Having problems with your Vacuums ?

Vax upright hoover

\015 Loose cable wirein hoover end\015

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hi The band snapped the other day on my Vax Swift Turbo upright hoover and i got a new band from a Hoover repair centre. (Im assuming the bloke sold me the correct band). Was tight to go on. And it seemed ok. However, after switching on the band snapped immediately. Kinda burnt as well (at the point it snapped). Any ideas as to what the problem is here? The hoover is roughly 2 years old and used around 3 times per week. thanks Mike


Sounds like the brush roll is bad. Did you check the ends to make sure they turn freely? If not, replace it. ... Vacuums

The upright VAX hoover model X-005 The manual


... Vacuums

My vax power 8, 2200 watts 300 air watts 4L capacity upright Hoover is brand new, I emptied out the dust/dirt collecter and cleaned the motor filter yesterday for the first time, i switched it on and all fine, the brush is spinning and the hose is sucking, put the Hoover to work it's fine for about 30 seconds then then suction stops and its dead it won't collect no more, so switched off taken apart again and the motor filter is blocked and full of dust, so I unblocked it, do the same process aga


I had the same problem. It looks like the seal on the lid on the bottom of the cylinder has fallen out when it was emptied. There is no longer a proper vacuum being created so you don't get the cyclone effect and the dirt doesn't collect where its su ... Vacuums

HAVE GOT A VAX TURBOFORCE UPRIGHT HOOVER WHICH WILL NOTB STAY ON AS SOON AS I SWITCH IT ON IT GOES BACK OFF STRAIGHTAWAY, IT IS A VAX TURBOFORCE 1700 VACUUM


I have one of these too and it used to keep cutting out, replaced the filters and now it wont even turn on.  changed fuses everything, and now im stuck with a dirty house.... ... Vacuums

Bottom part of hoover wont **** - VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum


... VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum

Vax upright hoover


... Vacuums

How to change belt on vax upright hoover - Vacuums


Click on your vax for the manualUprightsVMUA1200 Air Upright ... Vacuums

How to change a belt on a vax upright hoover


... Vacuums

How to replace the belt on a vax quicklite upright hoover


... VAX Appliances Vacuums

How do I replace the belt on my vax bagless upright pet 2200w hoover


... Miele Vacuums

Can t remove base from hoover to change belt. vax upright


... VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum

Just tried to fit a new belt to a vax quicklite 2 upright hoover and the belt snapped is there a right way to fit belt


... VAX Appliances Vax X3 Bagless Upright Vacuum

Vax vx1 no power to brush motor circuit board is their an interlock switch so no power to this when hoover handle upright ? have multimeter and tools to check out.


... VAX Appliances Vacuums

Replace belt on vax vx2 upright hoover - Vacuums


... Vacuums

Upright vax blowing out dust - VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum


... VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum

Vax hoover my vax hoover keeps overheating and cutting out.


... Vacuums

Vax upright brush bar not turning - VAX Appliances VZL-6012 Bagless Upright Vacuum


... VAX Appliances VZL-6012 Bagless Upright Vacuum

Change impeller on hoover upright - Hoover Commercial C1403 Bagged Upright Vacuum


... Hoover Commercial C1403 Bagged Upright Vacuum

Vax mach 7 upright cleaner does not engage brush bar what so ever


... VAX Appliances VZL-6017 Bagless Upright Vacuum

Rotating brush will not turn om Vax Mach Air - VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum


... VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum

Vax mach 3 allergy new belt how to fit - VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum


... VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum

Instructions to operate vax 1px4 - VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum


Click the link below find your vax click on it for the manualhttp://www.vax.com.au/Downloadsusermanual.html ... VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum

I have a Swan Petmaster 1800w Hepa Filtration hoover s/r no SU3021 and cant find my instruction manuel. Problem is when on hoover it doesnt seem to be sucking anything up?? I have cleaned the cylinder and filters. Is it something to do with the bit that you can use to clear stairs/car etc and not converting back to an upright hoover again? Please help Julie


... Vacuums

Change fab belt on vax power pet 1 - VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum


... VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum

Vax rapide not picking up - VAX Appliances Vax X3 Bagless Upright Vacuum


... VAX Appliances Vax X3 Bagless Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0465 seconds