Having problems with your Vacuums ?
How to reattach hose on hand vacuum V15Z
\015 The hose feel out of my shark hand vacuum, model number V15Z. How do I reattach it?\015
Repair Help & Product Troubleshooting for Vacuums
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
How to reattach hose on hand vacuum V15Z
I have a Model 116.35922500 Kenmore upright vacuum cleaner. It makes a loud air noise when using the vacuum. I have disconnected and removed the hose to see if anything is lodged in the hose and it appears clear. It makes the noise when the hose is connected. When I remove it, the noise stops. When I place my hand over the hose, the nose re appears. I sounds as though the noise is coming from the fan or internal parts of the machine. So, when there is a load or pull on the machine, it mak
... Kenmore Progressive 35922 Bagged Upright Vacuum
My vacuum hose has split very close to the handle- how do I remove the handle, cut the hose at the split & reattach it to the handle unit - Centralux central vacuum system. Where can I find a diagram of how to remove the handle?
Do Not Cut the hose! It has wiring inside to control the vac and power head. This is a swivel handled hose with both low and high voltage contacts in it. The same wiring which gives the hose its ribbing, is conducting current for two applic ... Electrolux Centralux Vacuum
Kenmoore Intellivac w direct drive suddenly started making internal sound like something was stuck. Hose is clear, and sound is made when hose is detached from main unit. Vacuum sounds find at lower pressure, only makes sound with bag door closed and/or placing my hand over the end of hose.
Shut off the vac and open container and remove the bag. Try dropping a coin into the hose, then raise up to see if it falls thru to the bag area. If it does check the throat of the vac where the dirt is sucked upward to dump into the bag itself. ... Kenmore 35912 / 35913 Progressive Upright Vacuum
I have a Eureka 4800 series the Boss upright with a bag and Hepa filter. I love it! I was just vacuuming with the hose part and all was well and then suddenly the lower brush came on and a "burning" smell followed. Thought it was the belt so my husband was going to put on the new belt which I had on hand! When he turned it over, the "bar" that holds the belt looks as though it "shot through" the plastic side of the housing on the vacuum. There is melted plastic on the outside of the vacuum and o
I had the same problem. Take out the old belt if possible. Remove the 4 screws inside the filter and the 3 on the front of that housing. pull out the foam around the motor. carefully pull out the suction tube that is press fit against the motor. ... Eureka 4874 Bagged Upright Vacuum
My new Kenmoore Powermate 116 canister has poor suction. I have no pets and light dust. Its not picking up small particles on the wood floor with the floor attachment. When I put my hand to the suction it feels weak. Cleared hose and changed bag. Using again, same issues. This should not be happening with a new vacuum. Is it a bad design in the elbow joint of the hose? I want to return this!!!!
First of all disassemble the handle and hose as much as possible and examine the inside. Make sure there is not any significant debris lodged in the hose somewhere like a plastic bag or something.\015\012\015\012Also check at the top of t ... Kenmore 23912 Progressive PowerMate Bagged Canister Vacuum
I have a Flex hand held vacuum. It turns on, the motor works, air is blowing out of the side vent very forcefully, but it is not picking up anything with the hose - no suction at all. My hose does not seem to be clogged.
No the hose,, check the filter and compartment behind the filter.. Note if there is air passing through the filter,, or being sucked through it.. If not chances are the extractor fan inside the machine may have broken ou will need to open it up and r ... Black & Decker CHV9600 Handheld Vacuum
Poor suction I have a hoover hush s5627 vacuum purchased about 4 years ago from Costco. It's suction power isn't so good anymore. I've checked all the lines & hoses and they're clear and I've changed the bag. I even disconnected the pipe from the vacuum unit and held my hand over the intake. While the machine roars like a jet engine the suction power just ain't like it used to be. What could possibly be the problem?
This vaccuum has a Fan Blade inside connected to the motor that spins to create the suction you feel. After a few years of use (and misuse) the blades on this (plastic) fan will be broken off, thus damaging the unit. These Fans are replaceable if yo ... Vacuums
I have a dc18 vacuum and though you can feel the suction from the hose when you put your hand over it, it will not pick up anything from the floor at all. I have cleaned the hose, filter and the holes from inside the canister and still nothing. Help?
Here is a Link to one of my Tips that should solve the problem you are having:www.fixya.com/support/r6311178-vacuum_brush_bar_not_spinning ... Vacuums
My Kenmore canaster vacuum Mod# 116.25513506 runs continously when plugged in regardless of the on/off hand controlled switch.. Disconnecting the switch located on the hose assembly has no affect of the continous vacuum operation. What component in the electric motor circuit is at fault and what would be the cost of repair?
... Kenmore Vacuums
SHARK HAND VACUUM WITH MOTORIZ3ED BRUSH MODEL v15zoperating instruction to reinstall HEPA dust cup filter and reinstall sharkk V15z in the vacuum
Theon-off buttons no longer work properly. When vacuum is in upright position there is no ability to use the hand hose. The gray button for hard floors is not functioning correctly. This just happened after about 4 years.
... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum
The cleaning solution stopped coming out of the rotating brush but still comes out of the hand held vacuum hose.
If you can check where the vacuum hose where it is connected their might have dirt in the opening to the rotating brush,or it is glogged,clean with a wire and it will be ok ... Bissell SpotBot Robotic Wet/Dry Vacuum
I have a Kenmore vacuum which all of a sudden will not **** up anything, there is nothing in the hose and when you place your hand over the nozzel it doesn't have any sucking power.
Hi Barb. Sounds like you simply need a new power head belt. If the belt is not broken it could be stretched and need replacing. Check the belt by accessing it from the bottom of the nozzle. If not your belt check the hose for any plugging. If not, ch ... Kenmore Vacuums
Electrolux vacuum model #1205. worked great . then got a new hose and if you check the suction with your hand, great suction, but the check light turns on and the machine shuts off.
... Electrolux UltraLux 2000 Bagged Canister Vacuum
I have the same rproblem with my little Shark V15Z hand held vacuum. the belt broke,there's no instruction on how to replace (and apparenlty it was not designed to be replaced (at least with out a lot of research). I see BElectric describes how to find the hidden path, but now where can we buy the correct belts??
... Euro-Pro HEPA Shark EP035 Bagless Handheld Vacuum
Replacing drive belt on shark hand vac v15z - Euro-Pro Shark EP750 Bagless Handheld Vacuum
... Euro-Pro Shark EP750 Bagless Handheld Vacuum
Model C153C The vacuum cleaner starts but stops immediately. If I disconnect the hose it will run but if I partially put my hand over the suction it shuts off. Both filters have been changed.
Hi If the vacuum cleaner works but then shuts off unexpectedly, it may be because of restricted airflow which can cause the vacuum cleaner to overheat and shutdown. Check the vacuum cleaner for clogs and if the bag/tan ... Electrolux Vacuums
SHARK HAND VACUUM WITH MOTORIZED BRUSH V15Z
Vacuum shut off immediatly when suckchen is applied new bag hepa filter removed plus hose is removed when i put my hand over suckghen side it shuts down
Sounds like motor overheating due to fault within....Operates a thermal overload, This could also be faulty ... Electrolux EL7055A Bagless Canister Vacuum
How do I gain access to the motor of an Electrolux 2000 canister vacuum. The air intake on the motor must be partially blocked as there is a loss of suction and the motor makes that high pitched whine like it does when you cover the hose with your hand
Dismantling the vacuum probably won't help much, and reassembling can be a bear. \015\012To check the intake, remove bag and look into bottom of bag well. It there's a filter there, remove it and check intake at bottom of bag well. Clear if t ... Electrolux UltraLux 2000 Bagged Canister Vacuum
The hand held attachment no longer has suction. The hose collapses when I try to use it. Have cleaned the vacuum thoroughly and the filter. This still happens. Ive taken all the parts off and cleaned in there too. What else can i do?
Hi, please ensure that the hose is fitted correctly into the base of the Dyson. If this becomes loose or detached the machine will not **** whilst using the hose. Also check that the u bend is fitted correctly. Finally check that the vent on the left ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
I have a Dyson DC07 Yellow Vac, I use this vacuum professionally and clean it after every job so there is no issues with the filter which are replaced regularly. When you turn it on it makes a noise as if it were blocked....I have checked all pipes, hoses and now disassembled the machine to the point where the motor is out. I have found that a small rubber valve or bleed valve (Attached to the right hand detachable filter housing and activated via an internal spring) is popping when the vac
Hi, Where exactly is this spring? ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
Bissell 37604 Bagless Upright Vacuum. Hose keeps clogging every time I vacuum. Is there a way to prevent this? I am ready to buy a new vacuum, but it does do a great job picking up hair...until it clogs. It clogs at top of hose. Could the hose be kinked? It does not look like it.
That is a defect in the design of that style of vacuum. I went back to my old vac because I got so tired of having to unstop it. The sharp turns in the hose and the molded plastic causes it. Find one without the turns. ... Bissell 37604 Lift-Off Pet Bagless Upright / Canister Vacuum CleanerVacuum
Floor attachment does not suction, no clog in the hose, hand held works when dettached from floor attachment
Have you checked the floor head? Use a pipe cleaner or twisted metal to carefully and gently see what's in there. It sounds like dirt or something has definately sealed up the main suction channel. ... Vacuums