisy. ... Dirt Devil M084600 Dynamite Bagless Upright Vacuum

Eureka Boss smartvac extremely loud


Bought a new vacuum cleaner.\015\012\015\012Thank you! ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

My vacuum is EXTREMELY loud all of a sudden...


... Bissell Vacuums

Suction problem I have a Hoover Widepath Fold Away, 12 amp motor vacuum cleaner and the problem I am having is every time I vacuum, the vacuum gets clogged up with carpet. I am probably only able to do one stroke then it gets clogged and I have to stop and unclog it or it spits it out on the carpet. This is very frustrating and I don't get much vacuuming done. Please can you help me. Thank you. Gwen email is [email protected]


Get rid of the carpet its shredding and falling apart.no sence in vacuuming old rotten carpet.or try using a vacuum without a brush roller and just suction ... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum

Belt problem My belt broke. I put a new belt in, followed the instructions, seemed to be right but as I started using the vaccuum, it starting smelling like burnt rubber. The belt was extremely hot. Took it apart, tried again and the same thing happened. Please help me!!!!


Get the old lady to use a dustpan and brush instead SORTED ... Kirby Generation 3 Bagged Upright Vacuum

A loud noise happens when I try to vacuum carpets. The hose works but that is it. Please help, I just recieved vacuum for mother's Day.


THE BELT MAY BE LOOSE. UNPLUG THE VAC AND USE A PHILIPS SCREW DRIVER TO REMOVE THE UNDERSIDE OF THE VACUUM WHERE THE BELT IT LOCATED. CHECK TO MAKE SURE THAT THE BELT IS ON TRACK AND NOT BROKEN OR SNAPPED. THIS CAN CUSE A LOUD NOISE TO BE PRODUCED FR ... Dyson DC07 Bagless Upright Cyclonic Vacuum

No suction i have a hoover supreme wind tunnel vac and its relatively new and the suction, well......sucks. It wont pick anything up! I am extremely frustrated! I picked up a ball of fuzz off the carpet and held it under the vacuum and it still wouldn't **** it up. I then shoved the fuzz up INTO the vacuum. It fell right back out. I may as well not even vacuum. Please help!


I have found more vacuums on the way to the dump because they were full. Check. Is it full?\015\012If not the air way is clogged. ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

When I turn the vaccuum on the roller works for about 20 seconds, then I hear an awful, loud noise, and the roller does not work. Sounds like maybe some gears are being stripped? Please help


It sounds like you need to change the belts. You can get replacements and view the manual here:Dyson DC07 Belts and Manual ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I have a vax cylinder model V-094. Working fine then started to play up. Switch it on and the motor seems to struggle to power up. Kind of wurrs up and down. Was thinking it could be the brushes have worn. Tokk to bits and cleaned her up, took a look at motot and brushes, cleaned them too, back together and still them same problem. Help please, hoover is not old but has done some work really don't want to through away something that can be fixed.


Hi.\015\012\015\012after all you have done I would be pretty confident its the motor thats faulty they are expensive to buy so machine is going to be scrap,\015\012\015\012Sorry.\015\012\015\012 ... Vacuums

Soinds weird my dyson sounds like sucksion is leaking...the air leaking sound is really loud. it sucks some dirt but is not going into the canister, don't know where its going. it sounds like when i'm using the attachments when i'm just vaccuming...please help!!!


Dysons web site has an online area where you can walk through common problems like this:\015\012\015\012http://www.dyson.com.au/support/ ... Dyson DC18 all floors Bagless Upright Cyclonic Vacuum

I have the eureka capture vacuum and it works great; however, it has recently started making an extremely high pitched sound when I use it. It is still vacuuming but the noise is so loud it hurts my head and I can only vacuum for a few minutes at a time before I have to turn it off. What is wrong with it???


Dust is getting past the dust cup filter, to the motor. Call Eureka customer service. 1-800-282-2886. ... Eureka 12 Amp Capture Vacuum Upright Vacuum

I have a Bissel proheat 7901 carpet cleaner and it is not sucking the water up. Normally when I clean the water gets sucked back up and I have to empty the dirty tank. Now no water is in the tank when I am done cleaning. Please help I cannot afford to take it to the shop.


I'm not sure if this will help but I had the same problem and was about ready to pull my hair out. I ended up taking the fill tank off and if you look inside where the red overflow flap is you will find a small screened opening. I found that mine w ... Vacuums

I have a panasonic mc-ul975 vacuum that works great when working properly. the airflow through the canister seems to stops once the aero blast technology is done running which causes the vacuum to not function as it should (does not have as much suction and the hose/tool accessories do not work at all). if air is continually running through the canister everything seems fine. please help!


Hi there. In Panasonic vacuums, there is a thermostat protection on the motor. It will auto ... Panasonic MC-UL975 Upright Vacuum

Makes a loud noise like a grinding noise then smokes comes out and it smells like burning rubber? When I take the (rod) brush off with the belt then run the vacuum there is no more noise? Please help me thank you


Your belt is worn and stretched and so it is slipping on the motor drive shaft. That is why it is noisy and smells like burning rubber. You simply need to replace the belt. You can get replacement belts here: ... Vacuums

Hi I have an electrolux "The Boss" hand held vaccum cleaner. I cannot find the instructions and am having problems changing the belt. It is model number Z57A. Product Number 900-250-006. It is the first time I have had a problem. I only use it occasionally for my caravan. So cant find the instructions and cant remember how to change the belt. Please help


You need top lace belt on brush roller and re[-assemble by putting plastic cover on which is retained by 2 recessed philips screws.. Prize off triangular coverat fornt.behing that you should see the belt lying loose.You need to get a blunt object to ... Electrolux Vacuums

I own a eureka,the boss capture bagless.it has started making a loud whining noise with very litle sucktion.can you advise me on what to do?


It sounds like there is something caught in the motor blocking the impeller a paperclip or a penny or even a bobby pin could have worked its way to the motor ... Hoover U6446-900 WindTunnel Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0810 seconds