Having problems with your Vacuums ?

EL8501 SUCTION IS NOT GOOD

\015 How do I take the hose off to clean out the clogged are and my Electrolux no loss of suction vacuum\015

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

EL8501 SUCTION IS NOT GOOD


... Vacuums

Poor Suction Heya! So I just picked up a used Dyson, but when I vacuum with it, the suction is pretty weak and it spits all kinds of stuff out the back and into my feet. When I pull the hose I have good suction, but in regular mode it hardly picks up anything. The brushes are spinning, and it eventually will clean an area if I go over it again and again. Maybe a clog somewhere? Please tell me that Dysons have better suction than my $50 Dirt Devil! Thanks!


I recently bought a second hand Dyson DC07. Its suction was poor. I removed all the un-clipable pipe bits and to remove any blockage but it all looked clear. The Final Sponge and hepper filter did have a lot of dust in it and the rotating brush was f ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Brush spin,good suction at hose, no suction at


Air passage from back of brush head, through the joint, and up to bag, may be blocked. ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

My eureka optima upright bagless vaccum has VERY low suction using the floor part. the hose has excellent suction. i removed the little translucent door underneath and there were no blockages, i cleaned the brushroll thoroughly and that hasnt helped either. i know this probably isnt recommended but i turned it on to the floor setting with the brushroll off and stuck my fingers up the intake as far as i could, the suction was good further up but it just seems to stop down at the base. because i s


I will try and help here. Is the sole plate on the bottom of the vacuum complety on and there are no visible cracks along the seam where it meets the body? This is the usual cause for this. Onc you take of the plate to access the roller and brushes, ... Eureka 431A Optima Bagless Upright Vacuum

Poor suction I have a hoover hush s5627 vacuum purchased about 4 years ago from Costco. It's suction power isn't so good anymore. I've checked all the lines & hoses and they're clear and I've changed the bag. I even disconnected the pipe from the vacuum unit and held my hand over the intake. While the machine roars like a jet engine the suction power just ain't like it used to be. What could possibly be the problem?


This vaccuum has a Fan Blade inside connected to the motor that spins to create the suction you feel. After a few years of use (and misuse) the blades on this (plastic) fan will be broken off, thus damaging the unit. These Fans are replaceable if yo ... Vacuums

Dyson vacum cleaner lost suction got the DC14 and it doesn't seem to have much suction in the floor head, the hose still has good suction. I have checked all the paths for blockage and there is none.


Hey, this is Leland with Crucial Vacuum,\012\012If your unit's suction has decreased there could be several reasons.\012\012Firstly, the motor may be the problem. If you hear any noises while the machine is running, you should contact ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Electrolux Epic 6500 SR Carpet Sweeper won't go on. Belt good brush moves, bulb looks good, reset red button I'm not sure, works, looks good. Vacuum starts has suction ,


This link is the manualhttp://www.totalvac.com/manuals/electrolux_manual_Epic6500.pdf ... Vacuums

No suction I have the 3760-4 and have no suction. Does it need an o-ring. Good suction in machine but none outside at hose


The simple solution would be a clog in or leading to the hose. Unless you here a air leak it does not need a new o ring. If there is no clog then you need to take it to your local vac shop for repair. ... Bissell 37604 Lift-Off Pet Bagless Upright / Canister Vacuum CleanerVacuum

Dyson DC14 is not picking up as it should and the hose hardly has any suction. I have checked for blockages and there are none. When i turn it on it sounds like there is good suction then there is a second noise like the suction is escaping somewhere.


Check this video out ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Suction I have no suction through the hose. I have taken this machine apart, and checked for clogs, have found nothing, but did give it a good cleaning, still I have no suction.


Hello tnwalkergal the hose may have a clog inside the hose at the bend you can take the hose loose and run a broomstick or a yardstick thorgh the hose this is how I find the clog ... Dirt Devil M086700 Vision Bagless Upright Vacuum

Ive got powerful suction from my wand when i am using my dyson upright, so the suction on the bottom not good


... Dyson DC07 Bagless Upright Cyclonic Vacuum

I have a Kenmore Progressive Inteleclean Upright vacuum cleaner (with Bag) . It has good suction only through the hose now and none through the bottom for cleaning carpets. and, there is a noise like it has a suction leak. the brush is rotating.


Theres a little bendable neck that hose with suction plugs into. Thats the one thats clogged. You will have to fish it out by taking off the roller and clearing the clog. ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

No suction from the bottom but the hose suction is good


Behind the bottom roller there is a pickup opening that is clogged ... Vacuums

My DC05 Dyson suction has stopped...there are no blockages, the seals are good, there seems to be more suction coming from a yellow box which is situated at the top of the removable cannister. There is nothing obvious'


My Dyson had exactly the same problem. I found the problem was caused by a blockage in the hose. Take the hose out where it joins the cleaner (it will come out if you pull it downwards gently) and take the hose out of the handle by squeezing the ye ... Dyson DC05 Cylinder Bagless Canister Cyclonic Vacuum

My vacuum has good suction the belt is good and i cleaned all the filters but it still wont pick up anything or pull itself


Sounds like its self propelled, if so check your belt and self propelled switch. John ... Vacuums

Weak suction on dyson dc05. The suction is not as good as usual


Hi its Darran at Dyson. Try washing your pre filter and checking the machine through for a blockage. These are the most likely causes. A full blockage procedure and filter washing instructions can be found at www.dyson.co.uk/ ... Dyson DC05 Bagless Canister Cyclonic Vacuum

Bag was not on good, resulted in dust,dirt, dog hair everywhere...have cleaned pretty thoroughly but vacuum does not have any suction. After taking apart did find that the larger wide belt is broke but I think that just affects the self propel...is there a belt tied to suction? HELP!


Greetings from GoVacuum,\015\012\015\012There are two things that you should check on this vacuum after running it without a bag inside. The first thing you should check is the filter that is underneath of the vacuum bag. This filter i ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

My Bissell cleanview is NOT suctioning well, all filters, nozzles, attachements, canisters and belts are clean and in good repair. We've pretty much made sure everything that I can get to without completely dismantling the vacuum is super clean and/or new... still poor suction


Did u check the filter above the dirt cup?\015\012\015\012twist the yellow piece and wash the filter ... Bissell 3594 CleanView PowerTrak Bagless Upright Vacuum

Losing suction filter clean,hoses clear,output blower good,but very poor suction


If the blower is much stronger than the suction, you may have an air leakwhere the cover fits on tank or possibly a warped tank or cover. feel all around the unit for air being drawn in somewhere besides the hose. try it without the hose on and block ... Craftsman 17765 Canister Wet/Dry Vacuum

I have good suction at brush, but no suction in hose connection.


Please unscrew the hose connection to the back panel. Is there suction there while in the upright locked position? If so, visually check the hose inside for obstructions. ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

No suction when vacuuming, but suction is good when using hose


Check for blockage from where the hose sets in its\015\012holder to the roller brush. Also see if the brush is\015\012turning, the belt maybe broken.\015\012\015\012Tom ... Eureka WhirlWind Litespeed 5844 Upright Vacuum

Hoover suction The suction on my cat and dog hoover is not as good as it should be. Any ideas?


I had a fur ball stuck in the pipe.  I took the end off and used a broom stick to clear it out. ... Miele Cat & Dog 326i Bagged Canister Vacuum

I have good suction at brush, but no suction in hose connection


I would change the bag and under the bag there is a filter, if dirty wash and make sure its completly dry before putting back into machine. once all done, have machine in upright position, turn on and see if there's sucktion at hose. hope this helps ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Suction Floor & wand seemed to have lost the good suction it used to have. Very disappointing Heather Chesser


Hi.\015\012\015\012If you have checked & cleaned all filters & its still no good go to this site http://dysonmanuals.llc.nu/index.htm\0 ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Low suction Have a Powr-Flite PF 18, suction is good at motor, but low at where hose comes out of top of vacuum. Could new lid seals help the problem? Where can I get new seals for this model. Also my zip is 98801 and my shop is not listed, could you add it please? Sew Creative 1139 N. Princeton Wenatchee, Wa 98801 509-663-5516 Thanks, Lauren-Sew Creative


Replacing the motor cover solved the problem, it must have been warped and was letting suction out thru it. ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0384 seconds